net: stmmac: sunxi platform extensions for GMAC in Allwinner A20 SoC's

The Allwinner A20 has an ethernet controller that seems to be
an early version of Synopsys DesignWare MAC 10/100/1000 Universal,
which is supported by the stmmac driver.

Allwinner's GMAC requires setting additional registers in the SoC's
clock control unit.

The exact version of the DWMAC IP that Allwinner uses is unknown,
thus the exact feature set is unknown.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

6 files changed, 185 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/net/allwinner,sun7i-a20-gmac.txt b/Documentation/devicetree/bindings/net/allwinner,sun7i-a20-gmac.txt
new file mode 100644
index 00000000000..ea4d752389a
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/allwinner,sun7i-a20-gmac.txt
@@ -0,0 +1,27 @@
+* Allwinner GMAC ethernet controller
+
+This device is a platform glue layer for stmmac.
+Please see stmmac.txt for the other unchanged properties.
+
+Required properties:
+ - compatible:  Should be "allwinner,sun7i-a20-gmac"
+ - clocks: Should contain the GMAC main clock, and tx clock
+   The tx clock type should be "allwinner,sun7i-a20-gmac-clk"
+ - clock-names: Should contain the clock names "stmmaceth",
+   and "allwinner_gmac_tx"
+
+Optional properties:
+- phy-supply: phandle to a regulator if the PHY needs one
+
+Examples:
+
+	gmac: ethernet@01c50000 {
+		compatible = "allwinner,sun7i-a20-gmac";
+		reg = <0x01c50000 0x10000>,
+		      <0x01c20164 0x4>;
+		interrupts = <0 85 1>;
+		interrupt-names = "macirq";
+		clocks = <&ahb_gates 49>, <&gmac_tx>;
+		clock-names = "stmmaceth", "allwinner_gmac_tx";
+		phy-mode = "mii";
+	};
diff --git a/drivers/net/ethernet/stmicro/stmmac/Kconfig b/drivers/net/ethernet/stmicro/stmmac/Kconfig
index b59d1ef5f6d..e2f202e3932 100644
--- a/drivers/net/ethernet/stmicro/stmmac/Kconfig
+++ b/drivers/net/ethernet/stmicro/stmmac/Kconfig
@@ -26,6 +26,17 @@ config STMMAC_PLATFORM
 
 	  If unsure, say N.
 
+config DWMAC_SUNXI
+	bool "Allwinner GMAC support"
+	depends on STMMAC_PLATFORM && ARCH_SUNXI
+	default y
+	---help---
+	  Support for Allwinner A20/A31 GMAC ethernet controllers.
+
+	  This selects Allwinner SoC glue layer support for the
+	  stmmac device driver. This driver is used for A20/A31
+	  GMAC 	  ethernet controller.
+
 config STMMAC_PCI
 	bool "STMMAC PCI bus support"
 	depends on STMMAC_ETH && PCI
diff --git a/drivers/net/ethernet/stmicro/stmmac/Makefile b/drivers/net/ethernet/stmicro/stmmac/Makefile
index 356a9dd32be..ecadecea79b 100644
--- a/drivers/net/ethernet/stmicro/stmmac/Makefile
+++ b/drivers/net/ethernet/stmicro/stmmac/Makefile
@@ -1,6 +1,7 @@
 obj-$(CONFIG_STMMAC_ETH) += stmmac.o
 stmmac-$(CONFIG_STMMAC_PLATFORM) += stmmac_platform.o
 stmmac-$(CONFIG_STMMAC_PCI) += stmmac_pci.o
+stmmac-$(CONFIG_DWMAC_SUNXI) += dwmac-sunxi.o
 stmmac-objs:= stmmac_main.o stmmac_ethtool.o stmmac_mdio.o ring_mode.o	\
 	      chain_mode.o dwmac_lib.o dwmac1000_core.o  dwmac1000_dma.o \
 	      dwmac100_core.o dwmac100_dma.o enh_desc.o  norm_desc.o \
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c
new file mode 100644
index 00000000000..771cd15fca1
--- /dev/null
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c
@@ -0,0 +1,140 @@
+/**
+ * dwmac-sunxi.c - Allwinner sunxi DWMAC specific glue layer
+ *
+ * Copyright (C) 2013 Chen-Yu Tsai
+ *
+ * Chen-Yu Tsai  <wens@csie.org>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ */
+
+#include <linux/stmmac.h>
+#include <linux/clk.h>
+#include <linux/phy.h>
+#include <linux/of_net.h>
+#include <linux/regulator/consumer.h>
+
+struct sunxi_priv_data {
+	int interface;
+	int clk_enabled;
+	struct clk *tx_clk;
+	struct regulator *regulator;
+};
+
+static void *sun7i_gmac_setup(struct platform_device *pdev)
+{
+	struct sunxi_priv_data *gmac;
+	struct device *dev = &pdev->dev;
+
+	gmac = devm_kzalloc(dev, sizeof(*gmac), GFP_KERNEL);
+	if (!gmac)
+		return ERR_PTR(-ENOMEM);
+
+	gmac->interface = of_get_phy_mode(dev->of_node);
+
+	gmac->tx_clk = devm_clk_get(dev, "allwinner_gmac_tx");
+	if (IS_ERR(gmac->tx_clk)) {
+		dev_err(dev, "could not get tx clock\n");
+		return gmac->tx_clk;
+	}
+
+	/* Optional regulator for PHY */
+	gmac->regulator = devm_regulator_get_optional(dev, "phy");
+	if (IS_ERR(gmac->regulator)) {
+		if (PTR_ERR(gmac->regulator) == -EPROBE_DEFER)
+			return ERR_PTR(-EPROBE_DEFER);
+		dev_info(dev, "no regulator found\n");
+		gmac->regulator = NULL;
+	}
+
+	return gmac;
+}
+
+#define SUN7I_GMAC_GMII_RGMII_RATE	125000000
+#define SUN7I_GMAC_MII_RATE		25000000
+
+static int sun7i_gmac_init(struct platform_device *pdev, void *priv)
+{
+	struct sunxi_priv_data *gmac = priv;
+	int ret;
+
+	if (gmac->regulator) {
+		ret = regulator_enable(gmac->regulator);
+		if (ret)
+			return ret;
+	}
+
+	/* Set GMAC interface port mode
+	 *
+	 * The GMAC TX clock lines are configured by setting the clock
+	 * rate, which then uses the auto-reparenting feature of the
+	 * clock driver, and enabling/disabling the clock.
+	 */
+	if (gmac->interface == PHY_INTERFACE_MODE_RGMII) {
+		clk_set_rate(gmac->tx_clk, SUN7I_GMAC_GMII_RGMII_RATE);
+		clk_prepare_enable(gmac->tx_clk);
+		gmac->clk_enabled = 1;
+	} else {
+		clk_set_rate(gmac->tx_clk, SUN7I_GMAC_MII_RATE);
+		clk_prepare(gmac->tx_clk);
+	}
+
+	return 0;
+}
+
+static void sun7i_gmac_exit(struct platform_device *pdev, void *priv)
+{
+	struct sunxi_priv_data *gmac = priv;
+
+	if (gmac->clk_enabled) {
+		clk_disable(gmac->tx_clk);
+		gmac->clk_enabled = 0;
+	}
+	clk_unprepare(gmac->tx_clk);
+
+	if (gmac->regulator)
+		regulator_disable(gmac->regulator);
+}
+
+static void sun7i_fix_speed(void *priv, unsigned int speed)
+{
+	struct sunxi_priv_data *gmac = priv;
+
+	/* only GMII mode requires us to reconfigure the clock lines */
+	if (gmac->interface != PHY_INTERFACE_MODE_GMII)
+		return;
+
+	if (gmac->clk_enabled) {
+		clk_disable(gmac->tx_clk);
+		gmac->clk_enabled = 0;
+	}
+	clk_unprepare(gmac->tx_clk);
+
+	if (speed == 1000) {
+		clk_set_rate(gmac->tx_clk, SUN7I_GMAC_GMII_RGMII_RATE);
+		clk_prepare_enable(gmac->tx_clk);
+		gmac->clk_enabled = 1;
+	} else {
+		clk_set_rate(gmac->tx_clk, SUN7I_GMAC_MII_RATE);
+		clk_prepare(gmac->tx_clk);
+	}
+}
+
+/* of_data specifying hardware features and callbacks.
+ * hardware features were copied from Allwinner drivers. */
+const struct stmmac_of_data sun7i_gmac_data = {
+	.has_gmac = 1,
+	.tx_coe = 1,
+	.fix_mac_speed = sun7i_fix_speed,
+	.setup = sun7i_gmac_setup,
+	.init = sun7i_gmac_init,
+	.exit = sun7i_gmac_exit,
+};
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac.h b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
index c1c141fe15e..d9af26ed58e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac.h
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
@@ -130,6 +130,9 @@ void stmmac_disable_eee_mode(struct stmmac_priv *priv);
 bool stmmac_eee_init(struct stmmac_priv *priv);
 
 #ifdef CONFIG_STMMAC_PLATFORM
+#ifdef CONFIG_DWMAC_SUNXI
+extern const struct stmmac_of_data sun7i_gmac_data;
+#endif
 extern struct platform_driver stmmac_pltfr_driver;
 static inline int stmmac_register_platform(void)
 {
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
index bf119db1521..9d4baa8b94a 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
@@ -30,6 +30,9 @@
 #include "stmmac.h"
 
 static const struct of_device_id stmmac_dt_ids[] = {
+#ifdef CONFIG_DWMAC_SUNXI
+	{ .compatible = "allwinner,sun7i-a20-gmac", .data = &sun7i_gmac_data},
+#endif
 	/* SoC specific glue layers should come before generic bindings */
 	{ .compatible = "st,spear600-gmac"},
 	{ .compatible = "snps,dwmac-3.610"},