tg3: Convert PHY_ADDR => TG3_PHY_MII_ADDR

This patch renames the PHY_ADDR preprocessor definition.  The following
patch will identify a new member on the MDIO bus, so we want this
preprocessor definition to be a little more descriptive.

Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

2 files changed, 30 insertions, 23 deletions

diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index b3c5d74022f..1c53250e400 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -937,7 +937,7 @@ static void tg3_mdio_config_5785(struct tg3 *tp)
 	u32 val;
 	struct phy_device *phydev;
 
-	phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+	phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 	switch (phydev->drv->phy_id & phydev->drv->phy_id_mask) {
 	case TG3_PHY_ID_BCM50610:
 		val = MAC_PHYCFG2_50610_LED_MODES;
@@ -1031,7 +1031,7 @@ static void tg3_mdio_start(struct tg3 *tp)
 		if (is_serdes)
 			tp->phy_addr += 7;
 	} else
-		tp->phy_addr = PHY_ADDR;
+		tp->phy_addr = TG3_PHY_MII_ADDR;
 
 	if ((tp->tg3_flags3 & TG3_FLG3_MDIOBUS_INITED) &&
 	    GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5785)
@@ -1062,7 +1062,7 @@ static int tg3_mdio_init(struct tg3 *tp)
 	tp->mdio_bus->read     = &tg3_mdio_read;
 	tp->mdio_bus->write    = &tg3_mdio_write;
 	tp->mdio_bus->reset    = &tg3_mdio_reset;
-	tp->mdio_bus->phy_mask = ~(1 << PHY_ADDR);
+	tp->mdio_bus->phy_mask = ~(1 << TG3_PHY_MII_ADDR);
 	tp->mdio_bus->irq      = &tp->mdio_irq[0];
 
 	for (i = 0; i < PHY_MAX_ADDR; i++)
@@ -1084,7 +1084,7 @@ static int tg3_mdio_init(struct tg3 *tp)
 		return i;
 	}
 
-	phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+	phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
 	if (!phydev || !phydev->drv) {
 		printk(KERN_WARNING "%s: No PHY devices\n", tp->dev->name);
@@ -1311,7 +1311,7 @@ static void tg3_setup_flow_control(struct tg3 *tp, u32 lcladv, u32 rmtadv)
 	u32 old_tx_mode = tp->tx_mode;
 
 	if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB)
-		autoneg = tp->mdio_bus->phy_map[PHY_ADDR]->autoneg;
+		autoneg = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]->autoneg;
 	else
 		autoneg = tp->link_config.autoneg;
 
@@ -1348,7 +1348,7 @@ static void tg3_adjust_link(struct net_device *dev)
 	u8 oldflowctrl, linkmesg = 0;
 	u32 mac_mode, lcl_adv, rmt_adv;
 	struct tg3 *tp = netdev_priv(dev);
-	struct phy_device *phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+	struct phy_device *phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
 	spin_lock_bh(&tp->lock);
 
@@ -1434,7 +1434,7 @@ static int tg3_phy_init(struct tg3 *tp)
 	/* Bring the PHY back to a known state. */
 	tg3_bmcr_reset(tp);
 
-	phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+	phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
 	/* Attach the MAC to the PHY. */
 	phydev = phy_connect(tp->dev, dev_name(&phydev->dev), tg3_adjust_link,
@@ -1461,7 +1461,7 @@ static int tg3_phy_init(struct tg3 *tp)
 				      SUPPORTED_Asym_Pause);
 		break;
 	default:
-		phy_disconnect(tp->mdio_bus->phy_map[PHY_ADDR]);
+		phy_disconnect(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
 		return -EINVAL;
 	}
 
@@ -1479,7 +1479,7 @@ static void tg3_phy_start(struct tg3 *tp)
 	if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
 		return;
 
-	phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+	phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
 	if (tp->link_config.phy_is_low_power) {
 		tp->link_config.phy_is_low_power = 0;
@@ -1499,13 +1499,13 @@ static void tg3_phy_stop(struct tg3 *tp)
 	if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
 		return;
 
-	phy_stop(tp->mdio_bus->phy_map[PHY_ADDR]);
+	phy_stop(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
 }
 
 static void tg3_phy_fini(struct tg3 *tp)
 {
 	if (tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED) {
-		phy_disconnect(tp->mdio_bus->phy_map[PHY_ADDR]);
+		phy_disconnect(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
 		tp->tg3_flags3 &= ~TG3_FLG3_PHY_CONNECTED;
 	}
 }
@@ -2474,7 +2474,7 @@ static int tg3_set_power_state(struct tg3 *tp, pci_power_t state)
 			struct phy_device *phydev;
 			u32 phyid, advertising;
 
-			phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+			phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
 			tp->link_config.phy_is_low_power = 1;
 
@@ -9243,9 +9243,11 @@ static int tg3_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 	struct tg3 *tp = netdev_priv(dev);
 
 	if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
+		struct phy_device *phydev;
 		if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
 			return -EAGAIN;
-		return phy_ethtool_gset(tp->mdio_bus->phy_map[PHY_ADDR], cmd);
+		phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
+		return phy_ethtool_gset(phydev, cmd);
 	}
 
 	cmd->supported = (SUPPORTED_Autoneg);
@@ -9284,9 +9286,11 @@ static int tg3_set_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 	struct tg3 *tp = netdev_priv(dev);
 
 	if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
+		struct phy_device *phydev;
 		if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
 			return -EAGAIN;
-		return phy_ethtool_sset(tp->mdio_bus->phy_map[PHY_ADDR], cmd);
+		phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
+		return phy_ethtool_sset(phydev, cmd);
 	}
 
 	if (cmd->autoneg != AUTONEG_ENABLE &&
@@ -9469,7 +9473,7 @@ static int tg3_nway_reset(struct net_device *dev)
 	if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
 		if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
 			return -EAGAIN;
-		r = phy_start_aneg(tp->mdio_bus->phy_map[PHY_ADDR]);
+		r = phy_start_aneg(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
 	} else {
 		u32 bmcr;
 
@@ -9588,7 +9592,7 @@ static int tg3_set_pauseparam(struct net_device *dev, struct ethtool_pauseparam
 			u32 newadv;
 			struct phy_device *phydev;
 
-			phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+			phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
 			if (epause->rx_pause) {
 				if (epause->tx_pause)
@@ -10568,9 +10572,11 @@ static int tg3_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd)
 	int err;
 
 	if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
+		struct phy_device *phydev;
 		if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
 			return -EAGAIN;
-		return phy_mii_ioctl(tp->mdio_bus->phy_map[PHY_ADDR], data, cmd);
+		phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
+		return phy_mii_ioctl(phydev, data, cmd);
 	}
 
 	switch(cmd) {
@@ -14135,13 +14141,14 @@ static int __devinit tg3_init_one(struct pci_dev *pdev,
 	       tg3_bus_string(tp, str),
 	       dev->dev_addr);
 
-	if (tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED)
+	if (tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED) {
+		struct phy_device *phydev;
+		phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 		printk(KERN_INFO
 		       "%s: attached PHY driver [%s] (mii_bus:phy_addr=%s)\n",
-		       tp->dev->name,
-		       tp->mdio_bus->phy_map[PHY_ADDR]->drv->name,
-		       dev_name(&tp->mdio_bus->phy_map[PHY_ADDR]->dev));
-	else
+		       tp->dev->name, phydev->drv->name,
+		       dev_name(&phydev->dev));
+	} else
 		printk(KERN_INFO
 		       "%s: attached PHY is %s (%s Ethernet) (WireSpeed[%d])\n",
 		       tp->dev->name, tg3_phy_string(tp),
diff --git a/drivers/net/tg3.h b/drivers/net/tg3.h
index eb4ed82d71e..40501cb3b35 100644
--- a/drivers/net/tg3.h
+++ b/drivers/net/tg3.h
@@ -1954,7 +1954,7 @@
 #define  NIC_SRAM_MBUF_POOL_SIZE5705	0x0000e000
 
 /* Currently this is fixed. */
-#define PHY_ADDR		0x01
+#define TG3_PHY_MII_ADDR		0x01
 
 /* Tigon3 specific PHY MII registers. */
 #define  TG3_BMCR_SPEED1000		0x0040