Merge branch 'remove' of master.kernel.org:/home/rmk/linux-2.6-arm

* 'remove' of master.kernel.org:/home/rmk/linux-2.6-arm:
  ARM: 6629/2: aaec2000: remove support for mach-aaec2000
  ARM: lh7a40x: remove unmaintained platform support

Fix up trivial conflicts in
 - arch/arm/mach-{aaec2000,lh7a40x}/include/mach/memory.h (removed)
 - drivers/usb/gadget/Kconfig (USB_[GADGET_]LH7A40X removed, others added)

1 files changed, 0 insertions, 59 deletions

diff --git a/Documentation/arm/Sharp-LH/LCDPanels b/Documentation/arm/Sharp-LH/LCDPanels
deleted file mode 100644
index fb1b21c2f2f..00000000000
--- a/Documentation/arm/Sharp-LH/LCDPanels
+++ /dev/null
@@ -1,59 +0,0 @@
-README on the LCD Panels
-========================
-
-Configuration options for several LCD panels, available from Logic PD,
-are included in the kernel source.  This README will help you
-understand the configuration data and give you some guidance for
-adding support for other panels if you wish.
-
-
-lcd-panels.h
-------------
-
-There is no way, at present, to detect which panel is attached to the
-system at runtime.  Thus the kernel configuration is static.  The file
-arch/arm/mach-ld7a40x/lcd-panels.h (or similar) defines all of the
-panel specific parameters.
-
-It should be possible for this data to be shared among several device
-families.  The current layout may be insufficiently general, but it is
-amenable to improvement.
-
-
-PIXEL_CLOCK
------------
-
-The panel data sheets will give a range of acceptable pixel clocks.
-The fundamental LCDCLK input frequency is divided down by a PCD
-constant in field '.tim2'.  It may happen that it is impossible to set
-the pixel clock within this range.  A clock which is too slow will
-tend to flicker.  For the highest quality image, set the clock as high
-as possible.
-
-
-MARGINS
--------
-
-These values may be difficult to glean from the panel data sheet.  In
-the case of the Sharp panels, the upper margin is explicitly called
-out as a specific number of lines from the top of the frame.  The
-other values may not matter as much as the panels tend to
-automatically center the image.
-
-
-Sync Sense
-----------
-
-The sense of the hsync and vsync pulses may be called out in the data
-sheet.  On one panel, the sense of these pulses determine the height
-of the visible region on the panel.  Most of the Sharp panels use
-negative sense sync pulses set by the TIM2_IHS and TIM2_IVS bits in
-'.tim2'.
-
-
-Pel Layout
-----------
-
-The Sharp color TFT panels are all configured for 16 bit direct color
-modes.  The amba-lcd driver sets the pel mode to 565 for 5 bits of
-each red and blue and 6 bits of green.