ARM: Orion: DT support for IRQ and GPIO Controllers

Both IRQ and GPIO controllers can now be represented in DT.  The IRQ
controllers are setup first, and then the GPIO controllers. Interrupts
for GPIO lines are placed directly after the main interrupts in the
interrupt space.

Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Acked-by: Sebastian Hesselbarth <sebastian.hesselbarth@googlemail.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Tested-by: Josh Coombs <josh.coombs@gmail.com>
Tested-by: Simon Baatz <gmbnomis@gmail.com>

1 files changed, 20 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/arm/mrvl/intc.txt b/Documentation/devicetree/bindings/arm/mrvl/intc.txt
index 80b9a94d9a2..8b53273cb22 100644
--- a/Documentation/devicetree/bindings/arm/mrvl/intc.txt
+++ b/Documentation/devicetree/bindings/arm/mrvl/intc.txt
@@ -38,3 +38,23 @@ Example:
 		reg-names = "mux status", "mux mask";
 		mrvl,intc-nr-irqs = <2>;
 	};
+
+* Marvell Orion Interrupt controller
+
+Required properties
+- compatible :  Should be "marvell,orion-intc".
+- #interrupt-cells: Specifies the number of cells needed to encode an
+  interrupt source. Supported value is <1>.
+- interrupt-controller : Declare this node to be an interrupt controller.
+- reg : Interrupt mask address. A list of 4 byte ranges, one per controller.
+        One entry in the list represents 32 interrupts.
+
+Example:
+
+	intc: interrupt-controller {
+        	compatible = "marvell,orion-intc", "marvell,intc";
+		interrupt-controller;
+		#interrupt-cells = <1>;
+                reg = <0xfed20204 0x04>,
+		      <0xfed20214 0x04>;
+        };