thermal: add imx thermal driver support

This is based on the initial imx thermal work done by
Rob Lee <rob.lee@linaro.org> (Not sure if the email address is still
valid).  Since he is no longer interested in the work and I have
rewritten a significant amount of the code, I just took the authorship
over from him.

It adds the imx thermal support using Temperature Monitor (TEMPMON)
block found on some Freescale i.MX SoCs.  The driver uses syscon regmap
interface to access TEMPMON control registers and calibration data, and
supports cpufreq as the cooling device.

Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Signed-off-by: Eduardo Valentin <eduardo.valentin@ti.com>

1 files changed, 17 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/thermal/imx-thermal.txt b/Documentation/devicetree/bindings/thermal/imx-thermal.txt
new file mode 100644
index 00000000000..541c25e49ab
--- /dev/null
+++ b/Documentation/devicetree/bindings/thermal/imx-thermal.txt
@@ -0,0 +1,17 @@
+* Temperature Monitor (TEMPMON) on Freescale i.MX SoCs
+
+Required properties:
+- compatible : "fsl,imx6q-thermal"
+- fsl,tempmon : phandle pointer to system controller that contains TEMPMON
+  control registers, e.g. ANATOP on imx6q.
+- fsl,tempmon-data : phandle pointer to fuse controller that contains TEMPMON
+  calibration data, e.g. OCOTP on imx6q.  The details about calibration data
+  can be found in SoC Reference Manual.
+
+Example:
+
+tempmon {
+	compatible = "fsl,imx6q-tempmon";
+	fsl,tempmon = <&anatop>;
+	fsl,tempmon-data = <&ocotp>;
+};