Merge remote-tracking branch 'asoc/topic/samsung' into asoc-next

2 files changed, 77 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/sound/samsung,smdk-wm8994.txt b/Documentation/devicetree/bindings/sound/samsung,smdk-wm8994.txt
new file mode 100644
index 00000000000..4686646fb12
--- /dev/null
+++ b/Documentation/devicetree/bindings/sound/samsung,smdk-wm8994.txt
@@ -0,0 +1,14 @@
+Samsung SMDK audio complex
+
+Required properties:
+- compatible : "samsung,smdk-wm8994"
+- samsung,i2s-controller: The phandle of the Samsung I2S0 controller
+- samsung,audio-codec: The phandle of the WM8994 audio codec
+Example:
+
+sound {
+		compatible = "samsung,smdk-wm8994";
+
+		samsung,i2s-controller = <&i2s0>;
+		samsung,audio-codec = <&wm8994>;
+};
diff --git a/Documentation/devicetree/bindings/sound/samsung-i2s.txt b/Documentation/devicetree/bindings/sound/samsung-i2s.txt
new file mode 100644
index 00000000000..3070046da2e
--- /dev/null
+++ b/Documentation/devicetree/bindings/sound/samsung-i2s.txt
@@ -0,0 +1,63 @@
+* Samsung I2S controller
+
+Required SoC Specific Properties:
+
+- compatible : "samsung,i2s-v5"
+- reg: physical base address of the controller and length of memory mapped
+  region.
+- dmas: list of DMA controller phandle and DMA request line ordered pairs.
+- dma-names: identifier string for each DMA request line in the dmas property.
+  These strings correspond 1:1 with the ordered pairs in dmas.
+
+Optional SoC Specific Properties:
+
+- samsung,supports-6ch: If the I2S Primary sound source has 5.1 Channel
+  support, this flag is enabled.
+- samsung,supports-rstclr: This flag should be set if I2S software reset bit
+  control is required. When this flag is set I2S software reset bit will be
+  enabled or disabled based on need.
+- samsung,supports-secdai:If I2S block has a secondary FIFO and internal DMA,
+  then this flag is enabled.
+- samsung,idma-addr: Internal DMA register base address of the audio
+  sub system(used in secondary sound source).
+
+Required Board Specific Properties:
+
+- gpios: The gpio specifier for data out,data in, LRCLK, CDCLK and SCLK
+  interface lines. The format of the gpio specifier depends on the gpio
+  controller.
+  The syntax of samsung gpio specifier is
+	<[phandle of the gpio controller node]
+	 [pin number within the gpio controller]
+	 [mux function]
+	 [flags and pull up/down]
+	 [drive strength]>
+
+Example:
+
+- SoC Specific Portion:
+
+i2s@03830000 {
+	compatible = "samsung,i2s-v5";
+	reg = <0x03830000 0x100>;
+	dmas = <&pdma0 10
+		&pdma0 9
+		&pdma0 8>;
+	dma-names = "tx", "rx", "tx-sec";
+	samsung,supports-6ch;
+	samsung,supports-rstclr;
+	samsung,supports-secdai;
+	samsung,idma-addr = <0x03000000>;
+};
+
+- Board Specific Portion:
+
+i2s@03830000 {
+	gpios = <&gpz 0 2 0 0>, /* I2S_0_SCLK */
+		<&gpz 1 2 0 0>, /* I2S_0_CDCLK */
+		<&gpz 2 2 0 0>, /* I2S_0_LRCK */
+		<&gpz 3 2 0 0>, /* I2S_0_SDI */
+		<&gpz 4 2 0 0>, /* I2S_0_SDO[1] */
+		<&gpz 5 2 0 0>, /* I2S_0_SDO[2] */
+		<&gpz 6 2 0 0>; /* I2S_0_SDO[3] */
+};