Merge tag 'mmc-updates-for-3.10-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc

Pull MMC update from Chris Ball:
 "MMC highlights for 3.10:

  Core:
   - Introduce MMC_CAP2_NO_PRESCAN_POWERUP to allow skipping
     mmc_power_up() at boot/initialization time if it's already
     happened, for performance (faster boot time) reasons.
   - Fix a bit width test failure that resulted in old eMMC cards being
     put into 1-bit mode when 4-bit mode was available.
   - Expose fwrev/hwrev for MMCv4 parts.
   - Improve card removal logic in the case where the card's removed
     slowly; we were missing card removal events if the card retained
     contact with the slot pads for long enough to reply to a CMD13
     while being removed.

  Drivers:
   - davinci_mmc: Support using PIO instead of DMA.
   - dw_mmc: Add support for Exynos4412.
   - mxcmmc: DT support, use slot-gpio API.
   - mxs-mmc: Add broken-cd/cd-inverted/non-removable DT property
     support.
   - sdhci-sirf: New sdhci-pltfm driver for CSR SiRF SoCs:
       SiRFprimaII: unicore ARM Cortex-A9
       SiRFatlas6: unicore ARM Cortex-A9
       SiRFmarco: dual core ARM Cortex-A9 SMP
   - sdhci-tegra: Add support for Tegra114 platforms, use
     mmc_of_parse()"

* tag 'mmc-updates-for-3.10-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/cjb/mmc: (66 commits)
  mmc: sdhci-tegra: fix MODULE_DEVICE_TABLE
  mmc: core: fix init controller performance regression, updated patch
  mmc: mxcmmc: enable DMA support on mpc512x
  mmc: mxcmmc: constify mxcmci_devtype
  mmc: mxcmmc: use slot-gpio API for write-protect detection
  mmc: mxcmmc: add mpc512x SDHC support
  mmc: mxcmmc: fix race conditions for host->req and host->data access
  mmc: mxcmmc: DT support
  mmc: dw_mmc: let device core setup the default pin configuration
  mmc: mxs-mmc: add broken-cd property
  mmc: mxs-mmc: add non-removable property
  mmc: mxs-mmc: add cd-inverted property
  mmc: core: call pm_runtime_put_noidle in pm_runtime_get_sync failed case
  mmc: mxcmmc: Fix bug when card is present during boot
  mmc: core: fix performance regression initializing MMC host controllers
  Revert "mmc: core: wait while adding MMC host to ensure root mounts successfully"
  mmc: atmel-mci: pio hang on block errors
  mmc: core: Fix bit width test failing on old eMMC cards
  mmc: dw_mmc: Use pr_info instead of printk
  mmc: dw_mmc: Check return value of regulator_enable
  ...

3 files changed, 46 insertions, 31 deletions

diff --git a/Documentation/devicetree/bindings/mmc/fsl-imx-mmc.txt b/Documentation/devicetree/bindings/mmc/fsl-imx-mmc.txt
new file mode 100644
index 00000000000..db442355cd2
--- /dev/null
+++ b/Documentation/devicetree/bindings/mmc/fsl-imx-mmc.txt
@@ -0,0 +1,24 @@
+* Freescale Secure Digital Host Controller for i.MX2/3 series
+
+This file documents differences to the properties defined in mmc.txt.
+
+Required properties:
+- compatible : Should be "fsl,<chip>-mmc", chip can be imx21 or imx31
+
+Optional properties:
+- dmas: One DMA phandle with arguments as defined by the devicetree bindings
+	of the used DMA controller.
+- dma-names: Has to be "rx-tx".
+
+Example:
+
+sdhci1: sdhci@10014000 {
+	compatible = "fsl,imx27-mmc", "fsl,imx21-mmc";
+	reg = <0x10014000 0x1000>;
+	interrupts = <11>;
+	dmas = <&dma 7>;
+	dma-names = "rx-tx";
+	bus-width = <4>;
+	cd-gpios = <&gpio3 29>;
+	status = "okay";
+};
diff --git a/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt b/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt
index 3b3a1ee055f..328e990d254 100644
--- a/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt
+++ b/Documentation/devicetree/bindings/mmc/samsung-sdhci.txt
@@ -5,13 +5,6 @@ MMC, SD and eMMC storage mediums. This file documents differences between the
 core mmc properties described by mmc.txt and the properties used by the
 Samsung implmentation of the SDHCI controller.
 
-Note: The mmc core bindings documentation states that if none of the core
-card-detect bindings are used, then the standard sdhci card detect mechanism
-is used. The Samsung's SDHCI controller bindings extends this as listed below.
-
-[A] The property "samsung,cd-pinmux-gpio" can be used as stated in the
-    "Optional Board Specific Properties" section below.
-
 Required SoC Specific Properties:
 - compatible: should be one of the following
   - "samsung,s3c6410-sdhci": For controllers compatible with s3c6410 sdhci
@@ -20,18 +13,8 @@ Required SoC Specific Properties:
     controller.
 
 Required Board Specific Properties:
-- Samsung GPIO variant (will be completely replaced by pinctrl):
-  - gpios: Should specify the gpios used for clock, command and data lines. The
-    gpio specifier format depends on the gpio controller.
-- Pinctrl variant (preferred if available):
-  - pinctrl-0: Should specify pin control groups used for this controller.
-  - pinctrl-names: Should contain only one value - "default".
-
-Optional Board Specific Properties:
-- samsung,cd-pinmux-gpio: Specifies the card detect line that is routed
-  through a pinmux to the card-detect pin of the card slot. This property
-  should be used only if none of the mmc core card-detect properties are
-  used. Only for Samsung GPIO variant.
+- pinctrl-0: Should specify pin control groups used for this controller.
+- pinctrl-names: Should contain only one value - "default".
 
 Example:
 	sdhci@12530000 {
@@ -39,19 +22,9 @@ Example:
 		reg = <0x12530000 0x100>;
 		interrupts = <0 75 0>;
 		bus-width = <4>;
-		cd-gpios = <&gpk2 2 2 3 3>;
-
-		/* Samsung GPIO variant */
-		gpios = <&gpk2 0 2 0 3>,  /* clock line */
-			<&gpk2 1 2 0 3>,  /* command line */
-			<&gpk2 3 2 3 3>,  /* data line 0 */
-			<&gpk2 4 2 3 3>,  /* data line 1 */
-			<&gpk2 5 2 3 3>,  /* data line 2 */
-			<&gpk2 6 2 3 3>;  /* data line 3 */
-
-		/* Pinctrl variant */
-		pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4>;
+		cd-gpios = <&gpk2 2 0>;
 		pinctrl-names = "default";
+		pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus4>;
 	};
 
 	Note: This example shows both SoC specific and board specific properties
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-sirf.txt b/Documentation/devicetree/bindings/mmc/sdhci-sirf.txt
new file mode 100644
index 00000000000..dd6ed464bcb
--- /dev/null
+++ b/Documentation/devicetree/bindings/mmc/sdhci-sirf.txt
@@ -0,0 +1,18 @@
+* SiRFprimII/marco/atlas6 SDHCI Controller
+
+This file documents differences between the core properties in mmc.txt
+and the properties used by the sdhci-sirf driver.
+
+Required properties:
+- compatible: sirf,prima2-sdhc
+
+Optional properties:
+- cd-gpios: card detect gpio, with zero flags.
+
+Example:
+
+	sd0: sdhci@56000000 {
+		compatible = "sirf,prima2-sdhc";
+		reg = <0xcd000000 0x100000>;
+		cd-gpios = <&gpio 6 0>;
+	};