Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next

Pull networking changes from David S Miller:

 1) Remove the ipv4 routing cache.  Now lookups go directly into the FIB
    trie and use prebuilt routes cached there.

    No more garbage collection, no more rDOS attacks on the routing
    cache.  Instead we now get predictable and consistent performance,
    no matter what the pattern of traffic we service.

    This has been almost 2 years in the making.  Special thanks to
    Julian Anastasov, Eric Dumazet, Steffen Klassert, and others who
    have helped along the way.

    I'm sure that with a change of this magnitude there will be some
    kind of fallout, but such things ought the be simple to fix at this
    point.  Luckily I'm not European so I'll be around all of August to
    fix things :-)

    The major stages of this work here are each fronted by a forced
    merge commit whose commit message contains a top-level description
    of the motivations and implementation issues.

 2) Pre-demux of established ipv4 TCP sockets, saves a route demux on
    input.

 3) TCP SYN/ACK performance tweaks from Eric Dumazet.

 4) Add namespace support for netfilter L4 conntrack helpers, from Gao
    Feng.

 5) Add config mechanism for Energy Efficient Ethernet to ethtool, from
    Yuval Mintz.

 6) Remove quadratic behavior from /proc/net/unix, from Eric Dumazet.

 7) Support for connection tracker helpers in userspace, from Pablo
    Neira Ayuso.

 8) Allow userspace driven TX load balancing functions in TEAM driver,
    from Jiri Pirko.

 9) Kill off NLMSG_PUT and RTA_PUT macros, more gross stuff with
    embedded gotos.

10) TCP Small Queues, essentially minimize the amount of TCP data queued
    up in the packet scheduler layer.  Whereas the existing BQL (Byte
    Queue Limits) limits the pkt_sched --> netdevice queuing levels,
    this controls the TCP --> pkt_sched queueing levels.

    From Eric Dumazet.

11) Reduce the number of get_page/put_page ops done on SKB fragments,
    from Alexander Duyck.

12) Implement protection against blind resets in TCP (RFC 5961), from
    Eric Dumazet.

13) Support the client side of TCP Fast Open, basically the ability to
    send data in the SYN exchange, from Yuchung Cheng.

    Basically, the sender queues up data with a sendmsg() call using
    MSG_FASTOPEN, then they do the connect() which emits the queued up
    fastopen data.

14) Avoid all the problems we get into in TCP when timers or PMTU events
    hit a locked socket.  The TCP Small Queues changes added a
    tcp_release_cb() that allows us to queue work up to the
    release_sock() caller, and that's what we use here too.  From Eric
    Dumazet.

15) Zero copy on TX support for TUN driver, from Michael S. Tsirkin.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (1870 commits)
  genetlink: define lockdep_genl_is_held() when CONFIG_LOCKDEP
  r8169: revert "add byte queue limit support".
  ipv4: Change rt->rt_iif encoding.
  net: Make skb->skb_iif always track skb->dev
  ipv4: Prepare for change of rt->rt_iif encoding.
  ipv4: Remove all RTCF_DIRECTSRC handliing.
  ipv4: Really ignore ICMP address requests/replies.
  decnet: Don't set RTCF_DIRECTSRC.
  net/ipv4/ip_vti.c: Fix __rcu warnings detected by sparse.
  ipv4: Remove redundant assignment
  rds: set correct msg_namelen
  openvswitch: potential NULL deref in sample()
  tcp: dont drop MTU reduction indications
  bnx2x: Add new 57840 device IDs
  tcp: avoid oops in tcp_metrics and reset tcpm_stamp
  niu: Change niu_rbr_fill() to use unlikely() to check niu_rbr_add_page() return value
  niu: Fix to check for dma mapping errors.
  net: Fix references to out-of-scope variables in put_cmsg_compat()
  net: ethernet: davinci_emac: add pm_runtime support
  net: ethernet: davinci_emac: Remove unnecessary #include
  ...

6 files changed, 91 insertions, 3 deletions

diff --git a/Documentation/devicetree/bindings/net/broadcom-bcm87xx.txt b/Documentation/devicetree/bindings/net/broadcom-bcm87xx.txt
new file mode 100644
index 00000000000..7c86d5e28a0
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/broadcom-bcm87xx.txt
@@ -0,0 +1,29 @@
+The Broadcom BCM87XX devices are a family of 10G Ethernet PHYs.  They
+have these bindings in addition to the standard PHY bindings.
+
+Compatible: Should contain "broadcom,bcm8706" or "broadcom,bcm8727" and
+            "ethernet-phy-ieee802.3-c45"
+
+Optional Properties:
+
+- broadcom,c45-reg-init : one of more sets of 4 cells.  The first cell
+  is the MDIO Manageable Device (MMD) address, the second a register
+  address within the MMD, the third cell contains a mask to be ANDed
+  with the existing register value, and the fourth cell is ORed with
+  he result to yield the new register value.  If the third cell has a
+  value of zero, no read of the existing value is performed.
+
+Example:
+
+	ethernet-phy@5 {
+		reg = <5>;
+		compatible = "broadcom,bcm8706", "ethernet-phy-ieee802.3-c45";
+		interrupt-parent = <&gpio>;
+		interrupts = <12 8>; /* Pin 12, active low */
+		/*
+		 * Set PMD Digital Control Register for
+		 * GPIO[1] Tx/Rx
+		 * GPIO[0] R64 Sync Acquired
+		 */
+		broadcom,c45-reg-init = <1 0xc808 0xff8f 0x70>;
+	};
diff --git a/Documentation/devicetree/bindings/net/can/fsl-flexcan.txt b/Documentation/devicetree/bindings/net/can/fsl-flexcan.txt
index f31b686d455..8ff324eaa88 100644
--- a/Documentation/devicetree/bindings/net/can/fsl-flexcan.txt
+++ b/Documentation/devicetree/bindings/net/can/fsl-flexcan.txt
@@ -11,6 +11,9 @@ Required properties:
 
 - reg : Offset and length of the register set for this device
 - interrupts : Interrupt tuple for this device
+
+Optional properties:
+
 - clock-frequency : The oscillator frequency driving the flexcan device
 
 Example:
diff --git a/Documentation/devicetree/bindings/net/davinci_emac.txt b/Documentation/devicetree/bindings/net/davinci_emac.txt
new file mode 100644
index 00000000000..48b259e29e8
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/davinci_emac.txt
@@ -0,0 +1,41 @@
+* Texas Instruments Davinci EMAC
+
+This file provides information, what the device node
+for the davinci_emac interface contains.
+
+Required properties:
+- compatible: "ti,davinci-dm6467-emac";
+- reg: Offset and length of the register set for the device
+- ti,davinci-ctrl-reg-offset: offset to control register
+- ti,davinci-ctrl-mod-reg-offset: offset to control module register
+- ti,davinci-ctrl-ram-offset: offset to control module ram
+- ti,davinci-ctrl-ram-size: size of control module ram
+- ti,davinci-rmii-en: use RMII
+- ti,davinci-no-bd-ram: has the emac controller BD RAM
+- phy-handle: Contains a phandle to an Ethernet PHY.
+              if not, davinci_emac driver defaults to 100/FULL
+- interrupts: interrupt mapping for the davinci emac interrupts sources:
+              4 sources: <Receive Threshold Interrupt
+			  Receive Interrupt
+			  Transmit Interrupt
+			  Miscellaneous Interrupt>
+
+Optional properties:
+- local-mac-address : 6 bytes, mac address
+
+Example (enbw_cmc board):
+	eth0: emac@1e20000 {
+		compatible = "ti,davinci-dm6467-emac";
+		reg = <0x220000 0x4000>;
+		ti,davinci-ctrl-reg-offset = <0x3000>;
+		ti,davinci-ctrl-mod-reg-offset = <0x2000>;
+		ti,davinci-ctrl-ram-offset = <0>;
+		ti,davinci-ctrl-ram-size = <0x2000>;
+		local-mac-address = [ 00 00 00 00 00 00 ];
+		interrupts = <33
+				34
+				35
+				36
+				>;
+		interrupt-parent = <&intc>;
+	};
diff --git a/Documentation/devicetree/bindings/net/fsl-fec.txt b/Documentation/devicetree/bindings/net/fsl-fec.txt
index 4616fc28ee8..d5363922140 100644
--- a/Documentation/devicetree/bindings/net/fsl-fec.txt
+++ b/Documentation/devicetree/bindings/net/fsl-fec.txt
@@ -7,10 +7,14 @@ Required properties:
 - phy-mode : String, operation mode of the PHY interface.
   Supported values are: "mii", "gmii", "sgmii", "tbi", "rmii",
   "rgmii", "rgmii-id", "rgmii-rxid", "rgmii-txid", "rtbi", "smii".
-- phy-reset-gpios : Should specify the gpio for phy reset
 
 Optional properties:
 - local-mac-address : 6 bytes, mac address
+- phy-reset-gpios : Should specify the gpio for phy reset
+- phy-reset-duration : Reset duration in milliseconds.  Should present
+  only if property "phy-reset-gpios" is available.  Missing the property
+  will have the duration be 1 millisecond.  Numbers greater than 1000 are
+  invalid and 1 millisecond will be used instead.
 
 Example:
 
diff --git a/Documentation/devicetree/bindings/net/phy.txt b/Documentation/devicetree/bindings/net/phy.txt
index bb8c742eb8c..7cd18fbfcf7 100644
--- a/Documentation/devicetree/bindings/net/phy.txt
+++ b/Documentation/devicetree/bindings/net/phy.txt
@@ -14,10 +14,20 @@ Required properties:
  - linux,phandle :  phandle for this node; likely referenced by an
    ethernet controller node.
 
+Optional Properties:
+
+- compatible: Compatible list, may contain
+  "ethernet-phy-ieee802.3-c22" or "ethernet-phy-ieee802.3-c45" for
+  PHYs that implement IEEE802.3 clause 22 or IEEE802.3 clause 45
+  specifications. If neither of these are specified, the default is to
+  assume clause 22. The compatible list may also contain other
+  elements.
+
 Example:
 
 ethernet-phy@0 {
-	linux,phandle = <2452000>
+	compatible = "ethernet-phy-ieee802.3-c22";
+	linux,phandle = <2452000>;
 	interrupt-parent = <40000>;
 	interrupts = <35 1>;
 	reg = <0>;
diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
index 1f62623f8c3..060bbf098ef 100644
--- a/Documentation/devicetree/bindings/net/stmmac.txt
+++ b/Documentation/devicetree/bindings/net/stmmac.txt
@@ -1,7 +1,8 @@
 * STMicroelectronics 10/100/1000 Ethernet driver (GMAC)
 
 Required properties:
-- compatible: Should be "st,spear600-gmac"
+- compatible: Should be "snps,dwmac-<ip_version>" "snps,dwmac"
+	For backwards compatibility: "st,spear600-gmac" is also supported.
 - reg: Address and length of the register set for the device
 - interrupt-parent: Should be the phandle for the interrupt controller
   that services interrupts for this device