Linux-2.6.12-rc2v2.6.12-rc2

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!

1 files changed, 57 insertions, 0 deletions

diff --git a/Documentation/filesystems/bfs.txt b/Documentation/filesystems/bfs.txt
new file mode 100644
index 00000000000..d2841e0bcf0
--- /dev/null
+++ b/Documentation/filesystems/bfs.txt
@@ -0,0 +1,57 @@
+BFS FILESYSTEM FOR LINUX
+========================
+
+The BFS filesystem is used by SCO UnixWare OS for the /stand slice, which
+usually contains the kernel image and a few other files required for the
+boot process.
+
+In order to access /stand partition under Linux you obviously need to
+know the partition number and the kernel must support UnixWare disk slices
+(CONFIG_UNIXWARE_DISKLABEL config option). However BFS support does not
+depend on having UnixWare disklabel support because one can also mount
+BFS filesystem via loopback:
+
+# losetup /dev/loop0 stand.img
+# mount -t bfs /dev/loop0 /mnt/stand
+
+where stand.img is a file containing the image of BFS filesystem. 
+When you have finished using it and umounted you need to also deallocate
+/dev/loop0 device by:
+
+# losetup -d /dev/loop0
+
+You can simplify mounting by just typing:
+
+# mount -t bfs -o loop stand.img /mnt/stand
+
+this will allocate the first available loopback device (and load loop.o 
+kernel module if necessary) automatically. If the loopback driver is not
+loaded automatically, make sure that your kernel is compiled with kmod 
+support (CONFIG_KMOD) enabled. Beware that umount will not
+deallocate /dev/loopN device if /etc/mtab file on your system is a
+symbolic link to /proc/mounts. You will need to do it manually using
+"-d" switch of losetup(8). Read losetup(8) manpage for more info.
+
+To create the BFS image under UnixWare you need to find out first which
+slice contains it. The command prtvtoc(1M) is your friend:
+
+# prtvtoc /dev/rdsk/c0b0t0d0s0
+
+(assuming your root disk is on target=0, lun=0, bus=0, controller=0). Then you
+look for the slice with tag "STAND", which is usually slice 10. With this
+information you can use dd(1) to create the BFS image:
+
+# umount /stand
+# dd if=/dev/rdsk/c0b0t0d0sa of=stand.img bs=512
+
+Just in case, you can verify that you have done the right thing by checking
+the magic number:
+
+# od -Ad -tx4 stand.img | more
+
+The first 4 bytes should be 0x1badface.
+
+If you have any patches, questions or suggestions regarding this BFS
+implementation please contact the author:
+
+Tigran A. Aivazian <tigran@veritas.com>