Manual merge with Linus.

Conflicts:
	arch/powerpc/kernel/setup-common.c
	drivers/input/keyboard/hil_kbd.c
	drivers/input/mouse/hil_ptr.c

1 files changed, 23 insertions, 5 deletions

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index fc99075e0af..f8cb55c30b0 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -49,6 +49,7 @@ restrictions referred to are that the relevant option is valid if:
 	MCA	MCA bus support is enabled.
 	MDA	MDA console support is enabled.
 	MOUSE	Appropriate mouse support is enabled.
+	MSI	Message Signaled Interrupts (PCI).
 	MTD	MTD support is enabled.
 	NET	Appropriate network support is enabled.
 	NUMA	NUMA support is enabled.
@@ -366,12 +367,17 @@ running once the system is up.
 		tty<n>	Use the virtual console device <n>.
 
 		ttyS<n>[,options]
+		ttyUSB0[,options]
 			Use the specified serial port.  The options are of
-			the form "bbbbpn", where "bbbb" is the baud rate,
-			"p" is parity ("n", "o", or "e"), and "n" is bits.
-			Default is "9600n8".
+			the form "bbbbpnf", where "bbbb" is the baud rate,
+			"p" is parity ("n", "o", or "e"), "n" is number of
+			bits, and "f" is flow control ("r" for RTS or
+			omit it).  Default is "9600n8".
 
-			See also Documentation/serial-console.txt.
+			See Documentation/serial-console.txt for more
+			information.  See
+			Documentation/networking/netconsole.txt for an
+			alternative.
 
 		uart,io,<addr>[,options]
 		uart,mmio,<addr>[,options]
@@ -1008,7 +1014,9 @@ running once the system is up.
 			noexec=on: enable non-executable mappings (default)
 			noexec=off: disable nn-executable mappings
 
-	nofxsr		[BUGS=IA-32]
+	nofxsr		[BUGS=IA-32] Disables x86 floating point extended
+			register save and restore. The kernel will only save
+			legacy floating-point registers on task switch.
 
 	nohlt		[BUGS=ARM]
 
@@ -1053,6 +1061,8 @@ running once the system is up.
 
 	nosbagart	[IA-64]
 
+	nosep		[BUGS=IA-32] Disables x86 SYSENTER/SYSEXIT support.
+
 	nosmp		[SMP] Tells an SMP kernel to act as a UP kernel.
 
 	nosync		[HW,M68K] Disables sync negotiation for all devices.
@@ -1122,6 +1132,11 @@ running once the system is up.
 	pas16=		[HW,SCSI]
 			See header of drivers/scsi/pas16.c.
 
+	pause_on_oops=
+			Halt all CPUs after the first oops has been printed for
+			the specified number of seconds.  This is to be used if
+			your oopses keep scrolling off the screen.
+
 	pcbit=		[HW,ISDN]
 
 	pcd.		[PARIDE]
@@ -1143,6 +1158,9 @@ running once the system is up.
 				Mechanism 2.
 		nommconf	[IA-32,X86_64] Disable use of MMCONFIG for PCI
 				Configuration
+		nomsi		[MSI] If the PCI_MSI kernel config parameter is
+				enabled, this kernel boot option can be used to
+				disable the use of MSI interrupts system-wide.
 		nosort		[IA-32] Don't sort PCI devices according to
 				order given by the PCI BIOS. This sorting is
 				done to get a device order compatible with