Merge branch 'linus' into tracing/core

Merge reason: tracing/core was on an older, pre-rc1 base.

Signed-off-by: Ingo Molnar <mingo@elte.hu>

1 files changed, 9 insertions, 11 deletions

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 2582e7aea29..81cdb7d5e38 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -229,14 +229,6 @@ and is between 256 and 4096 characters. It is defined in the file
 			to assume that this machine's pmtimer latches its value
 			and always returns good values.
 
- 	acpi.power_nocheck=	[HW,ACPI]
- 			Format: 1/0 enable/disable the check of power state.
- 			On some bogus BIOS the _PSC object/_STA object of
- 			power resource can't return the correct device power
- 			state. In such case it is unneccessary to check its
- 			power state again in power transition.
- 			1 : disable the power state check
-
 	acpi_sci=	[HW,ACPI] ACPI System Control Interrupt trigger mode
 			Format: { level | edge | high | low }
 
@@ -1728,8 +1720,8 @@ and is between 256 and 4096 characters. It is defined in the file
 	oprofile.cpu_type=	Force an oprofile cpu type
 			This might be useful if you have an older oprofile
 			userland or if you want common events.
-			Format: { archperfmon }
-			archperfmon: [X86] Force use of architectural
+			Format: { arch_perfmon }
+			arch_perfmon: [X86] Force use of architectural
 				perfmon on Intel CPUs instead of the
 				CPU specific event set.
 
@@ -1863,7 +1855,7 @@ and is between 256 and 4096 characters. It is defined in the file
 				IRQ routing is enabled.
 		noacpi		[X86] Do not use ACPI for IRQ routing
 				or for PCI scanning.
-		nocrs		[X86] Don't use _CRS for PCI resource
+		use_crs		[X86] Use _CRS for PCI resource
 				allocation.
 		routeirq	Do IRQ routing for all PCI devices.
 				This is normally done in pci_enable_device(),
@@ -1923,6 +1915,12 @@ and is between 256 and 4096 characters. It is defined in the file
 			Format: { 0 | 1 }
 			See arch/parisc/kernel/pdc_chassis.c
 
+	percpu_alloc=	[X86] Select which percpu first chunk allocator to use.
+			Allowed values are one of "lpage", "embed" and "4k".
+			See comments in arch/x86/kernel/setup_percpu.c for
+			details on each allocator.  This parameter is primarily
+			for debugging and performance comparison.
+
 	pf.		[PARIDE]
 			See Documentation/blockdev/paride.txt.