Merge remote branch 'intel/drm-intel-next' of ../drm-next into drm-core-next

* 'intel/drm-intel-next' of ../drm-next: (755 commits)
  drm/i915: Only wait on a pending flip if we intend to write to the buffer
  drm/i915/dp: Sanity check eDP existence
  drm/i915: Rebind the buffer if its alignment constraints changes with tiling
  drm/i915: Disable GPU semaphores by default
  drm/i915: Do not overflow the MMADDR write FIFO
  Revert "drm/i915: fix corruptions on i8xx due to relaxed fencing"
  drm/i915: Don't save/restore hardware status page address register
  drm/i915: don't store the reg value for HWS_PGA
  drm/i915: fix memory corruption with GM965 and >4GB RAM
  Linux 2.6.38-rc7
  Revert "TPM: Long default timeout fix"
  drm/i915: Re-enable GPU semaphores for SandyBridge mobile
  drm/i915: Replace vblank PM QoS with "Interrupt-Based AGPBUSY#"
  Revert "drm/i915: Use PM QoS to prevent C-State starvation of gen3 GPU"
  drm/i915: Allow relocation deltas outside of target bo
  drm/i915: Silence an innocuous compiler warning for an unused variable
  fs/block_dev.c: fix new kernel-doc warning
  ACPI: Fix build for CONFIG_NET unset
  mm: <asm-generic/pgtable.h> must include <linux/mm_types.h>
  x86: Use u32 instead of long to set reset vector back to 0
  ...

Conflicts:
	drivers/gpu/drm/i915/i915_gem.c

1 files changed, 16 insertions, 8 deletions

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 89835a4766a..f4a04c0c7ed 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -144,6 +144,11 @@ a fixed number of characters. This limit depends on the architecture
 and is between 256 and 4096 characters. It is defined in the file
 ./include/asm/setup.h as COMMAND_LINE_SIZE.
 
+Finally, the [KMG] suffix is commonly described after a number of kernel
+parameter values. These 'K', 'M', and 'G' letters represent the _binary_
+multipliers 'Kilo', 'Mega', and 'Giga', equalling 2^10, 2^20, and 2^30
+bytes respectively. Such letter suffixes can also be entirely omitted.
+
 
 	acpi=		[HW,ACPI,X86]
 			Advanced Configuration and Power Interface
@@ -545,16 +550,20 @@ and is between 256 and 4096 characters. It is defined in the file
 			Format:
 			<first_slot>,<last_slot>,<port>,<enum_bit>[,<debug>]
 
-	crashkernel=nn[KMG]@ss[KMG]
-			[KNL] Reserve a chunk of physical memory to
-			hold a kernel to switch to with kexec on panic.
+	crashkernel=size[KMG][@offset[KMG]]
+			[KNL] Using kexec, Linux can switch to a 'crash kernel'
+			upon panic. This parameter reserves the physical
+			memory region [offset, offset + size] for that kernel
+			image. If '@offset' is omitted, then a suitable offset
+			is selected automatically. Check
+			Documentation/kdump/kdump.txt for further details.
 
 	crashkernel=range1:size1[,range2:size2,...][@offset]
 			[KNL] Same as above, but depends on the memory
 			in the running system. The syntax of range is
 			start-[end] where start and end are both
 			a memory unit (amount[KMG]). See also
-			Documentation/kdump/kdump.txt for a example.
+			Documentation/kdump/kdump.txt for an example.
 
 	cs89x0_dma=	[HW,NET]
 			Format: <dma>
@@ -1262,10 +1271,9 @@ and is between 256 and 4096 characters. It is defined in the file
 			6 (KERN_INFO)		informational
 			7 (KERN_DEBUG)		debug-level messages
 
-	log_buf_len=n	Sets the size of the printk ring buffer, in bytes.
-			Format: { n | nk | nM }
-			n must be a power of two.  The default size
-			is set in the kernel config file.
+	log_buf_len=n[KMG]	Sets the size of the printk ring buffer,
+			in bytes.  n must be a power of two.  The default
+			size is set in the kernel config file.
 
 	logo.nologo	[FB] Disables display of the built-in Linux logo.
 			This may be used to provide more screen space for