[POWERPC] Add table of contents to booting-without-of.txt

Add table of contents.

Signed-off-by: Stuart Yoder <stuart.yoder@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

1 files changed, 56 insertions, 1 deletions

diff --git a/Documentation/powerpc/booting-without-of.txt b/Documentation/powerpc/booting-without-of.txt
index 258a2797148..d42d98107d4 100644
--- a/Documentation/powerpc/booting-without-of.txt
+++ b/Documentation/powerpc/booting-without-of.txt
@@ -1,7 +1,6 @@
            Booting the Linux/ppc kernel without Open Firmware
            --------------------------------------------------
 
-
 (c) 2005 Benjamin Herrenschmidt <benh at kernel.crashing.org>,
     IBM Corp.
 (c) 2005 Becky Bruce <becky.bruce at freescale.com>,
@@ -9,6 +8,62 @@
 (c) 2006 MontaVista Software, Inc.
     Flash chip node definition
 
+Table of Contents
+=================
+
+  I - Introduction
+    1) Entry point for arch/powerpc
+    2) Board support
+
+  II - The DT block format
+    1) Header
+    2) Device tree generalities
+    3) Device tree "structure" block
+    4) Device tree "strings" block
+
+  III - Required content of the device tree
+    1) Note about cells and address representation
+    2) Note about "compatible" properties
+    3) Note about "name" properties
+    4) Note about node and property names and character set
+    5) Required nodes and properties
+      a) The root node
+      b) The /cpus node
+      c) The /cpus/* nodes
+      d) the /memory node(s)
+      e) The /chosen node
+      f) the /soc<SOCname> node
+
+  IV - "dtc", the device tree compiler
+
+  V - Recommendations for a bootloader
+
+  VI - System-on-a-chip devices and nodes
+    1) Defining child nodes of an SOC
+    2) Representing devices without a current OF specification
+      a) MDIO IO device
+      c) PHY nodes
+      b) Gianfar-compatible ethernet nodes
+      d) Interrupt controllers
+      e) I2C
+      f) Freescale SOC USB controllers
+      g) Freescale SOC SEC Security Engines
+      h) Board Control and Status (BCSR)
+      i) Freescale QUICC Engine module (QE)
+      g) Flash chip nodes
+
+  VII - Specifying interrupt information for devices
+    1) interrupts property
+    2) interrupt-parent property
+    3) OpenPIC Interrupt Controllers
+    4) ISA Interrupt Controllers
+
+  Appendix A - Sample SOC node for MPC8540
+
+
+Revision Information
+====================
+
    May 18, 2005: Rev 0.1 - Initial draft, no chapter III yet.
 
    May 19, 2005: Rev 0.2 - Add chapter III and bits & pieces here or