OMAP2+: disable idle early in the suspend sequence

Some bad interaction between the idle and the suspend paths has been
identified: the idle code is called during the suspend enter and exit
sequences. This could cause corruption or lock-up of resources.

The solution is to move the calls to disable_hlt at the very beginning
of the suspend sequence (ex. in omap3_pm_begin instead of
omap3_pm_prepare), and the call to enable_hlt at the very end of
the suspend sequence (ex. in omap3_pm_end instead of omap3_pm_finish).

Tested with RET and OFF on Beagle and OMAP3EVM.

Signed-off-by: Jean Pihet <j-pihet@ti.com>
Cc: Kevin Hilman <khilman@deeprootsystems.com>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>

1 files changed, 2 insertions, 14 deletions

diff --git a/arch/arm/mach-omap2/pm24xx.c b/arch/arm/mach-omap2/pm24xx.c
index aaeea49b9bd..aea7ced9a2f 100644
--- a/arch/arm/mach-omap2/pm24xx.c
+++ b/arch/arm/mach-omap2/pm24xx.c
@@ -301,14 +301,8 @@ out:
 
 static int omap2_pm_begin(suspend_state_t state)
 {
-	suspend_state = state;
-	return 0;
-}
-
-static int omap2_pm_prepare(void)
-{
-	/* We cannot sleep in idle until we have resumed */
 	disable_hlt();
+	suspend_state = state;
 	return 0;
 }
 
@@ -349,21 +343,15 @@ static int omap2_pm_enter(suspend_state_t state)
 	return ret;
 }
 
-static void omap2_pm_finish(void)
-{
-	enable_hlt();
-}
-
 static void omap2_pm_end(void)
 {
 	suspend_state = PM_SUSPEND_ON;
+	enable_hlt();
 }
 
 static struct platform_suspend_ops omap_pm_ops = {
 	.begin		= omap2_pm_begin,
-	.prepare	= omap2_pm_prepare,
 	.enter		= omap2_pm_enter,
-	.finish		= omap2_pm_finish,
 	.end		= omap2_pm_end,
 	.valid		= suspend_valid_only_mem,
 };