Manual merge with Linus

4 files changed, 52 insertions, 43 deletions

diff --git a/arch/i386/kernel/cpu/cpufreq/acpi-cpufreq.c b/arch/i386/kernel/cpu/cpufreq/acpi-cpufreq.c
index 60a9e54dd20..822c8ce9d1f 100644
--- a/arch/i386/kernel/cpu/cpufreq/acpi-cpufreq.c
+++ b/arch/i386/kernel/cpu/cpufreq/acpi-cpufreq.c
@@ -31,6 +31,7 @@
 #include <linux/cpufreq.h>
 #include <linux/proc_fs.h>
 #include <linux/seq_file.h>
+#include <linux/compiler.h>
 #include <asm/io.h>
 #include <asm/delay.h>
 #include <asm/uaccess.h>
@@ -57,6 +58,8 @@ static struct cpufreq_acpi_io	*acpi_io_data[NR_CPUS];
 
 static struct cpufreq_driver acpi_cpufreq_driver;
 
+static unsigned int acpi_pstate_strict;
+
 static int
 acpi_processor_write_port(
 	u16	port,
@@ -163,34 +166,44 @@ acpi_processor_set_performance (
 	}
 
 	/*
-	 * Then we read the 'status_register' and compare the value with the
-	 * target state's 'status' to make sure the transition was successful.
-	 * Note that we'll poll for up to 1ms (100 cycles of 10us) before
-	 * giving up.
+	 * Assume the write went through when acpi_pstate_strict is not used.
+	 * As read status_register is an expensive operation and there 
+	 * are no specific error cases where an IO port write will fail.
 	 */
-
-	port = data->acpi_data.status_register.address;
-	bit_width = data->acpi_data.status_register.bit_width;
-
-	dprintk("Looking for 0x%08x from port 0x%04x\n",
-		(u32) data->acpi_data.states[state].status, port);
-
-	for (i=0; i<100; i++) {
-		ret = acpi_processor_read_port(port, bit_width, &value);
-		if (ret) {	
-			dprintk("Invalid port width 0x%04x\n", bit_width);
-			retval = ret;
-			goto migrate_end;
+	if (acpi_pstate_strict) {
+		/* Then we read the 'status_register' and compare the value 
+		 * with the target state's 'status' to make sure the 
+		 * transition was successful.
+		 * Note that we'll poll for up to 1ms (100 cycles of 10us) 
+		 * before giving up.
+		 */
+
+		port = data->acpi_data.status_register.address;
+		bit_width = data->acpi_data.status_register.bit_width;
+
+		dprintk("Looking for 0x%08x from port 0x%04x\n",
+			(u32) data->acpi_data.states[state].status, port);
+
+		for (i=0; i<100; i++) {
+			ret = acpi_processor_read_port(port, bit_width, &value);
+			if (ret) {	
+				dprintk("Invalid port width 0x%04x\n", bit_width);
+				retval = ret;
+				goto migrate_end;
+			}
+			if (value == (u32) data->acpi_data.states[state].status)
+				break;
+			udelay(10);
 		}
-		if (value == (u32) data->acpi_data.states[state].status)
-			break;
-		udelay(10);
+	} else {
+		i = 0;
+		value = (u32) data->acpi_data.states[state].status;
 	}
 
 	/* notify cpufreq */
 	cpufreq_notify_transition(&cpufreq_freqs, CPUFREQ_POSTCHANGE);
 
-	if (value != (u32) data->acpi_data.states[state].status) {
+	if (unlikely(value != (u32) data->acpi_data.states[state].status)) {
 		unsigned int tmp = cpufreq_freqs.new;
 		cpufreq_freqs.new = cpufreq_freqs.old;
 		cpufreq_freqs.old = tmp;
@@ -537,6 +550,8 @@ acpi_cpufreq_exit (void)
 	return;
 }
 
+module_param(acpi_pstate_strict, uint, 0644);
+MODULE_PARM_DESC(acpi_pstate_strict, "value 0 or non-zero. non-zero -> strict ACPI checks are performed during frequency changes.");
 
 late_initcall(acpi_cpufreq_init);
 module_exit(acpi_cpufreq_exit);
diff --git a/arch/i386/kernel/cpu/cpufreq/longhaul.c b/arch/i386/kernel/cpu/cpufreq/longhaul.c
index 04e3563da4f..8ef38544453 100644
--- a/arch/i386/kernel/cpu/cpufreq/longhaul.c
+++ b/arch/i386/kernel/cpu/cpufreq/longhaul.c
@@ -64,8 +64,6 @@ static int dont_scale_voltage;
 #define dprintk(msg...) cpufreq_debug_printk(CPUFREQ_DEBUG_DRIVER, "longhaul", msg)
 
 
-#define __hlt()     __asm__ __volatile__("hlt": : :"memory")
-
 /* Clock ratios multiplied by 10 */
 static int clock_ratio[32];
 static int eblcr_table[32];
@@ -168,11 +166,9 @@ static void do_powersaver(union msr_longhaul *longhaul,
 	outb(0xFE,0x21);	/* TMR0 only */
 	outb(0xFF,0x80);	/* delay */
 
-	local_irq_enable();
-
-	__hlt();
+	safe_halt();
 	wrmsrl(MSR_VIA_LONGHAUL, longhaul->val);
-	__hlt();
+	halt();
 
 	local_irq_disable();
 
@@ -251,9 +247,7 @@ static void longhaul_setstate(unsigned int clock_ratio_index)
 		bcr2.bits.CLOCKMUL = clock_ratio_index;
 		local_irq_disable();
 		wrmsrl (MSR_VIA_BCR2, bcr2.val);
-		local_irq_enable();
-
-		__hlt();
+		safe_halt();
 
 		/* Disable software clock multiplier */
 		rdmsrl (MSR_VIA_BCR2, bcr2.val);
@@ -473,11 +467,11 @@ static void __init longhaul_setup_voltagescaling(void)
 	}
 
 	if (vrmrev==0) {
-		dprintk ("VRM 8.5 \n");
+		dprintk ("VRM 8.5\n");
 		memcpy (voltage_table, vrm85scales, sizeof(voltage_table));
 		numvscales = (voltage_table[maxvid]-voltage_table[minvid])/25;
 	} else {
-		dprintk ("Mobile VRM \n");
+		dprintk ("Mobile VRM\n");
 		memcpy (voltage_table, mobilevrmscales, sizeof(voltage_table));
 		numvscales = (voltage_table[maxvid]-voltage_table[minvid])/5;
 	}
diff --git a/arch/i386/kernel/cpu/cpufreq/speedstep-centrino.c b/arch/i386/kernel/cpu/cpufreq/speedstep-centrino.c
index 327a55d4d1c..c397b622043 100644
--- a/arch/i386/kernel/cpu/cpufreq/speedstep-centrino.c
+++ b/arch/i386/kernel/cpu/cpufreq/speedstep-centrino.c
@@ -259,7 +259,7 @@ static int centrino_cpu_init_table(struct cpufreq_policy *policy)
 
 	if (model->op_points == NULL) {
 		/* Matched a non-match */
-		dprintk(KERN_INFO PFX "no table support for CPU model \"%s\": \n",
+		dprintk(KERN_INFO PFX "no table support for CPU model \"%s\"\n",
 		       cpu->x86_model_id);
 #ifndef CONFIG_X86_SPEEDSTEP_CENTRINO_ACPI
 		dprintk(KERN_INFO PFX "try compiling with CONFIG_X86_SPEEDSTEP_CENTRINO_ACPI enabled\n");
@@ -402,7 +402,7 @@ static int centrino_cpu_init_acpi(struct cpufreq_policy *policy)
 
 	for (i=0; i<p.state_count; i++) {
 		if (p.states[i].control != p.states[i].status) {
-			dprintk("Different control (%x) and status values (%x)\n",
+			dprintk("Different control (%llu) and status values (%llu)\n",
 				p.states[i].control, p.states[i].status);
 			result = -EINVAL;
 			goto err_unreg;
@@ -415,7 +415,7 @@ static int centrino_cpu_init_acpi(struct cpufreq_policy *policy)
 		}
 
 		if (p.states[i].core_frequency > p.states[0].core_frequency) {
-			dprintk("P%u has larger frequency (%u) than P0 (%u), skipping\n", i,
+			dprintk("P%u has larger frequency (%llu) than P0 (%llu), skipping\n", i,
 				p.states[i].core_frequency, p.states[0].core_frequency);
 			p.states[i].core_frequency = 0;
 			continue;
@@ -498,13 +498,6 @@ static int centrino_cpu_init(struct cpufreq_policy *policy)
 	if (cpu->x86_vendor != X86_VENDOR_INTEL || !cpu_has(cpu, X86_FEATURE_EST))
 		return -ENODEV;
 
-	for (i = 0; i < N_IDS; i++)
-		if (centrino_verify_cpu_id(cpu, &cpu_ids[i]))
-			break;
-
-	if (i != N_IDS)
-		centrino_cpu[policy->cpu] = &cpu_ids[i];
-
 	if (is_const_loops_cpu(policy->cpu)) {
 		centrino_driver.flags |= CPUFREQ_CONST_LOOPS;
 	}
@@ -513,6 +506,13 @@ static int centrino_cpu_init(struct cpufreq_policy *policy)
 		if (policy->cpu != 0)
 			return -ENODEV;
 
+		for (i = 0; i < N_IDS; i++)
+			if (centrino_verify_cpu_id(cpu, &cpu_ids[i]))
+				break;
+
+		if (i != N_IDS)
+			centrino_cpu[policy->cpu] = &cpu_ids[i];
+
 		if (!centrino_cpu[policy->cpu]) {
 			dprintk(KERN_INFO PFX "found unsupported CPU with "
 			"Enhanced SpeedStep: send /proc/cpuinfo to "
diff --git a/arch/i386/kernel/cpu/cpufreq/speedstep-smi.c b/arch/i386/kernel/cpu/cpufreq/speedstep-smi.c
index b25fb6b635a..2718fb6f6ab 100644
--- a/arch/i386/kernel/cpu/cpufreq/speedstep-smi.c
+++ b/arch/i386/kernel/cpu/cpufreq/speedstep-smi.c
@@ -99,7 +99,7 @@ static int speedstep_smi_get_freqs (unsigned int *low, unsigned int *high)
 	u32 function = GET_SPEEDSTEP_FREQS;
 
 	if (!(ist_info.event & 0xFFFF)) {
-		dprintk("bug #1422 -- can't read freqs from BIOS\n", result);
+		dprintk("bug #1422 -- can't read freqs from BIOS\n");
 		return -ENODEV;
 	}