Merge branch 'next' of git://git.kernel.org/pub/scm/linux/kernel/git/benh/powerpc

* 'next' of git://git.kernel.org/pub/scm/linux/kernel/git/benh/powerpc: (134 commits)
  powerpc/nvram: Enable use Generic NVRAM driver for different size chips
  powerpc/iseries: Fix oops reading from /proc/iSeries/mf/*/cmdline
  powerpc/ps3: Workaround for flash memory I/O error
  powerpc/booke: Don't set DABR on 64-bit BookE, use DAC1 instead
  powerpc/perf_counters: Reduce stack usage of power_check_constraints
  powerpc: Fix bug where perf_counters breaks oprofile
  powerpc/85xx: Fix SMP compile error and allow NULL for smp_ops
  powerpc/irq: Improve nanodoc
  powerpc: Fix some late PowerMac G5 with PCIe ATI graphics
  powerpc/fsl-booke: Use HW PTE format if CONFIG_PTE_64BIT
  powerpc/book3e: Add missing page sizes
  powerpc/pseries: Fix to handle slb resize across migration
  powerpc/powermac: Thermal control turns system off too eagerly
  powerpc/pci: Merge ppc32 and ppc64 versions of phb_scan()
  powerpc/405ex: support cuImage via included dtb
  powerpc/405ex: provide necessary fixup function to support cuImage
  powerpc/40x: Add support for the ESTeem 195E (PPC405EP) SBC
  powerpc/44x: Add Eiger AMCC (AppliedMicro) PPC460SX evaluation board support.
  powerpc/44x: Update Arches defconfig
  powerpc/44x: Update Arches dts
  ...

Fix up conflicts in drivers/char/agp/uninorth-agp.c

1 files changed, 133 insertions, 0 deletions

diff --git a/arch/powerpc/boot/ppcboot-hotfoot.h b/arch/powerpc/boot/ppcboot-hotfoot.h
new file mode 100644
index 00000000000..1a3e80b533d
--- /dev/null
+++ b/arch/powerpc/boot/ppcboot-hotfoot.h
@@ -0,0 +1,133 @@
+/*
+ * This interface is used for compatibility with old U-boots *ONLY*.
+ * Please do not imitate or extend this.
+ */
+
+/* 
+ * Unfortunately, the ESTeem Hotfoot board uses a mangled version of 
+ * ppcboot.h for historical reasons, and in the interest of having a 
+ * mainline kernel boot on the production board+bootloader, this was the 
+ * least-offensive solution.  Please direct all flames to:
+ *
+ *  Solomon Peachy <solomon@linux-wlan.com>
+ *
+ * (This header is identical to ppcboot.h except for the 
+ *  TARGET_HOTFOOT bits)
+ */
+
+/*
+ * (C) Copyright 2000, 2001
+ * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation; either version 2 of
+ * the License, or (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.	 See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 59 Temple Place, Suite 330, Boston,
+ * MA 02111-1307 USA
+ */
+
+#ifndef __PPCBOOT_H__
+#define __PPCBOOT_H__
+
+/*
+ * Board information passed to kernel from PPCBoot
+ *
+ * include/asm-ppc/ppcboot.h
+ */
+
+#include "types.h"
+
+typedef struct bd_info {
+	unsigned long	bi_memstart;	/* start of DRAM memory */
+	unsigned long	bi_memsize;	/* size	 of DRAM memory in bytes */
+	unsigned long	bi_flashstart;	/* start of FLASH memory */
+	unsigned long	bi_flashsize;	/* size	 of FLASH memory */
+	unsigned long	bi_flashoffset; /* reserved area for startup monitor */
+	unsigned long	bi_sramstart;	/* start of SRAM memory */
+	unsigned long	bi_sramsize;	/* size	 of SRAM memory */
+#if defined(TARGET_8xx) || defined(TARGET_CPM2) || defined(TARGET_85xx) ||\
+	defined(TARGET_83xx)
+	unsigned long	bi_immr_base;	/* base of IMMR register */
+#endif
+#if defined(TARGET_PPC_MPC52xx)
+	unsigned long   bi_mbar_base;   /* base of internal registers */
+#endif
+	unsigned long	bi_bootflags;	/* boot / reboot flag (for LynxOS) */
+	unsigned long	bi_ip_addr;	/* IP Address */
+	unsigned char	bi_enetaddr[6];	/* Ethernet address */
+#if defined(TARGET_HOTFOOT)
+	/* second onboard ethernet port */
+	unsigned char	bi_enet1addr[6];
+#define HAVE_ENET1ADDR
+#endif /* TARGET_HOOTFOOT */
+	unsigned short	bi_ethspeed;	/* Ethernet speed in Mbps */
+	unsigned long	bi_intfreq;	/* Internal Freq, in MHz */
+	unsigned long	bi_busfreq;	/* Bus Freq, in MHz */
+#if defined(TARGET_CPM2)
+	unsigned long	bi_cpmfreq;	/* CPM_CLK Freq, in MHz */
+	unsigned long	bi_brgfreq;	/* BRG_CLK Freq, in MHz */
+	unsigned long	bi_sccfreq;	/* SCC_CLK Freq, in MHz */
+	unsigned long	bi_vco;		/* VCO Out from PLL, in MHz */
+#endif
+#if defined(TARGET_PPC_MPC52xx)
+	unsigned long   bi_ipbfreq;     /* IPB Bus Freq, in MHz */
+	unsigned long   bi_pcifreq;     /* PCI Bus Freq, in MHz */
+#endif
+	unsigned long	bi_baudrate;	/* Console Baudrate */
+#if defined(TARGET_4xx)
+	unsigned char	bi_s_version[4];	/* Version of this structure */
+	unsigned char	bi_r_version[32];	/* Version of the ROM (IBM) */
+	unsigned int	bi_procfreq;	/* CPU (Internal) Freq, in Hz */
+	unsigned int	bi_plb_busfreq;	/* PLB Bus speed, in Hz */
+	unsigned int	bi_pci_busfreq;	/* PCI Bus speed, in Hz */
+	unsigned char	bi_pci_enetaddr[6];	/* PCI Ethernet MAC address */
+#endif
+#if defined(TARGET_HOTFOOT)
+	unsigned int     bi_pllouta_freq;       /* PLL OUTA speed, in Hz */
+#endif
+#if defined(TARGET_HYMOD)
+	hymod_conf_t	bi_hymod_conf;	/* hymod configuration information */
+#endif
+#if defined(TARGET_EVB64260) || defined(TARGET_405EP) || defined(TARGET_44x) || \
+	defined(TARGET_85xx) ||	defined(TARGET_83xx) || defined(TARGET_HAS_ETH1)
+	/* second onboard ethernet port */
+	unsigned char	bi_enet1addr[6];
+#define HAVE_ENET1ADDR
+#endif
+#if defined(TARGET_EVB64260) || defined(TARGET_440GX) || \
+    defined(TARGET_85xx) || defined(TARGET_HAS_ETH2)
+	/* third onboard ethernet ports */
+	unsigned char	bi_enet2addr[6];
+#define HAVE_ENET2ADDR
+#endif
+#if defined(TARGET_440GX) || defined(TARGET_HAS_ETH3)
+	/* fourth onboard ethernet ports */
+	unsigned char	bi_enet3addr[6];
+#define HAVE_ENET3ADDR
+#endif
+#if defined(TARGET_HOTFOOT)
+        int             bi_phynum[2];           /* Determines phy mapping */
+        int             bi_phymode[2];          /* Determines phy mode */
+#endif
+#if defined(TARGET_4xx)
+	unsigned int	bi_opbfreq;		/* OB clock in Hz */
+	int		bi_iic_fast[2];		/* Use fast i2c mode */
+#endif
+#if defined(TARGET_440GX)
+	int		bi_phynum[4];		/* phy mapping */
+	int		bi_phymode[4];		/* phy mode */
+#endif
+} bd_t;
+
+#define bi_tbfreq	bi_intfreq
+
+#endif	/* __PPCBOOT_H__ */