[POWERPC] mpc5200: Add generic support for simple MPC5200 based boards

This patch adds support for 'mpc5200-simple-platform' compatible
boards which do not need a platform specific setup. Such boards
are supported assuming the following:

- GPIO pins are configured by the firmware,
- CDM configuration (clocking) is setup correctly by firmware,
- if the 'fsl,has-wdt' property is present in one of the
  gpt nodes, then it is safe to use such gpt to reset the board,
- PCI is supported if enabled in the kernel configuration
  and if there is a PCI bus node defined in the device tree.

Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

2 files changed, 2 insertions, 2 deletions

diff --git a/arch/powerpc/boot/dts/lite5200.dts b/arch/powerpc/boot/dts/lite5200.dts
index 23eeeb1fc61..e1d6f441532 100644
--- a/arch/powerpc/boot/dts/lite5200.dts
+++ b/arch/powerpc/boot/dts/lite5200.dts
@@ -19,7 +19,7 @@
 / {
 	model = "fsl,lite5200";
 	// revision = "1.0";
-	compatible = "fsl,lite5200","generic-mpc5200";
+	compatible = "fsl,lite5200";
 	#address-cells = <1>;
 	#size-cells = <1>;
 
diff --git a/arch/powerpc/boot/dts/lite5200b.dts b/arch/powerpc/boot/dts/lite5200b.dts
index f94e073de9a..3e06f58a0a7 100644
--- a/arch/powerpc/boot/dts/lite5200b.dts
+++ b/arch/powerpc/boot/dts/lite5200b.dts
@@ -19,7 +19,7 @@
 / {
 	model = "fsl,lite5200b";
 	// revision = "1.0";
-	compatible = "fsl,lite5200b","generic-mpc5200";
+	compatible = "fsl,lite5200b";
 	#address-cells = <1>;
 	#size-cells = <1>;