powerpc: Move include files to arch/powerpc/include/asm

from include/asm-powerpc.  This is the result of a

mkdir arch/powerpc/include/asm
git mv include/asm-powerpc/* arch/powerpc/include/asm

Followed by a few documentation/comment fixups and a couple of places
where <asm-powepc/...> was being used explicitly.  Of the latter only
one was outside the arch code and it is a driver only built for powerpc.

Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>

1 files changed, 149 insertions, 0 deletions

diff --git a/arch/powerpc/include/asm/dcr-regs.h b/arch/powerpc/include/asm/dcr-regs.h
new file mode 100644
index 00000000000..29b0ecef980
--- /dev/null
+++ b/arch/powerpc/include/asm/dcr-regs.h
@@ -0,0 +1,149 @@
+/*
+ * Common DCR / SDR / CPR register definitions used on various IBM/AMCC
+ * 4xx processors
+ *
+ *    Copyright 2007 Benjamin Herrenschmidt, IBM Corp
+ *                   <benh@kernel.crashing.org>
+ *
+ * Mostly lifted from asm-ppc/ibm4xx.h by
+ *
+ *    Copyright (c) 1999 Grant Erickson <grant@lcse.umn.edu>
+ *
+ */
+
+#ifndef __DCR_REGS_H__
+#define __DCR_REGS_H__
+
+/*
+ * Most DCRs used for controlling devices such as the MAL, DMA engine,
+ * etc... are obtained for the device tree.
+ *
+ * The definitions in this files are fixed DCRs and indirect DCRs that
+ * are commonly used outside of specific drivers or refer to core
+ * common registers that may occasionally have to be tweaked outside
+ * of the driver main register set
+ */
+
+/* CPRs (440GX and 440SP/440SPe) */
+#define DCRN_CPR0_CONFIG_ADDR	0xc
+#define DCRN_CPR0_CONFIG_DATA	0xd
+
+/* SDRs (440GX and 440SP/440SPe) */
+#define DCRN_SDR0_CONFIG_ADDR 	0xe
+#define DCRN_SDR0_CONFIG_DATA	0xf
+
+#define SDR0_PFC0		0x4100
+#define SDR0_PFC1		0x4101
+#define SDR0_PFC1_EPS		0x1c00000
+#define SDR0_PFC1_EPS_SHIFT	22
+#define SDR0_PFC1_RMII		0x02000000
+#define SDR0_MFR		0x4300
+#define SDR0_MFR_TAH0 		0x80000000  	/* TAHOE0 Enable */
+#define SDR0_MFR_TAH1 		0x40000000  	/* TAHOE1 Enable */
+#define SDR0_MFR_PCM  		0x10000000  	/* PPC440GP irq compat mode */
+#define SDR0_MFR_ECS  		0x08000000  	/* EMAC int clk */
+#define SDR0_MFR_T0TXFL		0x00080000
+#define SDR0_MFR_T0TXFH		0x00040000
+#define SDR0_MFR_T1TXFL		0x00020000
+#define SDR0_MFR_T1TXFH		0x00010000
+#define SDR0_MFR_E0TXFL		0x00008000
+#define SDR0_MFR_E0TXFH		0x00004000
+#define SDR0_MFR_E0RXFL		0x00002000
+#define SDR0_MFR_E0RXFH		0x00001000
+#define SDR0_MFR_E1TXFL		0x00000800
+#define SDR0_MFR_E1TXFH		0x00000400
+#define SDR0_MFR_E1RXFL		0x00000200
+#define SDR0_MFR_E1RXFH		0x00000100
+#define SDR0_MFR_E2TXFL		0x00000080
+#define SDR0_MFR_E2TXFH		0x00000040
+#define SDR0_MFR_E2RXFL		0x00000020
+#define SDR0_MFR_E2RXFH		0x00000010
+#define SDR0_MFR_E3TXFL		0x00000008
+#define SDR0_MFR_E3TXFH		0x00000004
+#define SDR0_MFR_E3RXFL		0x00000002
+#define SDR0_MFR_E3RXFH		0x00000001
+#define SDR0_UART0		0x0120
+#define SDR0_UART1		0x0121
+#define SDR0_UART2		0x0122
+#define SDR0_UART3		0x0123
+#define SDR0_CUST0		0x4000
+
+/*
+ * All those DCR register addresses are offsets from the base address
+ * for the SRAM0 controller (e.g. 0x20 on 440GX). The base address is
+ * excluded here and configured in the device tree.
+ */
+#define DCRN_SRAM0_SB0CR	0x00
+#define DCRN_SRAM0_SB1CR	0x01
+#define DCRN_SRAM0_SB2CR	0x02
+#define DCRN_SRAM0_SB3CR	0x03
+#define  SRAM_SBCR_BU_MASK	0x00000180
+#define  SRAM_SBCR_BS_64KB	0x00000800
+#define  SRAM_SBCR_BU_RO	0x00000080
+#define  SRAM_SBCR_BU_RW	0x00000180
+#define DCRN_SRAM0_BEAR		0x04
+#define DCRN_SRAM0_BESR0	0x05
+#define DCRN_SRAM0_BESR1	0x06
+#define DCRN_SRAM0_PMEG		0x07
+#define DCRN_SRAM0_CID		0x08
+#define DCRN_SRAM0_REVID	0x09
+#define DCRN_SRAM0_DPC		0x0a
+#define  SRAM_DPC_ENABLE	0x80000000
+
+/*
+ * All those DCR register addresses are offsets from the base address
+ * for the SRAM0 controller (e.g. 0x30 on 440GX). The base address is
+ * excluded here and configured in the device tree.
+ */
+#define DCRN_L2C0_CFG		0x00
+#define  L2C_CFG_L2M		0x80000000
+#define  L2C_CFG_ICU		0x40000000
+#define  L2C_CFG_DCU		0x20000000
+#define  L2C_CFG_DCW_MASK	0x1e000000
+#define  L2C_CFG_TPC		0x01000000
+#define  L2C_CFG_CPC		0x00800000
+#define  L2C_CFG_FRAN		0x00200000
+#define  L2C_CFG_SS_MASK	0x00180000
+#define  L2C_CFG_SS_256		0x00000000
+#define  L2C_CFG_CPIM		0x00040000
+#define  L2C_CFG_TPIM		0x00020000
+#define  L2C_CFG_LIM		0x00010000
+#define  L2C_CFG_PMUX_MASK	0x00007000
+#define  L2C_CFG_PMUX_SNP	0x00000000
+#define  L2C_CFG_PMUX_IF	0x00001000
+#define  L2C_CFG_PMUX_DF	0x00002000
+#define  L2C_CFG_PMUX_DS	0x00003000
+#define  L2C_CFG_PMIM		0x00000800
+#define  L2C_CFG_TPEI		0x00000400
+#define  L2C_CFG_CPEI		0x00000200
+#define  L2C_CFG_NAM		0x00000100
+#define  L2C_CFG_SMCM		0x00000080
+#define  L2C_CFG_NBRM		0x00000040
+#define  L2C_CFG_RDBW		0x00000008	/* only 460EX/GT */
+#define DCRN_L2C0_CMD		0x01
+#define  L2C_CMD_CLR		0x80000000
+#define  L2C_CMD_DIAG		0x40000000
+#define  L2C_CMD_INV		0x20000000
+#define  L2C_CMD_CCP		0x10000000
+#define  L2C_CMD_CTE		0x08000000
+#define  L2C_CMD_STRC		0x04000000
+#define  L2C_CMD_STPC		0x02000000
+#define  L2C_CMD_RPMC		0x01000000
+#define  L2C_CMD_HCC		0x00800000
+#define DCRN_L2C0_ADDR		0x02
+#define DCRN_L2C0_DATA		0x03
+#define DCRN_L2C0_SR		0x04
+#define  L2C_SR_CC		0x80000000
+#define  L2C_SR_CPE		0x40000000
+#define  L2C_SR_TPE		0x20000000
+#define  L2C_SR_LRU		0x10000000
+#define  L2C_SR_PCS		0x08000000
+#define DCRN_L2C0_REVID		0x05
+#define DCRN_L2C0_SNP0		0x06
+#define DCRN_L2C0_SNP1		0x07
+#define  L2C_SNP_BA_MASK	0xffff0000
+#define  L2C_SNP_SSR_MASK	0x0000f000
+#define  L2C_SNP_SSR_32G	0x0000f000
+#define  L2C_SNP_ESR		0x00000800
+
+#endif /* __DCR_REGS_H__ */