diff options
| author | Trent Piepho <tpiepho@freescale.com> | 2008-11-19 03:13:14 -0800 |
|---|---|---|
| committer | Kumar Gala <galak@kernel.crashing.org> | 2008-12-03 08:19:18 -0600 |
| commit | b3898895355f73973eb3aef3489e999d3fb8e2bc (patch) | |
| tree | c9738f5585158948f6d2cd3955aa4969b2b4b935 /arch/powerpc/kernel/head_fsl_booke.S | |
| parent | 6a800f36acd5bf06b5fe2cb27c4d0524d60c3df5 (diff) | |
powerpc: Better setup of boot page TLB entry
The initial TLB mapping for the kernel boot didn't set the memory coherent
attribute, MAS2[M], in SMP mode.
If this code supported booting a secondary processor, which it doesn't yet,
but if it did, then when a secondary processor boots, it would probably signal
the primary processor by setting a variable called something like
__secondary_hold_acknowledge. However, due to the lack of the M bit, the
primary processor would not snoop the transaction (even if a transaction were
broadcast). If primary CPU's L1 D-cache had a copy, it would not be flushed
and the CPU would never see the ack. Which would have resulted in the primary
CPU spinning for a long time, perhaps a full second before it gives up, while
it would have waited for the ack from the secondary CPU that it wouldn't have
been able to see because of the stale cache.
The value of MAS2 for the boot page TLB1 entry is a compile time constant,
so there is no need to calculate it in powerpc assembly language.
Also, from the MPC8572 manual section 6.12.5.3, "Bits that represent
offsets within a page are ignored and should be cleared." Existing code
didn't clear them, this code does.
The same when the page of KERNELBASE is found; we don't need to use asm to
mask the lower 12 bits off.
In the code that computes the address to rfi from, don't hard code the
offset to 24 bytes, but have the assembler figure that out for us.
Signed-off-by: Trent Piepho <tpiepho@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Diffstat (limited to 'arch/powerpc/kernel/head_fsl_booke.S')
| -rw-r--r-- | arch/powerpc/kernel/head_fsl_booke.S | 22 |
1 files changed, 13 insertions, 9 deletions
diff --git a/arch/powerpc/kernel/head_fsl_booke.S b/arch/powerpc/kernel/head_fsl_booke.S index 837e3cc9cc8..8942d7a82fa 100644 --- a/arch/powerpc/kernel/head_fsl_booke.S +++ b/arch/powerpc/kernel/head_fsl_booke.S @@ -235,36 +235,40 @@ skpinv: addi r6,r6,1 /* Increment */ tlbivax 0,r9 TLBSYNC +/* The mapping only needs to be cache-coherent on SMP */ +#ifdef CONFIG_SMP +#define M_IF_SMP MAS2_M +#else +#define M_IF_SMP 0 +#endif + /* 6. Setup KERNELBASE mapping in TLB1[0] */ lis r6,0x1000 /* Set MAS0(TLBSEL) = TLB1(1), ESEL = 0 */ mtspr SPRN_MAS0,r6 lis r6,(MAS1_VALID|MAS1_IPROT)@h ori r6,r6,(MAS1_TSIZE(BOOKE_PAGESZ_64M))@l mtspr SPRN_MAS1,r6 - li r7,0 - lis r6,PAGE_OFFSET@h - ori r6,r6,PAGE_OFFSET@l - rlwimi r6,r7,0,20,31 + lis r6,MAS2_VAL(PAGE_OFFSET, BOOKE_PAGESZ_64M, M_IF_SMP)@h + ori r6,r6,MAS2_VAL(PAGE_OFFSET, BOOKE_PAGESZ_64M, M_IF_SMP)@l mtspr SPRN_MAS2,r6 mtspr SPRN_MAS3,r8 tlbwe /* 7. Jump to KERNELBASE mapping */ - lis r6,KERNELBASE@h - ori r6,r6,KERNELBASE@l - rlwimi r6,r7,0,20,31 + lis r6,(KERNELBASE & ~0xfff)@h + ori r6,r6,(KERNELBASE & ~0xfff)@l lis r7,MSR_KERNEL@h ori r7,r7,MSR_KERNEL@l bl 1f /* Find our address */ 1: mflr r9 rlwimi r6,r9,0,20,31 - addi r6,r6,24 + addi r6,r6,(2f - 1b) mtspr SPRN_SRR0,r6 mtspr SPRN_SRR1,r7 rfi /* start execution out of TLB1[0] entry */ /* 8. Clear out the temp mapping */ - lis r7,0x1000 /* Set MAS0(TLBSEL) = 1 */ +2: lis r7,0x1000 /* Set MAS0(TLBSEL) = 1 */ rlwimi r7,r5,16,4,15 /* Setup MAS0 = TLBSEL | ESEL(r5) */ mtspr SPRN_MAS0,r7 tlbre |