Merge git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6: (187 commits)
  sh: remove dead LED code for migo-r and ms7724se
  sh: ecovec build fix for CONFIG_I2C=n
  sh: ecovec r-standby support
  sh: ms7724se r-standby support
  sh: SH-Mobile R-standby register save/restore
  clocksource: Fix up a registration/IRQ race in the sh drivers.
  sh: ms7724: modify scan_timing for KEYSC
  sh: ms7724: Add sh_sir support
  sh: mach-ecovec24: Add sh_sir support
  sh: wire up SET/GET_UNALIGN_CTL.
  sh: allow alignment fault mode to be configured at kernel boot.
  sh: sh7724: Update FSI/SPU2 clock
  sh: always enable sh7724 vpu_clk and set to 166MHz on Ecovec
  sh: add sh7724 kick callback to clk_div4_table
  sh: introduce struct clk_div4_table
  sh: clock-cpg div4 set_rate() shift fix
  sh: Turn on speculative return for SH7785 and SH7786
  sh: Merge legacy and dynamic PMB modes.
  sh: Use uncached I/O helpers in PMB setup.
  sh: Provide uncached I/O helpers.
  ...

1 files changed, 48 insertions, 0 deletions

diff --git a/arch/sh/boards/mach-sdk7786/irq.c b/arch/sh/boards/mach-sdk7786/irq.c
new file mode 100644
index 00000000000..46943a0da5b
--- /dev/null
+++ b/arch/sh/boards/mach-sdk7786/irq.c
@@ -0,0 +1,48 @@
+/*
+ * SDK7786 FPGA IRQ Controller Support.
+ *
+ * Copyright (C) 2010  Matt Fleming
+ * Copyright (C) 2010  Paul Mundt
+ *
+ * This file is subject to the terms and conditions of the GNU General Public
+ * License.  See the file "COPYING" in the main directory of this archive
+ * for more details.
+ */
+#include <linux/irq.h>
+#include <mach/fpga.h>
+#include <mach/irq.h>
+
+enum {
+	ATA_IRQ_BIT		= 1,
+	SPI_BUSY_BIT		= 2,
+	LIRQ5_BIT		= 3,
+	LIRQ6_BIT		= 4,
+	LIRQ7_BIT		= 5,
+	LIRQ8_BIT		= 6,
+	KEY_IRQ_BIT		= 7,
+	PEN_IRQ_BIT		= 8,
+	ETH_IRQ_BIT		= 9,
+	RTC_ALARM_BIT		= 10,
+	CRYSTAL_FAIL_BIT	= 12,
+	ETH_PME_BIT		= 14,
+};
+
+void __init sdk7786_init_irq(void)
+{
+	unsigned int tmp;
+
+	/* Enable priority encoding for all IRLs */
+	fpga_write_reg(fpga_read_reg(INTMSR) | 0x0303, INTMSR);
+
+	/* Clear FPGA interrupt status registers */
+	fpga_write_reg(0x0000, INTASR);
+	fpga_write_reg(0x0000, INTBSR);
+
+	/* Unmask FPGA interrupts */
+	tmp = fpga_read_reg(INTAMR);
+	tmp &= ~(1 << ETH_IRQ_BIT);
+	fpga_write_reg(tmp, INTAMR);
+
+	plat_irq_setup_pins(IRQ_MODE_IRL7654_MASK);
+	plat_irq_setup_pins(IRQ_MODE_IRL3210_MASK);
+}