Merge git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6: (187 commits)
  sh: remove dead LED code for migo-r and ms7724se
  sh: ecovec build fix for CONFIG_I2C=n
  sh: ecovec r-standby support
  sh: ms7724se r-standby support
  sh: SH-Mobile R-standby register save/restore
  clocksource: Fix up a registration/IRQ race in the sh drivers.
  sh: ms7724: modify scan_timing for KEYSC
  sh: ms7724: Add sh_sir support
  sh: mach-ecovec24: Add sh_sir support
  sh: wire up SET/GET_UNALIGN_CTL.
  sh: allow alignment fault mode to be configured at kernel boot.
  sh: sh7724: Update FSI/SPU2 clock
  sh: always enable sh7724 vpu_clk and set to 166MHz on Ecovec
  sh: add sh7724 kick callback to clk_div4_table
  sh: introduce struct clk_div4_table
  sh: clock-cpg div4 set_rate() shift fix
  sh: Turn on speculative return for SH7785 and SH7786
  sh: Merge legacy and dynamic PMB modes.
  sh: Use uncached I/O helpers in PMB setup.
  sh: Provide uncached I/O helpers.
  ...

1 files changed, 9 insertions, 9 deletions

diff --git a/arch/sh/boards/mach-se/7780/irq.c b/arch/sh/boards/mach-se/7780/irq.c
index 121744c0871..d5c9edc172a 100644
--- a/arch/sh/boards/mach-se/7780/irq.c
+++ b/arch/sh/boards/mach-se/7780/irq.c
@@ -24,30 +24,30 @@
 void __init init_se7780_IRQ(void)
 {
 	/* enable all interrupt at FPGA */
-	ctrl_outw(0, FPGA_INTMSK1);
+	__raw_writew(0, FPGA_INTMSK1);
 	/* mask SM501 interrupt */
-	ctrl_outw((ctrl_inw(FPGA_INTMSK1) | 0x0002), FPGA_INTMSK1);
+	__raw_writew((__raw_readw(FPGA_INTMSK1) | 0x0002), FPGA_INTMSK1);
 	/* enable all interrupt at FPGA */
-	ctrl_outw(0, FPGA_INTMSK2);
+	__raw_writew(0, FPGA_INTMSK2);
 
 	/* set FPGA INTSEL register */
 	/* FPGA + 0x06 */
-	ctrl_outw( ((IRQPIN_SM501 << IRQPOS_SM501) |
+	__raw_writew( ((IRQPIN_SM501 << IRQPOS_SM501) |
 		(IRQPIN_SMC91CX << IRQPOS_SMC91CX)), FPGA_INTSEL1);
 
 	/* FPGA + 0x08 */
-	ctrl_outw(((IRQPIN_EXTINT4 << IRQPOS_EXTINT4) |
+	__raw_writew(((IRQPIN_EXTINT4 << IRQPOS_EXTINT4) |
 		(IRQPIN_EXTINT3 << IRQPOS_EXTINT3) |
 		(IRQPIN_EXTINT2 << IRQPOS_EXTINT2) |
 		(IRQPIN_EXTINT1 << IRQPOS_EXTINT1)), FPGA_INTSEL2);
 
 	/* FPGA + 0x0A */
-	ctrl_outw((IRQPIN_PCCPW << IRQPOS_PCCPW), FPGA_INTSEL3);
+	__raw_writew((IRQPIN_PCCPW << IRQPOS_PCCPW), FPGA_INTSEL3);
 
 	plat_irq_setup_pins(IRQ_MODE_IRQ); /* install handlers for IRQ0-7 */
 
 	/* ICR1: detect low level(for 2ndcut) */
-	ctrl_outl(0xAAAA0000, INTC_ICR1);
+	__raw_writel(0xAAAA0000, INTC_ICR1);
 
 	/*
 	 * FPGA PCISEL register initialize
@@ -63,6 +63,6 @@ void __init init_se7780_IRQ(void)
 	 *  INTD || INTD  | INTC  |  --   | INTA
 	 *  -------------------------------------
 	 */
-	ctrl_outw(0x0013, FPGA_PCI_INTSEL1);
-	ctrl_outw(0xE402, FPGA_PCI_INTSEL2);
+	__raw_writew(0x0013, FPGA_PCI_INTSEL1);
+	__raw_writew(0xE402, FPGA_PCI_INTSEL2);
 }