sata_mv ncq Fix EDMA configuration

Simplify and fix EDMA configuration setup to match Marvell specificiations.
The chip documentation gives a specific (re)init sequence, which we now follow.

Signed-off-by: Mark Lord <mlord@pobox.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

1 files changed, 34 insertions, 20 deletions

diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index 298f17d6e12..f117f6a0167 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c
@@ -210,6 +210,7 @@ enum {
 	/* SATA registers */
 	SATA_STATUS_OFS		= 0x300,  /* ctrl, err regs follow status */
 	SATA_ACTIVE_OFS		= 0x350,
+	SATA_FIS_IRQ_CAUSE_OFS	= 0x364,
 	PHY_MODE3		= 0x310,
 	PHY_MODE4		= 0x314,
 	PHY_MODE2		= 0x330,
@@ -222,11 +223,11 @@ enum {
 
 	/* Port registers */
 	EDMA_CFG_OFS		= 0,
-	EDMA_CFG_Q_DEPTH	= 0,			/* queueing disabled */
-	EDMA_CFG_NCQ		= (1 << 5),
-	EDMA_CFG_NCQ_GO_ON_ERR	= (1 << 14),		/* continue on error */
-	EDMA_CFG_RD_BRST_EXT	= (1 << 11),		/* read burst 512B */
-	EDMA_CFG_WR_BUFF_LEN	= (1 << 13),		/* write buffer 512B */
+	EDMA_CFG_Q_DEPTH	= 0x1f,		/* max device queue depth */
+	EDMA_CFG_NCQ		= (1 << 5),	/* for R/W FPDMA queued */
+	EDMA_CFG_NCQ_GO_ON_ERR	= (1 << 14),	/* continue on error */
+	EDMA_CFG_RD_BRST_EXT	= (1 << 11),	/* read burst 512B */
+	EDMA_CFG_WR_BUFF_LEN	= (1 << 13),	/* write buffer 512B */
 
 	EDMA_ERR_IRQ_CAUSE_OFS	= 0x8,
 	EDMA_ERR_IRQ_MASK_OFS	= 0xc,
@@ -470,6 +471,8 @@ static void mv6_reset_flash(struct mv_host_priv *hpriv, void __iomem *mmio);
 static void mv_reset_pci_bus(struct pci_dev *pdev, void __iomem *mmio);
 static void mv_channel_reset(struct mv_host_priv *hpriv, void __iomem *mmio,
 			     unsigned int port_no);
+static void mv_edma_cfg(struct ata_port *ap, struct mv_host_priv *hpriv,
+			void __iomem *port_mmio);
 
 static struct scsi_host_template mv5_sht = {
 	.module			= THIS_MODULE,
@@ -834,13 +837,33 @@ static void mv_set_edma_ptrs(void __iomem *port_mmio,
  *      LOCKING:
  *      Inherited from caller.
  */
-static void mv_start_dma(void __iomem *port_mmio, struct mv_host_priv *hpriv,
+static void mv_start_dma(struct ata_port *ap, void __iomem *port_mmio,
 			 struct mv_port_priv *pp)
 {
 	if (!(pp->pp_flags & MV_PP_FLAG_EDMA_EN)) {
+		struct mv_host_priv *hpriv = ap->host->private_data;
+		int hard_port = mv_hardport_from_port(ap->port_no);
+		void __iomem *hc_mmio = mv_hc_base_from_port(
+				ap->host->iomap[MV_PRIMARY_BAR], hard_port);
+		u32 hc_irq_cause, ipending;
+
 		/* clear EDMA event indicators, if any */
 		writelfl(0, port_mmio + EDMA_ERR_IRQ_CAUSE_OFS);
 
+		/* clear EDMA interrupt indicator, if any */
+		hc_irq_cause = readl(hc_mmio + HC_IRQ_CAUSE_OFS);
+		ipending = (DEV_IRQ << hard_port) |
+				(CRPB_DMA_DONE << hard_port);
+		if (hc_irq_cause & ipending) {
+			writelfl(hc_irq_cause & ~ipending,
+				 hc_mmio + HC_IRQ_CAUSE_OFS);
+		}
+
+		mv_edma_cfg(ap, hpriv, port_mmio);
+
+		/* clear FIS IRQ Cause */
+		writelfl(0, port_mmio + SATA_FIS_IRQ_CAUSE_OFS);
+
 		mv_set_edma_ptrs(port_mmio, hpriv, pp);
 
 		writelfl(EDMA_EN, port_mmio + EDMA_CMD_OFS);
@@ -1025,30 +1048,22 @@ static int mv_scr_write(struct ata_port *ap, unsigned int sc_reg_in, u32 val)
 static void mv_edma_cfg(struct ata_port *ap, struct mv_host_priv *hpriv,
 			void __iomem *port_mmio)
 {
-	u32 cfg = readl(port_mmio + EDMA_CFG_OFS);
+	u32 cfg;
 
 	/* set up non-NCQ EDMA configuration */
-	cfg &= ~(1 << 9);	/* disable eQue */
+	cfg = EDMA_CFG_Q_DEPTH;		/* always 0x1f for *all* chips */
 
-	if (IS_GEN_I(hpriv)) {
-		cfg &= ~0x1f;		/* clear queue depth */
+	if (IS_GEN_I(hpriv))
 		cfg |= (1 << 8);	/* enab config burst size mask */
-	}
 
-	else if (IS_GEN_II(hpriv)) {
-		cfg &= ~0x1f;		/* clear queue depth */
+	else if (IS_GEN_II(hpriv))
 		cfg |= EDMA_CFG_RD_BRST_EXT | EDMA_CFG_WR_BUFF_LEN;
-		cfg &= ~(EDMA_CFG_NCQ | EDMA_CFG_NCQ_GO_ON_ERR); /* clear NCQ */
-	}
 
 	else if (IS_GEN_IIE(hpriv)) {
 		cfg |= (1 << 23);	/* do not mask PM field in rx'd FIS */
 		cfg |= (1 << 22);	/* enab 4-entry host queue cache */
-		cfg &= ~(1 << 19);	/* dis 128-entry queue (for now?) */
 		cfg |= (1 << 18);	/* enab early completion */
 		cfg |= (1 << 17);	/* enab cut-through (dis stor&forwrd) */
-		cfg &= ~(1 << 16);	/* dis FIS-based switching (for now) */
-		cfg &= ~(EDMA_CFG_NCQ);	/* clear NCQ */
 	}
 
 	writelfl(cfg, port_mmio + EDMA_CFG_OFS);
@@ -1370,7 +1385,6 @@ static unsigned int mv_qc_issue(struct ata_queued_cmd *qc)
 	struct ata_port *ap = qc->ap;
 	void __iomem *port_mmio = mv_ap_base(ap);
 	struct mv_port_priv *pp = ap->private_data;
-	struct mv_host_priv *hpriv = ap->host->private_data;
 	u32 in_index;
 
 	if (qc->tf.protocol != ATA_PROT_DMA) {
@@ -1382,7 +1396,7 @@ static unsigned int mv_qc_issue(struct ata_queued_cmd *qc)
 		return ata_qc_issue_prot(qc);
 	}
 
-	mv_start_dma(port_mmio, hpriv, pp);
+	mv_start_dma(ap, port_mmio, pp);
 
 	in_index = pp->req_idx & MV_MAX_Q_DEPTH_MASK;