Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux-2.6

1 files changed, 24 insertions, 20 deletions

diff --git a/drivers/leds/leds-lp5523.c b/drivers/leds/leds-lp5523.c
index 1e11fcc08b2..0cc4ead2fd8 100644
--- a/drivers/leds/leds-lp5523.c
+++ b/drivers/leds/leds-lp5523.c
@@ -134,15 +134,18 @@ struct lp5523_chip {
 	u8			num_leds;
 };
 
-#define cdev_to_led(c)          container_of(c, struct lp5523_led, cdev)
+static inline struct lp5523_led *cdev_to_led(struct led_classdev *cdev)
+{
+	return container_of(cdev, struct lp5523_led, cdev);
+}
 
-static struct lp5523_chip *engine_to_lp5523(struct lp5523_engine *engine)
+static inline struct lp5523_chip *engine_to_lp5523(struct lp5523_engine *engine)
 {
 	return container_of(engine, struct lp5523_chip,
 			    engines[engine->id - 1]);
 }
 
-static struct lp5523_chip *led_to_lp5523(struct lp5523_led *led)
+static inline struct lp5523_chip *led_to_lp5523(struct lp5523_led *led)
 {
 	return container_of(led, struct lp5523_chip,
 			    leds[led->id]);
@@ -200,13 +203,9 @@ static int lp5523_configure(struct i2c_client *client)
 		{ 0x9c, 0x50, 0x9c, 0xd0, 0x9d, 0x80, 0xd8, 0x00, 0},
 	};
 
-	lp5523_write(client, LP5523_REG_RESET, 0xff);
-
-	usleep_range(10000, 100000);
-
 	ret |= lp5523_write(client, LP5523_REG_ENABLE, LP5523_ENABLE);
-	/* Chip startup time after reset is 500 us */
-	usleep_range(1000, 10000);
+	/* Chip startup time is 500 us, 1 - 2 ms gives some margin */
+	usleep_range(1000, 2000);
 
 	ret |= lp5523_write(client, LP5523_REG_CONFIG,
 			    LP5523_AUTO_INC | LP5523_PWR_SAVE |
@@ -243,8 +242,8 @@ static int lp5523_configure(struct i2c_client *client)
 		return -1;
 	}
 
-	/* Wait 3ms and check the engine status */
-	usleep_range(3000, 20000);
+	/* Let the programs run for couple of ms and check the engine status */
+	usleep_range(3000, 6000);
 	lp5523_read(client, LP5523_REG_STATUS, &status);
 	status &= LP5523_ENG_STATUS_MASK;
 
@@ -449,10 +448,10 @@ static ssize_t lp5523_selftest(struct device *dev,
 	/* Measure VDD (i.e. VBAT) first (channel 16 corresponds to VDD) */
 	lp5523_write(chip->client, LP5523_REG_LED_TEST_CTRL,
 				    LP5523_EN_LEDTEST | 16);
-	usleep_range(3000, 10000);
+	usleep_range(3000, 6000); /* ADC conversion time is typically 2.7 ms */
 	ret = lp5523_read(chip->client, LP5523_REG_STATUS, &status);
 	if (!(status & LP5523_LEDTEST_DONE))
-		usleep_range(3000, 10000);
+		usleep_range(3000, 6000); /* Was not ready. Wait little bit */
 
 	ret |= lp5523_read(chip->client, LP5523_REG_LED_TEST_ADC, &vdd);
 	vdd--;	/* There may be some fluctuation in measurement */
@@ -468,16 +467,16 @@ static ssize_t lp5523_selftest(struct device *dev,
 			chip->pdata->led_config[i].led_current);
 
 		lp5523_write(chip->client, LP5523_REG_LED_PWM_BASE + i, 0xff);
-		/* let current stabilize 2ms before measurements start */
-		usleep_range(2000, 10000);
+		/* let current stabilize 2 - 4ms before measurements start */
+		usleep_range(2000, 4000);
 		lp5523_write(chip->client,
 			     LP5523_REG_LED_TEST_CTRL,
 			     LP5523_EN_LEDTEST | i);
-		/* ledtest takes 2.7ms */
-		usleep_range(3000, 10000);
+		/* ADC conversion time is 2.7 ms typically */
+		usleep_range(3000, 6000);
 		ret = lp5523_read(chip->client, LP5523_REG_STATUS, &status);
 		if (!(status & LP5523_LEDTEST_DONE))
-			usleep_range(3000, 10000);
+			usleep_range(3000, 6000);/* Was not ready. Wait. */
 		ret |= lp5523_read(chip->client, LP5523_REG_LED_TEST_ADC, &adc);
 
 		if (adc >= vdd || adc < LP5523_ADC_SHORTCIRC_LIM)
@@ -930,11 +929,16 @@ static int lp5523_probe(struct i2c_client *client,
 
 	if (pdata->enable) {
 		pdata->enable(0);
-		usleep_range(1000, 10000);
+		usleep_range(1000, 2000); /* Keep enable down at least 1ms */
 		pdata->enable(1);
-		usleep_range(1000, 10000); /* Spec says min 500us */
+		usleep_range(1000, 2000); /* 500us abs min. */
 	}
 
+	lp5523_write(client, LP5523_REG_RESET, 0xff);
+	usleep_range(10000, 20000); /*
+				     * Exact value is not available. 10 - 20ms
+				     * appears to be enough for reset.
+				     */
 	ret = lp5523_detect(client);
 	if (ret)
 		goto fail2;