diff options
| author | Bruce Allan <bruce.w.allan@intel.com> | 2009-12-01 15:51:11 +0000 |
|---|---|---|
| committer | David S. Miller <davem@davemloft.net> | 2009-12-02 00:35:54 -0800 |
| commit | 5ff5b664351a94754031c1e5783f0cea6b3000ed (patch) | |
| tree | 09ff7ddacd94175b78879548179f108c1593efc1 /drivers/net/e1000e/phy.c | |
| parent | 9e135a2e6266eba276f33c404a2478499bc07ff5 (diff) | |
e1000e: comment corrections
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Diffstat (limited to 'drivers/net/e1000e/phy.c')
| -rw-r--r-- | drivers/net/e1000e/phy.c | 14 |
1 files changed, 7 insertions, 7 deletions
diff --git a/drivers/net/e1000e/phy.c b/drivers/net/e1000e/phy.c index 140b23b320f..1bc09b240e6 100644 --- a/drivers/net/e1000e/phy.c +++ b/drivers/net/e1000e/phy.c @@ -153,10 +153,10 @@ s32 e1000e_get_phy_id(struct e1000_hw *hw) goto out; /* - * If the PHY ID is still unknown, we may have an 82577i - * without link. We will try again after setting Slow - * MDIC mode. No harm in trying again in this case since - * the PHY ID is unknown at this point anyway + * If the PHY ID is still unknown, we may have an 82577 + * without link. We will try again after setting Slow MDIC + * mode. No harm in trying again in this case since the PHY + * ID is unknown at this point anyway. */ ret_val = phy->ops.acquire(hw); if (ret_val) @@ -1744,7 +1744,7 @@ out: * The automatic gain control (agc) normalizes the amplitude of the * received signal, adjusting for the attenuation produced by the * cable. By reading the AGC registers, which represent the - * combination of course and fine gain value, the value can be put + * combination of coarse and fine gain value, the value can be put * into a lookup table to obtain the approximate cable length * for each channel. **/ @@ -1769,7 +1769,7 @@ s32 e1000e_get_cable_length_igp_2(struct e1000_hw *hw) /* * Getting bits 15:9, which represent the combination of - * course and fine gain values. The result is a number + * coarse and fine gain values. The result is a number * that can be put into the lookup table to obtain the * approximate cable length. */ @@ -2511,7 +2511,7 @@ static s32 e1000_access_phy_wakeup_reg_bm(struct e1000_hw *hw, u32 offset, ret_val = e1000e_read_phy_reg_mdic(hw, BM_WUC_DATA_OPCODE, data); } else { - /* Read the page 800 value using opcode 0x12 */ + /* Write the page 800 value using opcode 0x12 */ ret_val = e1000e_write_phy_reg_mdic(hw, BM_WUC_DATA_OPCODE, *data); } |