net: fec: move fec_enet_private to header file

A new file fec_ptp.c will use fec_enet_private to support 1588 PTP
move such structure to common header file fec.h

Signed-off-by: Frank Li <Frank.Li@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 81 insertions, 0 deletions

diff --git a/drivers/net/ethernet/freescale/fec.h b/drivers/net/ethernet/freescale/fec.h
index 8408c627b19..e803812975d 100644
--- a/drivers/net/ethernet/freescale/fec.h
+++ b/drivers/net/ethernet/freescale/fec.h
@@ -147,6 +147,87 @@ struct bufdesc {
 #define BD_ENET_TX_CSL          ((ushort)0x0001)
 #define BD_ENET_TX_STATS        ((ushort)0x03ff)        /* All status bits */
 
+/*enhanced buffer desciptor control/status used by Ethernet transmit*/
+#define BD_ENET_TX_INT          0x40000000
+#define BD_ENET_TX_TS           0x20000000
+
+
+/* This device has up to three irqs on some platforms */
+#define FEC_IRQ_NUM		3
+
+/* The number of Tx and Rx buffers.  These are allocated from the page
+ * pool.  The code may assume these are power of two, so it it best
+ * to keep them that size.
+ * We don't need to allocate pages for the transmitter.  We just use
+ * the skbuffer directly.
+ */
+
+#define FEC_ENET_RX_PAGES	8
+#define FEC_ENET_RX_FRSIZE	2048
+#define FEC_ENET_RX_FRPPG	(PAGE_SIZE / FEC_ENET_RX_FRSIZE)
+#define RX_RING_SIZE		(FEC_ENET_RX_FRPPG * FEC_ENET_RX_PAGES)
+#define FEC_ENET_TX_FRSIZE	2048
+#define FEC_ENET_TX_FRPPG	(PAGE_SIZE / FEC_ENET_TX_FRSIZE)
+#define TX_RING_SIZE		16	/* Must be power of two */
+#define TX_RING_MOD_MASK	15	/*   for this to work */
+
+#define BD_ENET_RX_INT          0x00800000
+#define BD_ENET_RX_PTP          ((ushort)0x0400)
+
+/* The FEC buffer descriptors track the ring buffers.  The rx_bd_base and
+ * tx_bd_base always point to the base of the buffer descriptors.  The
+ * cur_rx and cur_tx point to the currently available buffer.
+ * The dirty_tx tracks the current buffer that is being sent by the
+ * controller.  The cur_tx and dirty_tx are equal under both completely
+ * empty and completely full conditions.  The empty/ready indicator in
+ * the buffer descriptor determines the actual condition.
+ */
+struct fec_enet_private {
+	/* Hardware registers of the FEC device */
+	void __iomem *hwp;
+
+	struct net_device *netdev;
+
+	struct clk *clk_ipg;
+	struct clk *clk_ahb;
+
+	/* The saved address of a sent-in-place packet/buffer, for skfree(). */
+	unsigned char *tx_bounce[TX_RING_SIZE];
+	struct	sk_buff *tx_skbuff[TX_RING_SIZE];
+	struct	sk_buff *rx_skbuff[RX_RING_SIZE];
+	ushort	skb_cur;
+	ushort	skb_dirty;
+
+	/* CPM dual port RAM relative addresses */
+	dma_addr_t	bd_dma;
+	/* Address of Rx and Tx buffers */
+	struct bufdesc	*rx_bd_base;
+	struct bufdesc	*tx_bd_base;
+	/* The next free ring entry */
+	struct bufdesc	*cur_rx, *cur_tx;
+	/* The ring entries to be free()ed */
+	struct bufdesc	*dirty_tx;
+
+	uint	tx_full;
+	/* hold while accessing the HW like ringbuffer for tx/rx but not MAC */
+	spinlock_t hw_lock;
+
+	struct	platform_device *pdev;
+
+	int	opened;
+	int	dev_id;
+
+	/* Phylib and MDIO interface */
+	struct	mii_bus *mii_bus;
+	struct	phy_device *phy_dev;
+	int	mii_timeout;
+	uint	phy_speed;
+	phy_interface_t	phy_interface;
+	int	link;
+	int	full_duplex;
+	struct	completion mdio_done;
+	int	irq[FEC_IRQ_NUM];
+};
 
 /****************************************************************************/
 #endif /* FEC_H */