gianfar: Fix RXICr/TXICr programming for multi-queue mode

The correct behavior is to program the interrupt coalescing regs
(RXICr/TXICr) in accordance with the Rx/Tx Q's "rx/txcoalescing"
flag. That is, if the coalescing flag is 0 for a given Rx/Tx queue
then the corresponding coalescing register should be cleared.
This behavior is correctly implemented for the single-queue mode
(SQ_SG_MODE), but not for the multi-queue mode (MQ_MG_MODE).
This fixes the later case.

Signed-off-by: Claudiu Manoil <claudiu.manoil@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 4 insertions, 6 deletions

diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c
index 0741aded9eb..f2db8fca46a 100644
--- a/drivers/net/ethernet/freescale/gianfar.c
+++ b/drivers/net/ethernet/freescale/gianfar.c
@@ -1804,18 +1804,16 @@ void gfar_configure_coalescing(struct gfar_private *priv,
 	if (priv->mode == MQ_MG_MODE) {
 		baddr = &regs->txic0;
 		for_each_set_bit(i, &tx_mask, priv->num_tx_queues) {
-			if (likely(priv->tx_queue[i]->txcoalescing)) {
-				gfar_write(baddr + i, 0);
+			gfar_write(baddr + i, 0);
+			if (likely(priv->tx_queue[i]->txcoalescing))
 				gfar_write(baddr + i, priv->tx_queue[i]->txic);
-			}
 		}
 
 		baddr = &regs->rxic0;
 		for_each_set_bit(i, &rx_mask, priv->num_rx_queues) {
-			if (likely(priv->rx_queue[i]->rxcoalescing)) {
-				gfar_write(baddr + i, 0);
+			gfar_write(baddr + i, 0);
+			if (likely(priv->rx_queue[i]->rxcoalescing))
 				gfar_write(baddr + i, priv->rx_queue[i]->rxic);
-			}
 		}
 	}
 }