[netdrvr] trim trailing whitespace: 8139*.c, epic100, forcedeth, tulip/*

1 files changed, 13 insertions, 13 deletions

diff --git a/drivers/net/tulip/winbond-840.c b/drivers/net/tulip/winbond-840.c
index 136a70c4d5e..64ecf929d2a 100644
--- a/drivers/net/tulip/winbond-840.c
+++ b/drivers/net/tulip/winbond-840.c
@@ -38,12 +38,12 @@
 			Copyright (C) 2001 Manfred Spraul
   	* ethtool support (jgarzik)
 	* Replace some MII-related magic numbers with constants (jgarzik)
-  
+
 	TODO:
 	* enable pci_power_off
 	* Wake-On-LAN
 */
-  
+
 #define DRV_NAME	"winbond-840"
 #define DRV_VERSION	"1.01-d"
 #define DRV_RELDATE	"Nov-17-2001"
@@ -57,7 +57,7 @@ c-help-name: Winbond W89c840 PCI Ethernet support
 c-help-symbol: CONFIG_WINBOND_840
 c-help: This driver is for the Winbond W89c840 chip.  It also works with
 c-help: the TX9882 chip on the Compex RL100-ATX board.
-c-help: More specific information and updates are available from 
+c-help: More specific information and updates are available from
 c-help: http://www.scyld.com/network/drivers.html
 */
 
@@ -207,7 +207,7 @@ Test with 'ping -s 10000' on a fast computer.
 
 */
 
-
+
 
 /*
   PCI probe table.
@@ -374,7 +374,7 @@ static int netdev_ioctl(struct net_device *dev, struct ifreq *rq, int cmd);
 static struct ethtool_ops netdev_ethtool_ops;
 static int  netdev_close(struct net_device *dev);
 
-
+
 
 static int __devinit w840_probe1 (struct pci_dev *pdev,
 				  const struct pci_device_id *ent)
@@ -434,7 +434,7 @@ static int __devinit w840_probe1 (struct pci_dev *pdev,
 	np->mii_if.mdio_read = mdio_read;
 	np->mii_if.mdio_write = mdio_write;
 	np->base_addr = ioaddr;
-	
+
 	pci_set_drvdata(pdev, dev);
 
 	if (dev->mem_start)
@@ -510,7 +510,7 @@ err_out_netdev:
 	return -ENODEV;
 }
 
-
+
 /* Read the EEPROM and MII Management Data I/O (MDIO) interfaces.  These are
    often serial bit streams generated by the host processor.
    The example below is for the common 93c46 EEPROM, 64 16 bit words. */
@@ -660,7 +660,7 @@ static void mdio_write(struct net_device *dev, int phy_id, int location, int val
 	return;
 }
 
-
+
 static int netdev_open(struct net_device *dev)
 {
 	struct netdev_private *np = netdev_priv(dev);
@@ -731,7 +731,7 @@ static int update_link(struct net_device *dev)
 				dev->name, np->phys[0]);
 		netif_carrier_on(dev);
 	}
-	
+
 	if ((np->mii & ~0xf) == MII_DAVICOM_DM9101) {
 		/* If the link partner doesn't support autonegotiation
 		 * the MII detects it's abilities with the "parallel detection".
@@ -761,7 +761,7 @@ static int update_link(struct net_device *dev)
 		result |= 0x20000000;
 	if (result != np->csr6 && debug)
 		printk(KERN_INFO "%s: Setting %dMBit-%s-duplex based on MII#%d\n",
-				 dev->name, fasteth ? 100 : 10, 
+				 dev->name, fasteth ? 100 : 10,
 			   	duplex ? "full" : "half", np->phys[0]);
 	return result;
 }
@@ -947,7 +947,7 @@ static void init_registers(struct net_device *dev)
 	iowrite32(i, ioaddr + PCIBusCfg);
 
 	np->csr6 = 0;
-	/* 128 byte Tx threshold; 
+	/* 128 byte Tx threshold;
 		Transmit on; Receive on; */
 	update_csr6(dev, 0x00022002 | update_link(dev) | __set_rx_mode(dev));
 
@@ -1584,7 +1584,7 @@ static int netdev_close(struct net_device *dev)
 static void __devexit w840_remove1 (struct pci_dev *pdev)
 {
 	struct net_device *dev = pci_get_drvdata(pdev);
-	
+
 	if (dev) {
 		struct netdev_private *np = netdev_priv(dev);
 		unregister_netdev(dev);
@@ -1640,7 +1640,7 @@ static int w840_suspend (struct pci_dev *pdev, pm_message_t state)
 
 		spin_unlock_wait(&dev->xmit_lock);
 		synchronize_irq(dev->irq);
-	
+
 		np->stats.rx_missed_errors += ioread32(ioaddr + RxMissed) & 0xffff;
 
 		/* no more hardware accesses behind this line. */