Merge branch 'next' into for-linus

1 files changed, 3 insertions, 15 deletions

diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index a4c086f069b..e63b7c40d0e 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -1903,17 +1903,6 @@ accept:
 		rxs->noise = sc->ah->ah_noise_floor;
 		rxs->signal = rxs->noise + rs.rs_rssi;
 
-		/* An rssi of 35 indicates you should be able use
-		 * 54 Mbps reliably. A more elaborate scheme can be used
-		 * here but it requires a map of SNR/throughput for each
-		 * possible mode used */
-		rxs->qual = rs.rs_rssi * 100 / 35;
-
-		/* rssi can be more than 35 though, anything above that
-		 * should be considered at 100% */
-		if (rxs->qual > 100)
-			rxs->qual = 100;
-
 		rxs->antenna = rs.rs_antenna;
 		rxs->rate_idx = ath5k_hw_to_driver_rix(sc, rs.rs_rate);
 		rxs->flag |= ath5k_rx_decrypted(sc, ds, skb, &rs);
@@ -2381,6 +2370,9 @@ ath5k_init(struct ath5k_softc *sc)
 	 */
 	ath5k_stop_locked(sc);
 
+	/* Set PHY calibration interval */
+	ah->ah_cal_intval = ath5k_calinterval;
+
 	/*
 	 * The basic interface to setting the hardware in a good
 	 * state is ``reset''.  On return the hardware is known to
@@ -2408,10 +2400,6 @@ ath5k_init(struct ath5k_softc *sc)
 
 	/* Set ack to be sent at low bit-rates */
 	ath5k_hw_set_ack_bitrate_high(ah, false);
-
-	/* Set PHY calibration inteval */
-	ah->ah_cal_intval = ath5k_calinterval;
-
 	ret = 0;
 done:
 	mmiowb();