USB: xhci: Performance - move interrupt handlers into xhci-ring.c

Most of the work for interrupt handling is done in xhci-ring.c, so it makes
sense to move the functions that are first called when an interrupt happens
(xhci_irq() or xhci_msi_irq()) into xhci-ring.c, so that the compiler can better
optimize them.

Shorten some lines to make it pass checkpatch.

Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

1 files changed, 0 insertions, 103 deletions

diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index f5e0b00cbb8..d5c550ea3e6 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -172,17 +172,6 @@ int xhci_reset(struct xhci_hcd *xhci)
 	return handshake(xhci, &xhci->op_regs->status, STS_CNR, 0, 250 * 1000);
 }
 
-static irqreturn_t xhci_msi_irq(int irq, struct usb_hcd *hcd)
-{
-	irqreturn_t ret;
-
-	set_bit(HCD_FLAG_SAW_IRQ, &hcd->flags);
-
-	ret = xhci_irq(hcd);
-
-	return ret;
-}
-
 /*
  * Free IRQs
  * free all IRQs request
@@ -332,100 +321,8 @@ int xhci_init(struct usb_hcd *hcd)
 	return retval;
 }
 
-/*
- * Called in interrupt context when there might be work
- * queued on the event ring
- *
- * xhci->lock must be held by caller.
- */
-static void xhci_work(struct xhci_hcd *xhci)
-{
-	u32 temp;
-	u64 temp_64;
-
-	/*
-	 * Clear the op reg interrupt status first,
-	 * so we can receive interrupts from other MSI-X interrupters.
-	 * Write 1 to clear the interrupt status.
-	 */
-	temp = xhci_readl(xhci, &xhci->op_regs->status);
-	temp |= STS_EINT;
-	xhci_writel(xhci, temp, &xhci->op_regs->status);
-	/* FIXME when MSI-X is supported and there are multiple vectors */
-	/* Clear the MSI-X event interrupt status */
-
-	/* Acknowledge the interrupt */
-	temp = xhci_readl(xhci, &xhci->ir_set->irq_pending);
-	temp |= 0x3;
-	xhci_writel(xhci, temp, &xhci->ir_set->irq_pending);
-	/* Flush posted writes */
-	xhci_readl(xhci, &xhci->ir_set->irq_pending);
-
-	if (xhci->xhc_state & XHCI_STATE_DYING)
-		xhci_dbg(xhci, "xHCI dying, ignoring interrupt. "
-				"Shouldn't IRQs be disabled?\n");
-	else
-		/* FIXME this should be a delayed service routine
-		 * that clears the EHB.
-		 */
-		xhci_handle_event(xhci);
-
-	/* Clear the event handler busy flag (RW1C); the event ring should be empty. */
-	temp_64 = xhci_read_64(xhci, &xhci->ir_set->erst_dequeue);
-	xhci_write_64(xhci, temp_64 | ERST_EHB, &xhci->ir_set->erst_dequeue);
-	/* Flush posted writes -- FIXME is this necessary? */
-	xhci_readl(xhci, &xhci->ir_set->irq_pending);
-}
-
 /*-------------------------------------------------------------------------*/
 
-/*
- * xHCI spec says we can get an interrupt, and if the HC has an error condition,
- * we might get bad data out of the event ring.  Section 4.10.2.7 has a list of
- * indicators of an event TRB error, but we check the status *first* to be safe.
- */
-irqreturn_t xhci_irq(struct usb_hcd *hcd)
-{
-	struct xhci_hcd *xhci = hcd_to_xhci(hcd);
-	u32 temp, temp2;
-	union xhci_trb *trb;
-
-	spin_lock(&xhci->lock);
-	trb = xhci->event_ring->dequeue;
-	/* Check if the xHC generated the interrupt, or the irq is shared */
-	temp = xhci_readl(xhci, &xhci->op_regs->status);
-	temp2 = xhci_readl(xhci, &xhci->ir_set->irq_pending);
-	if (temp == 0xffffffff && temp2 == 0xffffffff)
-		goto hw_died;
-
-	if (!(temp & STS_EINT) && !ER_IRQ_PENDING(temp2)) {
-		spin_unlock(&xhci->lock);
-		return IRQ_NONE;
-	}
-	xhci_dbg(xhci, "op reg status = %08x\n", temp);
-	xhci_dbg(xhci, "ir set irq_pending = %08x\n", temp2);
-	xhci_dbg(xhci, "Event ring dequeue ptr:\n");
-	xhci_dbg(xhci, "@%llx %08x %08x %08x %08x\n",
-			(unsigned long long)xhci_trb_virt_to_dma(xhci->event_ring->deq_seg, trb),
-			lower_32_bits(trb->link.segment_ptr),
-			upper_32_bits(trb->link.segment_ptr),
-			(unsigned int) trb->link.intr_target,
-			(unsigned int) trb->link.control);
-
-	if (temp & STS_FATAL) {
-		xhci_warn(xhci, "WARNING: Host System Error\n");
-		xhci_halt(xhci);
-hw_died:
-		xhci_to_hcd(xhci)->state = HC_STATE_HALT;
-		spin_unlock(&xhci->lock);
-		return -ESHUTDOWN;
-	}
-
-	xhci_work(xhci);
-	spin_unlock(&xhci->lock);
-
-	return IRQ_HANDLED;
-}
 
 #ifdef CONFIG_USB_XHCI_HCD_DEBUGGING
 void xhci_event_ring_work(unsigned long arg)