Merge tag 'for-usb-next-2012-09-13' of git://git.kernel.org/pub/scm/linux/kernel/git/sarah/xhci into usb-next

xHCI patches for 3.7

Hi Greg,

Here's seven patches for 3.7.

The first four fix an issue with Set Address command timeouts.  It turns out
that Set Address timeouts can trigger a warning that was put in to avoid a NULL
pointer dereference.  This patchset fixes the underlying cause of the NULL
pointer that was papered over by the warning.  They should be applied to stable,
but I'm a bit nervous about the size, so I'd rather they go into 3.7, rather
than trying to stuff them into a late 3.6-rc.

The other three patches are various trivial fixes.

Sarah Sharp

1 files changed, 27 insertions, 12 deletions

diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index c59d5b5b6c7..66bc5c3985f 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -51,7 +51,7 @@ MODULE_PARM_DESC(link_quirk, "Don't clear the chain bit on a link TRB");
  * handshake done).  There are two failure modes:  "usec" have passed (major
  * hardware flakeout), or the register reads as all-ones (hardware removed).
  */
-static int handshake(struct xhci_hcd *xhci, void __iomem *ptr,
+int handshake(struct xhci_hcd *xhci, void __iomem *ptr,
 		      u32 mask, u32 done, int usec)
 {
 	u32	result;
@@ -104,9 +104,10 @@ int xhci_halt(struct xhci_hcd *xhci)
 
 	ret = handshake(xhci, &xhci->op_regs->status,
 			STS_HALT, STS_HALT, XHCI_MAX_HALT_USEC);
-	if (!ret)
+	if (!ret) {
 		xhci->xhc_state |= XHCI_STATE_HALTED;
-	else
+		xhci->cmd_ring_state = CMD_RING_STATE_STOPPED;
+	} else
 		xhci_warn(xhci, "Host not halted after %u microseconds.\n",
 				XHCI_MAX_HALT_USEC);
 	return ret;
@@ -485,6 +486,7 @@ static int xhci_run_finished(struct xhci_hcd *xhci)
 		return -ENODEV;
 	}
 	xhci->shared_hcd->state = HC_STATE_RUNNING;
+	xhci->cmd_ring_state = CMD_RING_STATE_RUNNING;
 
 	if (xhci->quirks & XHCI_NEC_HOST)
 		xhci_ring_cmd_db(xhci);
@@ -1827,7 +1829,7 @@ static void xhci_finish_resource_reservation(struct xhci_hcd *xhci,
 				xhci->num_active_eps);
 }
 
-unsigned int xhci_get_block_size(struct usb_device *udev)
+static unsigned int xhci_get_block_size(struct usb_device *udev)
 {
 	switch (udev->speed) {
 	case USB_SPEED_LOW:
@@ -1845,7 +1847,8 @@ unsigned int xhci_get_block_size(struct usb_device *udev)
 	}
 }
 
-unsigned int xhci_get_largest_overhead(struct xhci_interval_bw *interval_bw)
+static unsigned int
+xhci_get_largest_overhead(struct xhci_interval_bw *interval_bw)
 {
 	if (interval_bw->overhead[LS_OVERHEAD_TYPE])
 		return LS_OVERHEAD;
@@ -2400,6 +2403,7 @@ static int xhci_configure_endpoint(struct xhci_hcd *xhci,
 	struct completion *cmd_completion;
 	u32 *cmd_status;
 	struct xhci_virt_device *virt_dev;
+	union xhci_trb *cmd_trb;
 
 	spin_lock_irqsave(&xhci->lock, flags);
 	virt_dev = xhci->devs[udev->slot_id];
@@ -2445,6 +2449,7 @@ static int xhci_configure_endpoint(struct xhci_hcd *xhci,
 	}
 	init_completion(cmd_completion);
 
+	cmd_trb = xhci->cmd_ring->dequeue;
 	if (!ctx_change)
 		ret = xhci_queue_configure_endpoint(xhci, in_ctx->dma,
 				udev->slot_id, must_succeed);
@@ -2466,14 +2471,17 @@ static int xhci_configure_endpoint(struct xhci_hcd *xhci,
 	/* Wait for the configure endpoint command to complete */
 	timeleft = wait_for_completion_interruptible_timeout(
 			cmd_completion,
-			USB_CTRL_SET_TIMEOUT);
+			XHCI_CMD_DEFAULT_TIMEOUT);
 	if (timeleft <= 0) {
 		xhci_warn(xhci, "%s while waiting for %s command\n",
 				timeleft == 0 ? "Timeout" : "Signal",
 				ctx_change == 0 ?
 					"configure endpoint" :
 					"evaluate context");
-		/* FIXME cancel the configure endpoint command */
+		/* cancel the configure endpoint command */
+		ret = xhci_cancel_cmd(xhci, command, cmd_trb);
+		if (ret < 0)
+			return ret;
 		return -ETIME;
 	}
 
@@ -3422,8 +3430,10 @@ int xhci_alloc_dev(struct usb_hcd *hcd, struct usb_device *udev)
 	unsigned long flags;
 	int timeleft;
 	int ret;
+	union xhci_trb *cmd_trb;
 
 	spin_lock_irqsave(&xhci->lock, flags);
+	cmd_trb = xhci->cmd_ring->dequeue;
 	ret = xhci_queue_slot_control(xhci, TRB_ENABLE_SLOT, 0);
 	if (ret) {
 		spin_unlock_irqrestore(&xhci->lock, flags);
@@ -3435,12 +3445,12 @@ int xhci_alloc_dev(struct usb_hcd *hcd, struct usb_device *udev)
 
 	/* XXX: how much time for xHC slot assignment? */
 	timeleft = wait_for_completion_interruptible_timeout(&xhci->addr_dev,
-			USB_CTRL_SET_TIMEOUT);
+			XHCI_CMD_DEFAULT_TIMEOUT);
 	if (timeleft <= 0) {
 		xhci_warn(xhci, "%s while waiting for a slot\n",
 				timeleft == 0 ? "Timeout" : "Signal");
-		/* FIXME cancel the enable slot request */
-		return 0;
+		/* cancel the enable slot request */
+		return xhci_cancel_cmd(xhci, NULL, cmd_trb);
 	}
 
 	if (!xhci->slot_id) {
@@ -3501,6 +3511,7 @@ int xhci_address_device(struct usb_hcd *hcd, struct usb_device *udev)
 	struct xhci_slot_ctx *slot_ctx;
 	struct xhci_input_control_ctx *ctrl_ctx;
 	u64 temp_64;
+	union xhci_trb *cmd_trb;
 
 	if (!udev->slot_id) {
 		xhci_dbg(xhci, "Bad Slot ID %d\n", udev->slot_id);
@@ -3539,6 +3550,7 @@ int xhci_address_device(struct usb_hcd *hcd, struct usb_device *udev)
 	xhci_dbg_ctx(xhci, virt_dev->in_ctx, 2);
 
 	spin_lock_irqsave(&xhci->lock, flags);
+	cmd_trb = xhci->cmd_ring->dequeue;
 	ret = xhci_queue_address_device(xhci, virt_dev->in_ctx->dma,
 					udev->slot_id);
 	if (ret) {
@@ -3551,7 +3563,7 @@ int xhci_address_device(struct usb_hcd *hcd, struct usb_device *udev)
 
 	/* ctrl tx can take up to 5 sec; XXX: need more time for xHC? */
 	timeleft = wait_for_completion_interruptible_timeout(&xhci->addr_dev,
-			USB_CTRL_SET_TIMEOUT);
+			XHCI_CMD_DEFAULT_TIMEOUT);
 	/* FIXME: From section 4.3.4: "Software shall be responsible for timing
 	 * the SetAddress() "recovery interval" required by USB and aborting the
 	 * command on a timeout.
@@ -3559,7 +3571,10 @@ int xhci_address_device(struct usb_hcd *hcd, struct usb_device *udev)
 	if (timeleft <= 0) {
 		xhci_warn(xhci, "%s while waiting for address device command\n",
 				timeleft == 0 ? "Timeout" : "Signal");
-		/* FIXME cancel the address device command */
+		/* cancel the address device command */
+		ret = xhci_cancel_cmd(xhci, NULL, cmd_trb);
+		if (ret < 0)
+			return ret;
 		return -ETIME;
 	}