writeback: balance_dirty_pages(): reduce calls to global_page_state

Reducing the number of times balance_dirty_pages calls global_page_state
reduces the cache references and so improves write performance on a
variety of workloads.

'perf stats' of simple fio write tests shows the reduction in cache
access.  Where the test is fio 'write,mmap,600Mb,pre_read' on AMD AthlonX2
with 3Gb memory (dirty_threshold approx 600 Mb) running each test 10
times, dropping the fasted & slowest values then taking the average &
standard deviation

		average (s.d.) in millions (10^6)
2.6.31-rc8	648.6 (14.6)
+patch		620.1 (16.5)

Achieving this reduction is by dropping clip_bdi_dirty_limit as it rereads
the counters to apply the dirty_threshold and moving this check up into
balance_dirty_pages where it has already read the counters.

Also by rearrange the for loop to only contain one copy of the limit tests
allows the pdflush test after the loop to use the local copies of the
counters rather than rereading them.

In the common case with no throttling it now calls global_page_state 5
fewer times and bdi_stat 2 fewer.

Fengguang:

This patch slightly changes behavior by replacing clip_bdi_dirty_limit()
with the explicit check (nr_reclaimable + nr_writeback >= dirty_thresh) to
avoid exceeding the dirty limit.  Since the bdi dirty limit is mostly
accurate we don't need to do routinely clip.  A simple dirty limit check
would be enough.

The check is necessary because, in principle we should throttle everything
calling balance_dirty_pages() when we're over the total limit, as said by
Peter.

We now set and clear dirty_exceeded not only based on bdi dirty limits,
but also on the global dirty limit.  The global limit check is added in
place of clip_bdi_dirty_limit() for safety and not intended as a behavior
change.  The bdi limits should be tight enough to keep all dirty pages
under the global limit at most time; occasional small exceeding should be
OK though.  The change makes the logic more obvious: the global limit is
the ultimate goal and shall be always imposed.

We may now start background writeback work based on outdated conditions.
That's safe because the bdi flush thread will (and have to) double check
the states.  It reduces overall overheads because the test based on old
states still have good chance to be right.

[akpm@linux-foundation.org] fix uninitialized dirty_exceeded
Signed-off-by: Richard Kennedy <richard@rsk.demon.co.uk>
Signed-off-by: Wu Fengguang <fengguang.wu@intel.com>
Cc: Jan Kara <jack@suse.cz>
Acked-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
Cc: Christoph Hellwig <hch@infradead.org>
Cc: Dave Chinner <david@fromorbit.com>
Cc: Jens Axboe <axboe@kernel.dk>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

0 files changed, 0 insertions, 0 deletions