[SPARC64]: Do proper DMA IRQ syncing on Tomatillo

This was the main impetus behind adding the PCI IRQ shim.

In order to properly order DMA writes wrt. interrupts, you have to
write to a PCI controller register, then poll for that bit clearing.
There is one bit for each interrupt source, and setting this register
bit tells Tomatillo to drain all pending DMA from that device.

Furthermore, Tomatillo's with revision less than 4 require us to do a
block store due to some memory transaction ordering issues it has on
JBUS.

Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 3 insertions, 0 deletions

diff --git a/include/asm-sparc64/pbm.h b/include/asm-sparc64/pbm.h
index 4c15610a2ba..38bbbccb406 100644
--- a/include/asm-sparc64/pbm.h
+++ b/include/asm-sparc64/pbm.h
@@ -145,6 +145,9 @@ struct pci_pbm_info {
 	/* Physical address base of PBM registers. */
 	unsigned long			pbm_regs;
 
+	/* Physical address of DMA sync register, if any.  */
+	unsigned long			sync_reg;
+
 	/* Opaque 32-bit system bus Port ID. */
 	u32				portid;