ath9k: Use a separate TX gain table for WZR-HP-G450H

The Buffalo device WZR-HP-G450H uses the index 3 for TX gain,
which is set to the high_power table currently. Later variants
of the router use the same index, but instead refer to the
low_ob_db gain table. This is not handled in the driver since
there is no way to distinguish board revisions and the high_power
table is used (incorrectly) for the newer variants.

By default, devices based on AR9300 using the TX gain index 3 have
to use the high_power table. To make sure that WZR-HP-G450H is not
broken when the high_power table is updated, use a separate array
based on information obtained from the platform data.

The current situation where only the original variant of WZR-HP-G450H
works properly stays unchanged.

Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 2 insertions, 0 deletions

diff --git a/include/linux/ath9k_platform.h b/include/linux/ath9k_platform.h
index fcdd81bd531..8598f8eacb2 100644
--- a/include/linux/ath9k_platform.h
+++ b/include/linux/ath9k_platform.h
@@ -32,6 +32,8 @@ struct ath9k_platform_data {
 	u32 gpio_val;
 
 	bool is_clk_25mhz;
+	bool tx_gain_buffalo;
+
 	int (*get_mac_revision)(void);
 	int (*external_reset)(void);
 };