cfg80211/mac80211: add mesh join/leave commands

Instead of tying mesh activity to interface up,
add join and leave commands for mesh. Since we
must be backward compatible, let cfg80211 handle
joining a mesh if a mesh ID was pre-configured
when the device goes up.

Note that this therefore must modify mac80211 as
well since mac80211 needs to lose the logic to
start the mesh on interface up.

We now allow querying mesh parameters before the
mesh is connected, which simply returns defaults.
Setting them (internally renamed to "update") is
only allowed while connected. Specify them with
the new mesh join command instead where needed.

In mac80211, beaconing must now also follow the
mesh enabled/not enabled state, which is done
by testing the mesh ID.

Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 8 insertions, 0 deletions

diff --git a/include/linux/nl80211.h b/include/linux/nl80211.h
index 9e541452d80..410a06ea551 100644
--- a/include/linux/nl80211.h
+++ b/include/linux/nl80211.h
@@ -394,6 +394,11 @@
  *
  * @NL80211_CMD_SET_WDS_PEER: Set the MAC address of the peer on a WDS interface.
  *
+ * @NL80211_CMD_JOIN_MESH: Join a mesh. The mesh ID must be given, and initial
+ *	mesh config parameters may be given.
+ * @NL80211_CMD_LEAVE_MESH: Leave the mesh network -- no special arguments, the
+ *	network is determined by the network interface.
+ *
  * @NL80211_CMD_MAX: highest used command number
  * @__NL80211_CMD_AFTER_LAST: internal use
  */
@@ -500,6 +505,9 @@ enum nl80211_commands {
 
 	NL80211_CMD_FRAME_WAIT_CANCEL,
 
+	NL80211_CMD_JOIN_MESH,
+	NL80211_CMD_LEAVE_MESH,
+
 	/* add new commands above here */
 
 	/* used to define NL80211_CMD_MAX below */