dmaengine: Add slave DMA interface

This patch adds the necessary interfaces to the DMA Engine framework
to use functionality found on most embedded DMA controllers: DMA from
and to I/O registers with hardware handshaking.

In this context, hardware hanshaking means that the peripheral that
owns the I/O registers in question is able to tell the DMA controller
when more data is available for reading, or when there is room for
more data to be written. This usually happens internally on the chip,
but these signals may also be exported outside the chip for things
like IDE DMA, etc.

A new struct dma_slave is introduced. This contains information that
the DMA engine driver needs to set up slave transfers to and from a
slave device. Most engines supporting DMA slave transfers will want to
extend this structure with controller-specific parameters.  This
additional information is usually passed from the platform/board code
through the client driver.

A "slave" pointer is added to the dma_client struct. This must point
to a valid dma_slave structure iff the DMA_SLAVE capability is
requested.  The DMA engine driver may use this information in its
device_alloc_chan_resources hook to configure the DMA controller for
slave transfers from and to the given slave device.

A new operation for preparing slave DMA transfers is added to struct
dma_device. This takes a scatterlist and returns a single descriptor
representing the whole transfer.

Another new operation for terminating all pending transfers is added as
well. The latter is needed because there may be errors outside the scope
of the DMA Engine framework that may require DMA operations to be
terminated prematurely.

DMA Engine drivers may extend the dma_device, dma_chan and/or
dma_slave_descriptor structures to allow controller-specific
operations. The client driver can detect such extensions by looking at
the DMA Engine's struct device, or it can request a specific DMA
Engine device by setting the dma_dev field in struct dma_slave.

dmaslave interface changes since v4:
  * Fix checkpatch errors
  * Fix changelog (there are no slave descriptors anymore)

dmaslave interface changes since v3:
  * Use dma_data_direction instead of a new enum
  * Submit slave transfers as scatterlists
  * Remove the DMA slave descriptor struct

dmaslave interface changes since v2:
  * Add a dma_dev field to struct dma_slave. If set, the client can
    only be bound to the DMA controller that corresponds to this
    device.  This allows controller-specific extensions of the
    dma_slave structure; if the device matches, the controller may
    safely assume its extensions are present.
  * Move reg_width into struct dma_slave as there are currently no
    users that need to be able to set the width on a per-transfer
    basis.

dmaslave interface changes since v1:
  * Drop the set_direction and set_width descriptor hooks. Pass the
    direction and width to the prep function instead.
  * Declare a dma_slave struct with fixed information about a slave,
    i.e. register addresses, handshake interfaces and such.
  * Add pointer to a dma_slave struct to dma_client. Can be NULL if
    the DMA_SLAVE capability isn't requested.
  * Drop the set_slave device hook since the alloc_chan_resources hook
    now has enough information to set up the channel for slave
    transfers.

Acked-by: Maciej Sosnowski <maciej.sosnowski@intel.com>
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>

1 files changed, 51 insertions, 1 deletions

diff --git a/include/linux/dmaengine.h b/include/linux/dmaengine.h
index b058d636038..9b91d341e1f 100644
--- a/include/linux/dmaengine.h
+++ b/include/linux/dmaengine.h
@@ -89,10 +89,23 @@ enum dma_transaction_type {
 	DMA_MEMSET,
 	DMA_MEMCPY_CRC32C,
 	DMA_INTERRUPT,
+	DMA_SLAVE,
 };
 
 /* last transaction type for creation of the capabilities mask */
-#define DMA_TX_TYPE_END (DMA_INTERRUPT + 1)
+#define DMA_TX_TYPE_END (DMA_SLAVE + 1)
+
+/**
+ * enum dma_slave_width - DMA slave register access width.
+ * @DMA_SLAVE_WIDTH_8BIT: Do 8-bit slave register accesses
+ * @DMA_SLAVE_WIDTH_16BIT: Do 16-bit slave register accesses
+ * @DMA_SLAVE_WIDTH_32BIT: Do 32-bit slave register accesses
+ */
+enum dma_slave_width {
+	DMA_SLAVE_WIDTH_8BIT,
+	DMA_SLAVE_WIDTH_16BIT,
+	DMA_SLAVE_WIDTH_32BIT,
+};
 
 /**
  * enum dma_ctrl_flags - DMA flags to augment operation preparation,
@@ -119,6 +132,32 @@ enum dma_ctrl_flags {
 typedef struct { DECLARE_BITMAP(bits, DMA_TX_TYPE_END); } dma_cap_mask_t;
 
 /**
+ * struct dma_slave - Information about a DMA slave
+ * @dev: device acting as DMA slave
+ * @dma_dev: required DMA master device. If non-NULL, the client can not be
+ *	bound to other masters than this.
+ * @tx_reg: physical address of data register used for
+ *	memory-to-peripheral transfers
+ * @rx_reg: physical address of data register used for
+ *	peripheral-to-memory transfers
+ * @reg_width: peripheral register width
+ *
+ * If dma_dev is non-NULL, the client can not be bound to other DMA
+ * masters than the one corresponding to this device. The DMA master
+ * driver may use this to determine if there is controller-specific
+ * data wrapped around this struct. Drivers of platform code that sets
+ * the dma_dev field must therefore make sure to use an appropriate
+ * controller-specific dma slave structure wrapping this struct.
+ */
+struct dma_slave {
+	struct device		*dev;
+	struct device		*dma_dev;
+	dma_addr_t		tx_reg;
+	dma_addr_t		rx_reg;
+	enum dma_slave_width	reg_width;
+};
+
+/**
  * struct dma_chan_percpu - the per-CPU part of struct dma_chan
  * @refcount: local_t used for open-coded "bigref" counting
  * @memcpy_count: transaction counter
@@ -208,11 +247,14 @@ typedef enum dma_state_client (*dma_event_callback) (struct dma_client *client,
  * @event_callback: func ptr to call when something happens
  * @cap_mask: only return channels that satisfy the requested capabilities
  *  a value of zero corresponds to any capability
+ * @slave: data for preparing slave transfer. Must be non-NULL iff the
+ *  DMA_SLAVE capability is requested.
  * @global_node: list_head for global dma_client_list
  */
 struct dma_client {
 	dma_event_callback	event_callback;
 	dma_cap_mask_t		cap_mask;
+	struct dma_slave	*slave;
 	struct list_head	global_node;
 };
 
@@ -269,6 +311,8 @@ struct dma_async_tx_descriptor {
  * @device_prep_dma_zero_sum: prepares a zero_sum operation
  * @device_prep_dma_memset: prepares a memset operation
  * @device_prep_dma_interrupt: prepares an end of chain interrupt operation
+ * @device_prep_slave_sg: prepares a slave dma operation
+ * @device_terminate_all: terminate all pending operations
  * @device_issue_pending: push pending transactions to hardware
  */
 struct dma_device {
@@ -304,6 +348,12 @@ struct dma_device {
 	struct dma_async_tx_descriptor *(*device_prep_dma_interrupt)(
 		struct dma_chan *chan, unsigned long flags);
 
+	struct dma_async_tx_descriptor *(*device_prep_slave_sg)(
+		struct dma_chan *chan, struct scatterlist *sgl,
+		unsigned int sg_len, enum dma_data_direction direction,
+		unsigned long flags);
+	void (*device_terminate_all)(struct dma_chan *chan);
+
 	enum dma_status (*device_is_tx_complete)(struct dma_chan *chan,
 			dma_cookie_t cookie, dma_cookie_t *last,
 			dma_cookie_t *used);