diff options
-rw-r--r-- | arch/avr32/boards/atngw100/mrmt.c | 1 | ||||
-rw-r--r-- | arch/avr32/boards/atngw100/setup.c | 5 | ||||
-rw-r--r-- | arch/avr32/kernel/vmlinux.lds.S | 64 | ||||
-rw-r--r-- | arch/avr32/mach-at32ap/at32ap700x.c | 35 | ||||
-rw-r--r-- | arch/avr32/mach-at32ap/include/mach/board.h | 1 |
5 files changed, 30 insertions, 76 deletions
diff --git a/arch/avr32/boards/atngw100/mrmt.c b/arch/avr32/boards/atngw100/mrmt.c index bf78e516a85..7919be311f4 100644 --- a/arch/avr32/boards/atngw100/mrmt.c +++ b/arch/avr32/boards/atngw100/mrmt.c @@ -302,6 +302,7 @@ static int __init mrmt1_init(void) at32_select_periph( GPIO_PIOB_BASE, 1 << (PB_EXTINT_BASE+TS_IRQ), GPIO_PERIPH_A, AT32_GPIOF_DEGLITCH); set_irq_type( AT32_EXTINT(TS_IRQ), IRQ_TYPE_EDGE_FALLING ); + at32_spi_setup_slaves(0,spi01_board_info,ARRAY_SIZE(spi01_board_info)); spi_register_board_info(spi01_board_info,ARRAY_SIZE(spi01_board_info)); #endif diff --git a/arch/avr32/boards/atngw100/setup.c b/arch/avr32/boards/atngw100/setup.c index bc299fbbeb4..5b022aad4bd 100644 --- a/arch/avr32/boards/atngw100/setup.c +++ b/arch/avr32/boards/atngw100/setup.c @@ -56,13 +56,8 @@ static struct spi_board_info spi0_board_info[] __initdata = { static struct mci_platform_data __initdata mci0_data = { .slot[0] = { .bus_width = 4, -#if defined(CONFIG_BOARD_ATNGW100_EVKLCD10X) || defined(CONFIG_BOARD_ATNGW100_MRMT1) - .detect_pin = GPIO_PIN_NONE, - .wp_pin = GPIO_PIN_NONE, -#else .detect_pin = GPIO_PIN_PC(25), .wp_pin = GPIO_PIN_PE(0), -#endif }, }; diff --git a/arch/avr32/kernel/vmlinux.lds.S b/arch/avr32/kernel/vmlinux.lds.S index c4b56654349..9cd2bd91d64 100644 --- a/arch/avr32/kernel/vmlinux.lds.S +++ b/arch/avr32/kernel/vmlinux.lds.S @@ -39,30 +39,10 @@ SECTIONS __tagtable_begin = .; *(.taglist.init) __tagtable_end = .; - INIT_DATA - . = ALIGN(16); - __setup_start = .; - *(.init.setup) - __setup_end = .; - . = ALIGN(4); - __initcall_start = .; - INITCALLS - __initcall_end = .; - __con_initcall_start = .; - *(.con_initcall.init) - __con_initcall_end = .; - __security_initcall_start = .; - *(.security_initcall.init) - __security_initcall_end = .; -#ifdef CONFIG_BLK_DEV_INITRD - . = ALIGN(32); - __initramfs_start = .; - *(.init.ramfs) - __initramfs_end = .; -#endif - . = ALIGN(PAGE_SIZE); - __init_end = .; } + INIT_DATA_SECTION(16) + . = ALIGN(PAGE_SIZE); + __init_end = .; .text : AT(ADDR(.text) - LOAD_OFFSET) { _evba = .; @@ -78,34 +58,16 @@ SECTIONS _etext = .; } = 0xd703d703 - . = ALIGN(4); - __ex_table : AT(ADDR(__ex_table) - LOAD_OFFSET) { - __start___ex_table = .; - *(__ex_table) - __stop___ex_table = .; - } - + EXCEPTION_TABLE(4) RODATA - . = ALIGN(THREAD_SIZE); - .data : AT(ADDR(.data) - LOAD_OFFSET) { _data = .; _sdata = .; - /* - * First, the init task union, aligned to an 8K boundary. - */ - *(.data.init_task) - /* Then, the page-aligned data */ - . = ALIGN(PAGE_SIZE); - *(.data.page_aligned) - - /* Then, the cacheline aligned data */ - . = ALIGN(L1_CACHE_BYTES); - *(.data.cacheline_aligned) - - /* And the rest... */ + INIT_TASK_DATA(THREAD_SIZE) + PAGE_ALIGNED_DATA(PAGE_SIZE); + CACHELINE_ALIGNED_DATA(L1_CACHE_BYTES) *(.data.rel*) DATA_DATA CONSTRUCTORS @@ -113,16 +75,8 @@ SECTIONS _edata = .; } - - . = ALIGN(8); - .bss : AT(ADDR(.bss) - LOAD_OFFSET) { - __bss_start = .; - *(.bss) - *(COMMON) - . = ALIGN(8); - __bss_stop = .; - _end = .; - } + BSS_SECTION(0, 8, 8) + _end = .; DWARF_DEBUG diff --git a/arch/avr32/mach-at32ap/at32ap700x.c b/arch/avr32/mach-at32ap/at32ap700x.c index eb9d4dc2e86..a47592e2fc3 100644 --- a/arch/avr32/mach-at32ap/at32ap700x.c +++ b/arch/avr32/mach-at32ap/at32ap700x.c @@ -1181,19 +1181,32 @@ static struct resource atmel_spi1_resource[] = { DEFINE_DEV(atmel_spi, 1); DEV_CLK(spi_clk, atmel_spi1, pba, 1); -static void __init -at32_spi_setup_slaves(unsigned int bus_num, struct spi_board_info *b, - unsigned int n, const u8 *pins) +void __init +at32_spi_setup_slaves(unsigned int bus_num, struct spi_board_info *b, unsigned int n) { + /* + * Manage the chipselects as GPIOs, normally using the same pins + * the SPI controller expects; but boards can use other pins. + */ + static u8 __initdata spi_pins[][4] = { + { GPIO_PIN_PA(3), GPIO_PIN_PA(4), + GPIO_PIN_PA(5), GPIO_PIN_PA(20) }, + { GPIO_PIN_PB(2), GPIO_PIN_PB(3), + GPIO_PIN_PB(4), GPIO_PIN_PA(27) }, + }; unsigned int pin, mode; + /* There are only 2 SPI controllers */ + if (bus_num > 1) + return; + for (; n; n--, b++) { b->bus_num = bus_num; if (b->chip_select >= 4) continue; pin = (unsigned)b->controller_data; if (!pin) { - pin = pins[b->chip_select]; + pin = spi_pins[bus_num][b->chip_select]; b->controller_data = (void *)pin; } mode = AT32_GPIOF_OUTPUT; @@ -1206,16 +1219,6 @@ at32_spi_setup_slaves(unsigned int bus_num, struct spi_board_info *b, struct platform_device *__init at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n) { - /* - * Manage the chipselects as GPIOs, normally using the same pins - * the SPI controller expects; but boards can use other pins. - */ - static u8 __initdata spi0_pins[] = - { GPIO_PIN_PA(3), GPIO_PIN_PA(4), - GPIO_PIN_PA(5), GPIO_PIN_PA(20), }; - static u8 __initdata spi1_pins[] = - { GPIO_PIN_PB(2), GPIO_PIN_PB(3), - GPIO_PIN_PB(4), GPIO_PIN_PA(27), }; struct platform_device *pdev; u32 pin_mask; @@ -1228,7 +1231,7 @@ at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n) select_peripheral(PIOA, (1 << 0), PERIPH_A, AT32_GPIOF_PULLUP); select_peripheral(PIOA, pin_mask, PERIPH_A, 0); - at32_spi_setup_slaves(0, b, n, spi0_pins); + at32_spi_setup_slaves(0, b, n); break; case 1: @@ -1239,7 +1242,7 @@ at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n) select_peripheral(PIOB, (1 << 0), PERIPH_B, AT32_GPIOF_PULLUP); select_peripheral(PIOB, pin_mask, PERIPH_B, 0); - at32_spi_setup_slaves(1, b, n, spi1_pins); + at32_spi_setup_slaves(1, b, n); break; default: diff --git a/arch/avr32/mach-at32ap/include/mach/board.h b/arch/avr32/mach-at32ap/include/mach/board.h index ddedb471f33..c7f25bb1d06 100644 --- a/arch/avr32/mach-at32ap/include/mach/board.h +++ b/arch/avr32/mach-at32ap/include/mach/board.h @@ -49,6 +49,7 @@ at32_add_device_eth(unsigned int id, struct eth_platform_data *data); struct spi_board_info; struct platform_device * at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n); +void at32_spi_setup_slaves(unsigned int bus_num, struct spi_board_info *b, unsigned int n); struct atmel_lcdfb_info; struct platform_device * |