diff options
| -rw-r--r-- | drivers/ata/libahci.c | 21 |
1 files changed, 0 insertions, 21 deletions
diff --git a/drivers/ata/libahci.c b/drivers/ata/libahci.c index ff9d832a163..d38c40fe4dd 100644 --- a/drivers/ata/libahci.c +++ b/drivers/ata/libahci.c @@ -561,27 +561,6 @@ void ahci_start_engine(struct ata_port *ap) { void __iomem *port_mmio = ahci_port_base(ap); u32 tmp; - u8 status; - - status = readl(port_mmio + PORT_TFDATA) & 0xFF; - - /* - * At end of section 10.1 of AHCI spec (rev 1.3), it states - * Software shall not set PxCMD.ST to 1 until it is determined - * that a functoinal device is present on the port as determined by - * PxTFD.STS.BSY=0, PxTFD.STS.DRQ=0 and PxSSTS.DET=3h - * - * Even though most AHCI host controllers work without this check, - * specific controller will fail under this condition - */ - if (status & (ATA_BUSY | ATA_DRQ)) - return; - else { - ahci_scr_read(&ap->link, SCR_STATUS, &tmp); - - if ((tmp & 0xf) != 0x3) - return; - } /* start DMA */ tmp = readl(port_mmio + PORT_CMD); |