diff options
| -rwxr-xr-x | drivers/net/qla3xxx.c | 99 | ||||
| -rwxr-xr-x | drivers/net/qla3xxx.h | 1 |
2 files changed, 64 insertions, 36 deletions
diff --git a/drivers/net/qla3xxx.c b/drivers/net/qla3xxx.c index bdf1a400430..4e9b25f475d 100755 --- a/drivers/net/qla3xxx.c +++ b/drivers/net/qla3xxx.c @@ -2122,11 +2122,13 @@ static void ql_hw_csum_setup(struct sk_buff *skb, if (ip) { if (ip->protocol == IPPROTO_TCP) { - mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_TC; + mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_TC | + OB_3032MAC_IOCB_REQ_IC; mac_iocb_ptr->ip_hdr_off = offset; mac_iocb_ptr->ip_hdr_len = ip->ihl; } else if (ip->protocol == IPPROTO_UDP) { - mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_UC; + mac_iocb_ptr->flags1 |= OB_3032MAC_IOCB_REQ_UC | + OB_3032MAC_IOCB_REQ_IC; mac_iocb_ptr->ip_hdr_off = offset; mac_iocb_ptr->ip_hdr_len = ip->ihl; } @@ -2134,51 +2136,29 @@ static void ql_hw_csum_setup(struct sk_buff *skb, } /* - * The difference between 3022 and 3032 sends: - * 3022 only supports a simple single segment transmission. - * 3032 supports checksumming and scatter/gather lists (fragments). - * The 3032 supports sglists by using the 3 addr/len pairs (ALP) - * in the IOCB plus a chain of outbound address lists (OAL) that - * each contain 5 ALPs. The last ALP of the IOCB (3rd) or OAL (5th) - * will used to point to an OAL when more ALP entries are required. - * The IOCB is always the top of the chain followed by one or more - * OALs (when necessary). + * Map the buffers for this transmit. This will return + * NETDEV_TX_BUSY or NETDEV_TX_OK based on success. */ -static int ql3xxx_send(struct sk_buff *skb, struct net_device *ndev) +static int ql_send_map(struct ql3_adapter *qdev, + struct ob_mac_iocb_req *mac_iocb_ptr, + struct ql_tx_buf_cb *tx_cb, + struct sk_buff *skb) { - struct ql3_adapter *qdev = (struct ql3_adapter *)netdev_priv(ndev); - struct ql3xxx_port_registers __iomem *port_regs = qdev->mem_map_registers; - struct ql_tx_buf_cb *tx_cb; - u32 tot_len = skb->len; struct oal *oal; struct oal_entry *oal_entry; - int len; - struct ob_mac_iocb_req *mac_iocb_ptr; + int len = skb_headlen(skb); u64 map; int seg_cnt, seg = 0; int frag_cnt = (int)skb_shinfo(skb)->nr_frags; - if (unlikely(atomic_read(&qdev->tx_count) < 2)) { - if (!netif_queue_stopped(ndev)) - netif_stop_queue(ndev); - return NETDEV_TX_BUSY; - } - tx_cb = &qdev->tx_buf[qdev->req_producer_index] ; seg_cnt = tx_cb->seg_count = ql_get_seg_count((skb_shinfo(skb)->nr_frags)); if(seg_cnt == -1) { printk(KERN_ERR PFX"%s: invalid segment count!\n",__func__); - return NETDEV_TX_OK; - + return NETDEV_TX_BUSY; } - mac_iocb_ptr = tx_cb->queue_entry; - mac_iocb_ptr->opcode = qdev->mac_ob_opcode; - mac_iocb_ptr->flags |= qdev->mb_bit_mask; - mac_iocb_ptr->transaction_id = qdev->req_producer_index; - mac_iocb_ptr->data_len = cpu_to_le16((u16) tot_len); - tx_cb->skb = skb; - if (skb->ip_summed == CHECKSUM_PARTIAL) - ql_hw_csum_setup(skb, mac_iocb_ptr); - len = skb_headlen(skb); + /* + * Map the skb buffer first. + */ map = pci_map_single(qdev->pdev, skb->data, len, PCI_DMA_TODEVICE); oal_entry = (struct oal_entry *)&mac_iocb_ptr->buf_addr0_low; oal_entry->dma_lo = cpu_to_le32(LS_64BITS(map)); @@ -2235,6 +2215,55 @@ static int ql3xxx_send(struct sk_buff *skb, struct net_device *ndev) oal_entry->len = cpu_to_le32(le32_to_cpu(oal_entry->len) | OAL_LAST_ENTRY); } + return NETDEV_TX_OK; +} + +/* + * The difference between 3022 and 3032 sends: + * 3022 only supports a simple single segment transmission. + * 3032 supports checksumming and scatter/gather lists (fragments). + * The 3032 supports sglists by using the 3 addr/len pairs (ALP) + * in the IOCB plus a chain of outbound address lists (OAL) that + * each contain 5 ALPs. The last ALP of the IOCB (3rd) or OAL (5th) + * will used to point to an OAL when more ALP entries are required. + * The IOCB is always the top of the chain followed by one or more + * OALs (when necessary). + */ +static int ql3xxx_send(struct sk_buff *skb, struct net_device *ndev) +{ + struct ql3_adapter *qdev = (struct ql3_adapter *)netdev_priv(ndev); + struct ql3xxx_port_registers __iomem *port_regs = qdev->mem_map_registers; + struct ql_tx_buf_cb *tx_cb; + u32 tot_len = skb->len; + struct ob_mac_iocb_req *mac_iocb_ptr; + + if (unlikely(atomic_read(&qdev->tx_count) < 2)) { + if (!netif_queue_stopped(ndev)) + netif_stop_queue(ndev); + return NETDEV_TX_BUSY; + } + + tx_cb = &qdev->tx_buf[qdev->req_producer_index] ; + if((tx_cb->seg_count = ql_get_seg_count((skb_shinfo(skb)->nr_frags))) == -1) { + printk(KERN_ERR PFX"%s: invalid segment count!\n",__func__); + return NETDEV_TX_OK; + } + + mac_iocb_ptr = tx_cb->queue_entry; + mac_iocb_ptr->opcode = qdev->mac_ob_opcode; + mac_iocb_ptr->flags = OB_MAC_IOCB_REQ_X; + mac_iocb_ptr->flags |= qdev->mb_bit_mask; + mac_iocb_ptr->transaction_id = qdev->req_producer_index; + mac_iocb_ptr->data_len = cpu_to_le16((u16) tot_len); + tx_cb->skb = skb; + if (skb->ip_summed == CHECKSUM_PARTIAL) + ql_hw_csum_setup(skb, mac_iocb_ptr); + + if(ql_send_map(qdev,mac_iocb_ptr,tx_cb,skb) != NETDEV_TX_OK) { + printk(KERN_ERR PFX"%s: Could not map the segments!\n",__func__); + return NETDEV_TX_BUSY; + } + wmb(); qdev->req_producer_index++; if (qdev->req_producer_index == NUM_REQ_Q_ENTRIES) diff --git a/drivers/net/qla3xxx.h b/drivers/net/qla3xxx.h index 51173e585ce..40913d2c709 100755 --- a/drivers/net/qla3xxx.h +++ b/drivers/net/qla3xxx.h @@ -1094,7 +1094,6 @@ struct oal_entry { u32 len; #define OAL_LAST_ENTRY 0x80000000 /* Last valid buffer in list. */ #define OAL_CONT_ENTRY 0x40000000 /* points to an OAL. (continuation) */ - u32 reserved; }; struct oal { |