diff options
| -rw-r--r-- | drivers/mmc/host/mmci.c | 5 | ||||
| -rw-r--r-- | include/linux/amba/mmci.h | 4 |
2 files changed, 1 insertions, 8 deletions
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c index 9c60325f1a3..758efea184c 100644 --- a/drivers/mmc/host/mmci.c +++ b/drivers/mmc/host/mmci.c @@ -1500,13 +1500,10 @@ static int mmci_probe(struct amba_device *dev, * If no maximum operating frequency is supplied, fall back to use * the module parameter, which has a (low) default value in case it * is not specified. Either value must not exceed the clock rate into - * the block, of course. Also note that DT takes precedence over - * platform data. + * the block, of course. */ if (mmc->f_max) mmc->f_max = min(host->mclk, mmc->f_max); - else if (plat->f_max) - mmc->f_max = min(host->mclk, plat->f_max); else mmc->f_max = min(host->mclk, fmax); dev_dbg(mmc_dev(mmc), "clocking block at %u Hz\n", mmc->f_max); diff --git a/include/linux/amba/mmci.h b/include/linux/amba/mmci.h index b992fc93129..3f95d32d527 100644 --- a/include/linux/amba/mmci.h +++ b/include/linux/amba/mmci.h @@ -12,9 +12,6 @@ struct dma_chan; /** * struct mmci_platform_data - platform configuration for the MMCI * (also known as PL180) block. - * @f_max: the maximum operational frequency for this host in this - * platform configuration. When this is specified it takes precedence - * over the module parameter for the same frequency. * @ocr_mask: available voltages on the 4 pins from the block, this * is ignored if a regulator is used, see the MMC_VDD_* masks in * mmc/host.h @@ -42,7 +39,6 @@ struct dma_chan; * bidirectional channel */ struct mmci_platform_data { - unsigned int f_max; unsigned int ocr_mask; int (*ios_handler)(struct device *, struct mmc_ios *); unsigned int (*status)(struct device *); |