diff options
-rw-r--r-- | arch/arm/mach-integrator/core.c | 46 | ||||
-rw-r--r-- | drivers/serial/amba-pl010.c | 160 | ||||
-rw-r--r-- | include/linux/amba/serial.h | 6 |
3 files changed, 119 insertions, 93 deletions
diff --git a/arch/arm/mach-integrator/core.c b/arch/arm/mach-integrator/core.c index 20071a2767c..576a5e979c0 100644 --- a/arch/arm/mach-integrator/core.c +++ b/arch/arm/mach-integrator/core.c @@ -15,7 +15,9 @@ #include <linux/interrupt.h> #include <linux/sched.h> #include <linux/smp.h> +#include <linux/termios.h> #include <linux/amba/bus.h> +#include <linux/amba/serial.h> #include <asm/hardware.h> #include <asm/irq.h> @@ -28,6 +30,8 @@ #include "common.h" +static struct amba_pl010_data integrator_uart_data; + static struct amba_device rtc_device = { .dev = { .bus_id = "mb:15", @@ -44,6 +48,7 @@ static struct amba_device rtc_device = { static struct amba_device uart0_device = { .dev = { .bus_id = "mb:16", + .platform_data = &integrator_uart_data, }, .res = { .start = INTEGRATOR_UART0_BASE, @@ -57,6 +62,7 @@ static struct amba_device uart0_device = { static struct amba_device uart1_device = { .dev = { .bus_id = "mb:17", + .platform_data = &integrator_uart_data, }, .res = { .start = INTEGRATOR_UART1_BASE, @@ -115,6 +121,46 @@ static int __init integrator_init(void) arch_initcall(integrator_init); +/* + * On the Integrator platform, the port RTS and DTR are provided by + * bits in the following SC_CTRLS register bits: + * RTS DTR + * UART0 7 6 + * UART1 5 4 + */ +#define SC_CTRLC (IO_ADDRESS(INTEGRATOR_SC_BASE) + INTEGRATOR_SC_CTRLC_OFFSET) +#define SC_CTRLS (IO_ADDRESS(INTEGRATOR_SC_BASE) + INTEGRATOR_SC_CTRLS_OFFSET) + +static void integrator_uart_set_mctrl(struct amba_device *dev, void __iomem *base, unsigned int mctrl) +{ + unsigned int ctrls = 0, ctrlc = 0, rts_mask, dtr_mask; + + if (dev == &uart0_device) { + rts_mask = 1 << 4; + dtr_mask = 1 << 5; + } else { + rts_mask = 1 << 6; + dtr_mask = 1 << 7; + } + + if (mctrl & TIOCM_RTS) + ctrlc |= rts_mask; + else + ctrls |= rts_mask; + + if (mctrl & TIOCM_DTR) + ctrlc |= dtr_mask; + else + ctrls |= dtr_mask; + + __raw_writel(ctrls, SC_CTRLS); + __raw_writel(ctrlc, SC_CTRLC); +} + +static struct amba_pl010_data integrator_uart_data = { + .set_mctrl = integrator_uart_set_mctrl, +}; + #define CM_CTRL IO_ADDRESS(INTEGRATOR_HDR_BASE) + INTEGRATOR_HDR_CTRL_OFFSET static DEFINE_SPINLOCK(cm_lock); diff --git a/drivers/serial/amba-pl010.c b/drivers/serial/amba-pl010.c index 127d6cd5de7..1631414000a 100644 --- a/drivers/serial/amba-pl010.c +++ b/drivers/serial/amba-pl010.c @@ -51,8 +51,6 @@ #include <linux/amba/serial.h> #include <asm/io.h> -#include <asm/irq.h> -#include <asm/hardware.h> #define UART_NR 2 @@ -65,26 +63,16 @@ #define UART_RX_DATA(s) (((s) & UART01x_FR_RXFE) == 0) #define UART_TX_READY(s) (((s) & UART01x_FR_TXFF) == 0) -#define UART_DUMMY_RSR_RX /*256*/0 +#define UART_DUMMY_RSR_RX 256 #define UART_PORT_SIZE 64 /* - * On the Integrator platform, the port RTS and DTR are provided by - * bits in the following SC_CTRLS register bits: - * RTS DTR - * UART0 7 6 - * UART1 5 4 - */ -#define SC_CTRLC (IO_ADDRESS(INTEGRATOR_SC_BASE) + INTEGRATOR_SC_CTRLC_OFFSET) -#define SC_CTRLS (IO_ADDRESS(INTEGRATOR_SC_BASE) + INTEGRATOR_SC_CTRLS_OFFSET) - -/* * We wrap our port structure around the generic uart_port. */ struct uart_amba_port { struct uart_port port; - unsigned int dtr_mask; - unsigned int rts_mask; + struct amba_device *dev; + struct amba_pl010_data *data; unsigned int old_status; }; @@ -300,20 +288,9 @@ static unsigned int pl010_get_mctrl(struct uart_port *port) static void pl010_set_mctrl(struct uart_port *port, unsigned int mctrl) { struct uart_amba_port *uap = (struct uart_amba_port *)port; - unsigned int ctrls = 0, ctrlc = 0; - - if (mctrl & TIOCM_RTS) - ctrlc |= uap->rts_mask; - else - ctrls |= uap->rts_mask; - if (mctrl & TIOCM_DTR) - ctrlc |= uap->dtr_mask; - else - ctrls |= uap->dtr_mask; - - __raw_writel(ctrls, SC_CTRLS); - __raw_writel(ctrlc, SC_CTRLC); + if (uap->data) + uap->data->set_mctrl(uap->dev, uap->port.membase, mctrl); } static void pl010_break_ctl(struct uart_port *port, int break_state) @@ -539,38 +516,7 @@ static struct uart_ops amba_pl010_pops = { .verify_port = pl010_verify_port, }; -static struct uart_amba_port amba_ports[UART_NR] = { - { - .port = { - .membase = (void *)IO_ADDRESS(INTEGRATOR_UART0_BASE), - .mapbase = INTEGRATOR_UART0_BASE, - .iotype = UPIO_MEM, - .irq = IRQ_UARTINT0, - .uartclk = 14745600, - .fifosize = 16, - .ops = &amba_pl010_pops, - .flags = UPF_BOOT_AUTOCONF, - .line = 0, - }, - .dtr_mask = 1 << 5, - .rts_mask = 1 << 4, - }, - { - .port = { - .membase = (void *)IO_ADDRESS(INTEGRATOR_UART1_BASE), - .mapbase = INTEGRATOR_UART1_BASE, - .iotype = UPIO_MEM, - .irq = IRQ_UARTINT1, - .uartclk = 14745600, - .fifosize = 16, - .ops = &amba_pl010_pops, - .flags = UPF_BOOT_AUTOCONF, - .line = 1, - }, - .dtr_mask = 1 << 7, - .rts_mask = 1 << 6, - } -}; +static struct uart_amba_port *amba_ports[UART_NR]; #ifdef CONFIG_SERIAL_AMBA_PL010_CONSOLE @@ -588,7 +534,7 @@ static void pl010_console_putchar(struct uart_port *port, int ch) static void pl010_console_write(struct console *co, const char *s, unsigned int count) { - struct uart_port *port = &amba_ports[co->index].port; + struct uart_port *port = &amba_ports[co->index]->port; unsigned int status, old_cr; /* @@ -651,7 +597,7 @@ static int __init pl010_console_setup(struct console *co, char *options) */ if (co->index >= UART_NR) co->index = 0; - port = &amba_ports[co->index].port; + port = &amba_ports[co->index]->port; if (options) uart_parse_options(options, &baud, &parity, &bits, &flow); @@ -672,24 +618,6 @@ static struct console amba_console = { .data = &amba_reg, }; -static int __init amba_console_init(void) -{ - /* - * All port initializations are done statically - */ - register_console(&amba_console); - return 0; -} -console_initcall(amba_console_init); - -static int __init amba_late_console_init(void) -{ - if (!(amba_console.flags & CON_ENABLED)) - register_console(&amba_console); - return 0; -} -late_initcall(amba_late_console_init); - #define AMBA_CONSOLE &amba_console #else #define AMBA_CONSOLE NULL @@ -707,30 +635,76 @@ static struct uart_driver amba_reg = { static int pl010_probe(struct amba_device *dev, void *id) { - int i; + struct uart_amba_port *port; + void __iomem *base; + int i, ret; - for (i = 0; i < UART_NR; i++) { - if (amba_ports[i].port.mapbase != dev->res.start) - continue; + for (i = 0; i < ARRAY_SIZE(amba_ports); i++) + if (amba_ports[i] == NULL) + break; - amba_ports[i].port.dev = &dev->dev; - uart_add_one_port(&amba_reg, &amba_ports[i].port); - amba_set_drvdata(dev, &amba_ports[i]); - break; + if (i == ARRAY_SIZE(amba_ports)) { + ret = -EBUSY; + goto out; } - return 0; + port = kzalloc(sizeof(struct uart_amba_port), GFP_KERNEL); + if (!port) { + ret = -ENOMEM; + goto out; + } + + base = ioremap(dev->res.start, PAGE_SIZE); + if (!base) { + ret = -ENOMEM; + goto free; + } + + port->port.dev = &dev->dev; + port->port.mapbase = dev->res.start; + port->port.membase = base; + port->port.iotype = UPIO_MEM; + port->port.irq = dev->irq[0]; + port->port.uartclk = 14745600; + port->port.fifosize = 16; + port->port.ops = &amba_pl010_pops; + port->port.flags = UPF_BOOT_AUTOCONF; + port->port.line = i; + port->dev = dev; + port->data = dev->dev.platform_data; + + amba_ports[i] = port; + + amba_set_drvdata(dev, port); + ret = uart_add_one_port(&amba_reg, &port->port); + if (ret) { + amba_set_drvdata(dev, NULL); + amba_ports[i] = NULL; + iounmap(base); + free: + kfree(port); + } + + out: + return ret; } static int pl010_remove(struct amba_device *dev) { - struct uart_amba_port *uap = amba_get_drvdata(dev); - - if (uap) - uart_remove_one_port(&amba_reg, &uap->port); + struct uart_amba_port *port = amba_get_drvdata(dev); + int i; amba_set_drvdata(dev, NULL); + uart_remove_one_port(&amba_reg, &port->port); + + for (i = 0; i < ARRAY_SIZE(amba_ports); i++) + if (amba_ports[i] == port) + amba_ports[i] = NULL; + + iounmap(port->port.membase); + kfree(port); + return 0; } diff --git a/include/linux/amba/serial.h b/include/linux/amba/serial.h index dc726ffcceb..48ee32a18ac 100644 --- a/include/linux/amba/serial.h +++ b/include/linux/amba/serial.h @@ -158,4 +158,10 @@ #define UART01x_RSR_ANY (UART01x_RSR_OE|UART01x_RSR_BE|UART01x_RSR_PE|UART01x_RSR_FE) #define UART01x_FR_MODEM_ANY (UART01x_FR_DCD|UART01x_FR_DSR|UART01x_FR_CTS) +#ifndef __ASSEMBLY__ +struct amba_pl010_data { + void (*set_mctrl)(struct amba_device *dev, void __iomem *base, unsigned int mctrl); +}; +#endif + #endif |