diff options
| -rw-r--r-- | drivers/usb/host/ehci-tegra.c | 246 |
1 files changed, 1 insertions, 245 deletions
diff --git a/drivers/usb/host/ehci-tegra.c b/drivers/usb/host/ehci-tegra.c index 289b9b83f6b..dde51896979 100644 --- a/drivers/usb/host/ehci-tegra.c +++ b/drivers/usb/host/ehci-tegra.c @@ -46,30 +46,11 @@ struct tegra_ehci_hcd { struct tegra_usb_phy *phy; struct clk *clk; struct usb_phy *transceiver; - int host_resumed; int port_resuming; bool needs_double_reset; enum tegra_usb_phy_port_speed port_speed; }; -static void tegra_ehci_power_up(struct usb_hcd *hcd) -{ - struct tegra_ehci_hcd *tegra = dev_get_drvdata(hcd->self.controller); - - clk_prepare_enable(tegra->clk); - usb_phy_set_suspend(hcd->phy, 0); - tegra->host_resumed = 1; -} - -static void tegra_ehci_power_down(struct usb_hcd *hcd) -{ - struct tegra_ehci_hcd *tegra = dev_get_drvdata(hcd->self.controller); - - tegra->host_resumed = 0; - usb_phy_set_suspend(hcd->phy, 1); - clk_disable_unprepare(tegra->clk); -} - static int tegra_ehci_internal_port_reset( struct ehci_hcd *ehci, u32 __iomem *portsc_reg @@ -248,39 +229,6 @@ done: return retval; } -static void tegra_ehci_restart(struct usb_hcd *hcd) -{ - struct ehci_hcd *ehci = hcd_to_ehci(hcd); - - ehci_reset(ehci); - - /* setup the frame list and Async q heads */ - ehci_writel(ehci, ehci->periodic_dma, &ehci->regs->frame_list); - ehci_writel(ehci, (u32)ehci->async->qh_dma, &ehci->regs->async_next); - /* setup the command register and set the controller in RUN mode */ - ehci->command &= ~(CMD_LRESET|CMD_IAAD|CMD_PSE|CMD_ASE|CMD_RESET); - ehci->command |= CMD_RUN; - ehci_writel(ehci, ehci->command, &ehci->regs->command); - - down_write(&ehci_cf_port_reset_rwsem); - ehci_writel(ehci, FLAG_CF, &ehci->regs->configured_flag); - /* flush posted writes */ - ehci_readl(ehci, &ehci->regs->command); - up_write(&ehci_cf_port_reset_rwsem); -} - -static void tegra_ehci_shutdown(struct usb_hcd *hcd) -{ - struct tegra_ehci_hcd *tegra = dev_get_drvdata(hcd->self.controller); - - /* ehci_shutdown touches the USB controller registers, make sure - * controller has clocks to it */ - if (!tegra->host_resumed) - tegra_ehci_power_up(hcd); - - ehci_shutdown(hcd); -} - static int tegra_ehci_setup(struct usb_hcd *hcd) { struct ehci_hcd *ehci = hcd_to_ehci(hcd); @@ -395,7 +343,7 @@ static const struct hc_driver tegra_ehci_hc_driver = { /* modified ehci functions for tegra */ .reset = tegra_ehci_setup, - .shutdown = tegra_ehci_shutdown, + .shutdown = ehci_shutdown, .map_urb_for_dma = tegra_ehci_map_urb_for_dma, .unmap_urb_for_dma = tegra_ehci_unmap_urb_for_dma, .hub_control = tegra_ehci_hub_control, @@ -432,182 +380,6 @@ static int setup_vbus_gpio(struct platform_device *pdev, return err; } -#ifdef CONFIG_PM - -static int controller_suspend(struct device *dev) -{ - struct tegra_ehci_hcd *tegra = - platform_get_drvdata(to_platform_device(dev)); - struct ehci_hcd *ehci = tegra->ehci; - struct usb_hcd *hcd = ehci_to_hcd(ehci); - struct ehci_regs __iomem *hw = ehci->regs; - unsigned long flags; - - if (time_before(jiffies, ehci->next_statechange)) - msleep(10); - - ehci_halt(ehci); - - spin_lock_irqsave(&ehci->lock, flags); - tegra->port_speed = (readl(&hw->port_status[0]) >> 26) & 0x3; - clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags); - spin_unlock_irqrestore(&ehci->lock, flags); - - tegra_ehci_power_down(hcd); - return 0; -} - -static int controller_resume(struct device *dev) -{ - struct tegra_ehci_hcd *tegra = - platform_get_drvdata(to_platform_device(dev)); - struct ehci_hcd *ehci = tegra->ehci; - struct usb_hcd *hcd = ehci_to_hcd(ehci); - struct ehci_regs __iomem *hw = ehci->regs; - unsigned long val; - - set_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags); - tegra_ehci_power_up(hcd); - - if (tegra->port_speed > TEGRA_USB_PHY_PORT_SPEED_HIGH) { - /* Wait for the phy to detect new devices - * before we restart the controller */ - msleep(10); - goto restart; - } - - /* Force the phy to keep data lines in suspend state */ - tegra_ehci_phy_restore_start(hcd->phy, tegra->port_speed); - - /* Enable host mode */ - tdi_reset(ehci); - - /* Enable Port Power */ - val = readl(&hw->port_status[0]); - val |= PORT_POWER; - writel(val, &hw->port_status[0]); - udelay(10); - - /* Check if the phy resume from LP0. When the phy resume from LP0 - * USB register will be reset. */ - if (!readl(&hw->async_next)) { - /* Program the field PTC based on the saved speed mode */ - val = readl(&hw->port_status[0]); - val &= ~PORT_TEST(~0); - if (tegra->port_speed == TEGRA_USB_PHY_PORT_SPEED_HIGH) - val |= PORT_TEST_FORCE; - else if (tegra->port_speed == TEGRA_USB_PHY_PORT_SPEED_FULL) - val |= PORT_TEST(6); - else if (tegra->port_speed == TEGRA_USB_PHY_PORT_SPEED_LOW) - val |= PORT_TEST(7); - writel(val, &hw->port_status[0]); - udelay(10); - - /* Disable test mode by setting PTC field to NORMAL_OP */ - val = readl(&hw->port_status[0]); - val &= ~PORT_TEST(~0); - writel(val, &hw->port_status[0]); - udelay(10); - } - - /* Poll until CCS is enabled */ - if (ehci_handshake(ehci, &hw->port_status[0], PORT_CONNECT, - PORT_CONNECT, 2000)) { - pr_err("%s: timeout waiting for PORT_CONNECT\n", __func__); - goto restart; - } - - /* Poll until PE is enabled */ - if (ehci_handshake(ehci, &hw->port_status[0], PORT_PE, - PORT_PE, 2000)) { - pr_err("%s: timeout waiting for USB_PORTSC1_PE\n", __func__); - goto restart; - } - - /* Clear the PCI status, to avoid an interrupt taken upon resume */ - val = readl(&hw->status); - val |= STS_PCD; - writel(val, &hw->status); - - /* Put controller in suspend mode by writing 1 to SUSP bit of PORTSC */ - val = readl(&hw->port_status[0]); - if ((val & PORT_POWER) && (val & PORT_PE)) { - val |= PORT_SUSPEND; - writel(val, &hw->port_status[0]); - - /* Wait until port suspend completes */ - if (ehci_handshake(ehci, &hw->port_status[0], PORT_SUSPEND, - PORT_SUSPEND, 1000)) { - pr_err("%s: timeout waiting for PORT_SUSPEND\n", - __func__); - goto restart; - } - } - - tegra_ehci_phy_restore_end(hcd->phy); - goto done; - - restart: - if (tegra->port_speed <= TEGRA_USB_PHY_PORT_SPEED_HIGH) - tegra_ehci_phy_restore_end(hcd->phy); - - tegra_ehci_restart(hcd); - - done: - tegra_usb_phy_preresume(hcd->phy); - tegra->port_resuming = 1; - return 0; -} - -static int tegra_ehci_suspend(struct device *dev) -{ - struct tegra_ehci_hcd *tegra = - platform_get_drvdata(to_platform_device(dev)); - struct usb_hcd *hcd = ehci_to_hcd(tegra->ehci); - int rc = 0; - - /* - * When system sleep is supported and USB controller wakeup is - * implemented: If the controller is runtime-suspended and the - * wakeup setting needs to be changed, call pm_runtime_resume(). - */ - if (HCD_HW_ACCESSIBLE(hcd)) - rc = controller_suspend(dev); - return rc; -} - -static int tegra_ehci_resume(struct device *dev) -{ - int rc; - - rc = controller_resume(dev); - if (rc == 0) { - pm_runtime_disable(dev); - pm_runtime_set_active(dev); - pm_runtime_enable(dev); - } - return rc; -} - -static int tegra_ehci_runtime_suspend(struct device *dev) -{ - return controller_suspend(dev); -} - -static int tegra_ehci_runtime_resume(struct device *dev) -{ - return controller_resume(dev); -} - -static const struct dev_pm_ops tegra_ehci_pm_ops = { - .suspend = tegra_ehci_suspend, - .resume = tegra_ehci_resume, - .runtime_suspend = tegra_ehci_runtime_suspend, - .runtime_resume = tegra_ehci_runtime_resume, -}; - -#endif - /* Bits of PORTSC1, which will get cleared by writing 1 into them */ #define TEGRA_PORTSC1_RWC_BITS (PORT_CSC | PORT_PEC | PORT_OCC) @@ -746,7 +518,6 @@ static int tegra_ehci_probe(struct platform_device *pdev) goto cleanup_phy; } - tegra->host_resumed = 1; tegra->ehci = hcd_to_ehci(hcd); irq = platform_get_irq(pdev, 0); @@ -773,14 +544,6 @@ static int tegra_ehci_probe(struct platform_device *pdev) goto cleanup_phy; } - pm_runtime_set_active(&pdev->dev); - pm_runtime_get_noresume(&pdev->dev); - - /* Don't skip the pm_runtime_forbid call if wakeup isn't working */ - /* if (!pdata->power_down_on_bus_suspend) */ - pm_runtime_forbid(&pdev->dev); - pm_runtime_enable(&pdev->dev); - pm_runtime_put_sync(&pdev->dev); return err; cleanup_phy: @@ -800,10 +563,6 @@ static int tegra_ehci_remove(struct platform_device *pdev) struct tegra_ehci_hcd *tegra = platform_get_drvdata(pdev); struct usb_hcd *hcd = ehci_to_hcd(tegra->ehci); - pm_runtime_get_sync(&pdev->dev); - pm_runtime_disable(&pdev->dev); - pm_runtime_put_noidle(&pdev->dev); - if (!IS_ERR(tegra->transceiver)) otg_set_host(tegra->transceiver->otg, NULL); @@ -837,8 +596,5 @@ static struct platform_driver tegra_ehci_driver = { .driver = { .name = "tegra-ehci", .of_match_table = tegra_ehci_of_match, -#ifdef CONFIG_PM - .pm = &tegra_ehci_pm_ops, -#endif } }; |