diff options
| -rw-r--r-- | drivers/net/phy/smsc.c | 28 |
1 files changed, 27 insertions, 1 deletions
diff --git a/drivers/net/phy/smsc.c b/drivers/net/phy/smsc.c index 6d6192316b3..88e3991464e 100644 --- a/drivers/net/phy/smsc.c +++ b/drivers/net/phy/smsc.c @@ -56,6 +56,32 @@ static int smsc_phy_config_init(struct phy_device *phydev) return smsc_phy_ack_interrupt (phydev); } +static int lan87xx_config_init(struct phy_device *phydev) +{ + /* + * Make sure the EDPWRDOWN bit is NOT set. Setting this bit on + * LAN8710/LAN8720 PHY causes the PHY to misbehave, likely due + * to a bug on the chip. + * + * When the system is powered on with the network cable being + * disconnected all the way until after ifconfig ethX up is + * issued for the LAN port with this PHY, connecting the cable + * afterwards does not cause LINK change detection, while the + * expected behavior is the Link UP being detected. + */ + int rc = phy_read(phydev, MII_LAN83C185_CTRL_STATUS); + if (rc < 0) + return rc; + + rc &= ~MII_LAN83C185_EDPWRDOWN; + + rc = phy_write(phydev, MII_LAN83C185_CTRL_STATUS, rc); + if (rc < 0) + return rc; + + return smsc_phy_ack_interrupt(phydev); +} + static int lan911x_config_init(struct phy_device *phydev) { return smsc_phy_ack_interrupt(phydev); @@ -162,7 +188,7 @@ static struct phy_driver smsc_phy_driver[] = { /* basic functions */ .config_aneg = genphy_config_aneg, .read_status = genphy_read_status, - .config_init = smsc_phy_config_init, + .config_init = lan87xx_config_init, /* IRQ related */ .ack_interrupt = smsc_phy_ack_interrupt, |