diff options
Diffstat (limited to 'Documentation/DMA-mapping.txt')
| -rw-r--r-- | Documentation/DMA-mapping.txt | 26 |
1 files changed, 19 insertions, 7 deletions
diff --git a/Documentation/DMA-mapping.txt b/Documentation/DMA-mapping.txt index ee4bb73683c..7c717699032 100644 --- a/Documentation/DMA-mapping.txt +++ b/Documentation/DMA-mapping.txt @@ -58,11 +58,15 @@ translating each of those pages back to a kernel address using something like __va(). [ EDIT: Update this when we integrate Gerd Knorr's generic code which does this. ] -This rule also means that you may not use kernel image addresses -(ie. items in the kernel's data/text/bss segment, or your driver's) -nor may you use kernel stack addresses for DMA. Both of these items -might be mapped somewhere entirely different than the rest of physical -memory. +This rule also means that you may use neither kernel image addresses +(items in data/text/bss segments), nor module image addresses, nor +stack addresses for DMA. These could all be mapped somewhere entirely +different than the rest of physical memory. Even if those classes of +memory could physically work with DMA, you'd need to ensure the I/O +buffers were cacheline-aligned. Without that, you'd see cacheline +sharing problems (data corruption) on CPUs with DMA-incoherent caches. +(The CPU could write to one word, DMA would write to a different one +in the same cache line, and one of them could be overwritten.) Also, this means that you cannot take the return of a kmap() call and DMA to/from that. This is similar to vmalloc(). @@ -194,7 +198,7 @@ document for how to handle this case. Finally, if your device can only drive the low 24-bits of address during PCI bus mastering you might do something like: - if (pci_set_dma_mask(pdev, 0x00ffffff)) { + if (pci_set_dma_mask(pdev, DMA_24BIT_MASK)) { printk(KERN_WARNING "mydev: 24-bit DMA addressing not available.\n"); goto ignore_this_device; @@ -212,7 +216,7 @@ functions (for example a sound card provides playback and record functions) and the various different functions have _different_ DMA addressing limitations, you may wish to probe each mask and only provide the functionality which the machine can handle. It -is important that the last call to pci_set_dma_mask() be for the +is important that the last call to pci_set_dma_mask() be for the most specific mask. Here is pseudo-code showing how this might be done: @@ -284,6 +288,11 @@ There are two types of DMA mappings: in order to get correct behavior on all platforms. + Also, on some platforms your driver may need to flush CPU write + buffers in much the same way as it needs to flush write buffers + found in PCI bridges (such as by reading a register's value + after writing it). + - Streaming DMA mappings which are usually mapped for one DMA transfer, unmapped right after it (unless you use pci_dma_sync_* below) and for which hardware can optimize for sequential accesses. @@ -303,6 +312,9 @@ There are two types of DMA mappings: Neither type of DMA mapping has alignment restrictions that come from PCI, although some devices may have such restrictions. +Also, systems with caches that aren't DMA-coherent will work better +when the underlying buffers don't share cache lines with other data. + Using Consistent DMA mappings. |