diff options
Diffstat (limited to 'Documentation/DocBook/libata.tmpl')
| -rw-r--r-- | Documentation/DocBook/libata.tmpl | 47 |
1 files changed, 43 insertions, 4 deletions
diff --git a/Documentation/DocBook/libata.tmpl b/Documentation/DocBook/libata.tmpl index d260d92089a..5bcbb6ee3bc 100644 --- a/Documentation/DocBook/libata.tmpl +++ b/Documentation/DocBook/libata.tmpl @@ -120,14 +120,27 @@ void (*dev_config) (struct ata_port *, struct ata_device *); <programlisting> void (*set_piomode) (struct ata_port *, struct ata_device *); void (*set_dmamode) (struct ata_port *, struct ata_device *); -void (*post_set_mode) (struct ata_port *ap); +void (*post_set_mode) (struct ata_port *); +unsigned int (*mode_filter) (struct ata_port *, struct ata_device *, unsigned int); </programlisting> <para> Hooks called prior to the issue of SET FEATURES - XFER MODE - command. dev->pio_mode is guaranteed to be valid when - ->set_piomode() is called, and dev->dma_mode is guaranteed to be - valid when ->set_dmamode() is called. ->post_set_mode() is + command. The optional ->mode_filter() hook is called when libata + has built a mask of the possible modes. This is passed to the + ->mode_filter() function which should return a mask of valid modes + after filtering those unsuitable due to hardware limits. It is not + valid to use this interface to add modes. + </para> + <para> + dev->pio_mode and dev->dma_mode are guaranteed to be valid when + ->set_piomode() and when ->set_dmamode() is called. The timings for + any other drive sharing the cable will also be valid at this point. + That is the library records the decisions for the modes of each + drive on a channel before it attempts to set any of them. + </para> + <para> + ->post_set_mode() is called unconditionally, after the SET FEATURES - XFER MODE command completes successfully. </para> @@ -230,6 +243,32 @@ void (*dev_select)(struct ata_port *ap, unsigned int device); </sect2> + <sect2><title>Private tuning method</title> + <programlisting> +void (*set_mode) (struct ata_port *ap); + </programlisting> + + <para> + By default libata performs drive and controller tuning in + accordance with the ATA timing rules and also applies blacklists + and cable limits. Some controllers need special handling and have + custom tuning rules, typically raid controllers that use ATA + commands but do not actually do drive timing. + </para> + + <warning> + <para> + This hook should not be used to replace the standard controller + tuning logic when a controller has quirks. Replacing the default + tuning logic in that case would bypass handling for drive and + bridge quirks that may be important to data reliability. If a + controller needs to filter the mode selection it should use the + mode_filter hook instead. + </para> + </warning> + + </sect2> + <sect2><title>Reset ATA bus</title> <programlisting> void (*phy_reset) (struct ata_port *ap); |