diff options
Diffstat (limited to 'Documentation/cdrom/sjcd')
| -rw-r--r-- | Documentation/cdrom/sjcd | 60 |
1 files changed, 0 insertions, 60 deletions
diff --git a/Documentation/cdrom/sjcd b/Documentation/cdrom/sjcd deleted file mode 100644 index 74a14847b93..00000000000 --- a/Documentation/cdrom/sjcd +++ /dev/null @@ -1,60 +0,0 @@ - -- Documentation/cdrom/sjcd - 80% of the work takes 20% of the time, - 20% of the work takes 80% of the time... - (Murphy's law) - - Once started, training can not be stopped... - (Star Wars) - -This is the README for the sjcd cdrom driver, version 1.6. - -This file is meant as a tips & tricks edge for the usage of the SANYO CDR-H94A -cdrom drive. It will grow as the questions arise. ;-) -For info on configuring the ISP16 sound card look at Documentation/cdrom/isp16. - -The driver should work with any of the Panasonic, Sony or Mitsumi style -CDROM interfaces. -The cdrom interface on Media Magic's soft configurable sound card ISP16, -which used to be included in the driver, is now supported in a separate module. -This initialisation module will probably also work with other interfaces -based on an OPTi 82C928 or 82C929 chip (like MAD16 and Mozart): see the -documentation Documentation/cdrom/isp16. - -The device major for sjcd is 18, and minor is 0. Create a block special -file in your /dev directory (e.g., /dev/sjcd) with these numbers. -(For those who don't know, being root and doing the following should do -the trick: - mknod -m 644 /dev/sjcd b 18 0 -and mount the cdrom by /dev/sjcd). - -The default configuration parameters are: - base address 0x340 - no irq - no dma -(Actually the CDR-H94A doesn't know how to use irq and dma.) -As of version 1.2, setting base address at boot time is supported -through the use of command line options: type at the "boot:" prompt: - linux sjcd=<base_address> -(where you would use the kernel labeled "linux" in lilo's configuration -file /etc/lilo.conf). You could also use 'append="sjcd=<configuration_info>"' -in the appropriate section of /etc/lilo.conf -If you're building a kernel yourself you can set your default base -i/o address with SJCD_BASE_ADDR in /usr/src/linux/drivers/cdrom/sjcd.h. - -The sjcd driver supports being loaded as a module. The following -command will set the base i/o address on the fly (assuming you -have installed the module in an appropriate place). - insmod sjcd.o sjcd_base=<base_address> - - -Have fun! - -If something is wrong, please email to vadim@rbrf.ru - or vadim@ipsun.ras.ru - or model@cecmow.enet.dec.com - or H.T.M.v.d.Maarel@marin.nl - -It happens sometimes that Vadim is not reachable by mail. For these -instances, Eric van der Maarel will help too. - - Vadim V. Model, Eric van der Maarel, Eberhard Moenkeberg |