summaryrefslogtreecommitdiffstats
path: root/Documentation/gpio/board.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/gpio/board.txt')
-rw-r--r--Documentation/gpio/board.txt28
1 files changed, 17 insertions, 11 deletions
diff --git a/Documentation/gpio/board.txt b/Documentation/gpio/board.txt
index 0d03506f2cc..ba169faad5c 100644
--- a/Documentation/gpio/board.txt
+++ b/Documentation/gpio/board.txt
@@ -72,10 +72,11 @@ where
- chip_label is the label of the gpiod_chip instance providing the GPIO
- chip_hwnum is the hardware number of the GPIO within the chip
- - dev_id is the identifier of the device that will make use of this GPIO. If
- NULL, the GPIO will be available to all devices.
+ - dev_id is the identifier of the device that will make use of this GPIO. It
+ can be NULL, in which case it will be matched for calls to gpiod_get()
+ with a NULL device.
- con_id is the name of the GPIO function from the device point of view. It
- can be NULL.
+ can be NULL, in which case it will match any function.
- idx is the index of the GPIO within the function.
- flags is defined to specify the following properties:
* GPIOF_ACTIVE_LOW - to configure the GPIO as active-low
@@ -86,18 +87,23 @@ In the future, these flags might be extended to support more properties.
Note that GPIO_LOOKUP() is just a shortcut to GPIO_LOOKUP_IDX() where idx = 0.
-A lookup table can then be defined as follows:
+A lookup table can then be defined as follows, with an empty entry defining its
+end:
- struct gpiod_lookup gpios_table[] = {
- GPIO_LOOKUP_IDX("gpio.0", 15, "foo.0", "led", 0, GPIO_ACTIVE_HIGH),
- GPIO_LOOKUP_IDX("gpio.0", 16, "foo.0", "led", 1, GPIO_ACTIVE_HIGH),
- GPIO_LOOKUP_IDX("gpio.0", 17, "foo.0", "led", 2, GPIO_ACTIVE_HIGH),
- GPIO_LOOKUP("gpio.0", 1, "foo.0", "power", GPIO_ACTIVE_LOW),
- };
+struct gpiod_lookup_table gpios_table = {
+ .dev_id = "foo.0",
+ .table = {
+ GPIO_LOOKUP_IDX("gpio.0", 15, "led", 0, GPIO_ACTIVE_HIGH),
+ GPIO_LOOKUP_IDX("gpio.0", 16, "led", 1, GPIO_ACTIVE_HIGH),
+ GPIO_LOOKUP_IDX("gpio.0", 17, "led", 2, GPIO_ACTIVE_HIGH),
+ GPIO_LOOKUP("gpio.0", 1, "power", GPIO_ACTIVE_LOW),
+ { },
+ },
+};
And the table can be added by the board code as follows:
- gpiod_add_table(gpios_table, ARRAY_SIZE(gpios_table));
+ gpiod_add_lookup_table(&gpios_table);
The driver controlling "foo.0" will then be able to obtain its GPIOs as follows: