diff options
Diffstat (limited to 'Documentation/hwmon/adt7410')
| -rw-r--r-- | Documentation/hwmon/adt7410 | 51 |
1 files changed, 51 insertions, 0 deletions
diff --git a/Documentation/hwmon/adt7410 b/Documentation/hwmon/adt7410 new file mode 100644 index 00000000000..96004000dc2 --- /dev/null +++ b/Documentation/hwmon/adt7410 @@ -0,0 +1,51 @@ +Kernel driver adt7410 +===================== + +Supported chips: + * Analog Devices ADT7410 + Prefix: 'adt7410' + Addresses scanned: I2C 0x48 - 0x4B + Datasheet: Publicly available at the Analog Devices website + http://www.analog.com/static/imported-files/data_sheets/ADT7410.pdf + +Author: Hartmut Knaack <knaack.h@gmx.de> + +Description +----------- + +The ADT7410 is a temperature sensor with rated temperature range of -55°C to ++150°C. It has a high accuracy of +/-0.5°C and can be operated at a resolution +of 13 bits (0.0625°C) or 16 bits (0.0078°C). The sensor provides an INT pin to +indicate that a minimum or maximum temperature set point has been exceeded, as +well as a critical temperature (CT) pin to indicate that the critical +temperature set point has been exceeded. Both pins can be set up with a common +hysteresis of 0°C - 15°C and a fault queue, ranging from 1 to 4 events. Both +pins can individually set to be active-low or active-high, while the whole +device can either run in comparator mode or interrupt mode. The ADT7410 +supports continous temperature sampling, as well as sampling one temperature +value per second or even justget one sample on demand for power saving. +Besides, it can completely power down its ADC, if power management is +required. + +Configuration Notes +------------------- + +Since the device uses one hysteresis value, which is an offset to minimum, +maximum and critical temperature, it can only be set for temp#_max_hyst. +However, temp#_min_hyst and temp#_crit_hyst show their corresponding +hysteresis. +The device is set to 16 bit resolution and comparator mode. + +sysfs-Interface +--------------- + +temp#_input - temperature input +temp#_min - temperature minimum setpoint +temp#_max - temperature maximum setpoint +temp#_crit - critical temperature setpoint +temp#_min_hyst - hysteresis for temperature minimum (read-only) +temp#_max_hyst - hysteresis for temperature maximum (read/write) +temp#_crit_hyst - hysteresis for critical temperature (read-only) +temp#_min_alarm - temperature minimum alarm flag +temp#_max_alarm - temperature maximum alarm flag +temp#_crit_alarm - critical temperature alarm flag |