diff options
Diffstat (limited to 'Documentation/networking/ip-sysctl.txt')
| -rw-r--r-- | Documentation/networking/ip-sysctl.txt | 66 |
1 files changed, 59 insertions, 7 deletions
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index 006b39dec87..8b72c88ba21 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -487,6 +487,30 @@ tcp_dma_copybreak - INTEGER and CONFIG_NET_DMA is enabled. Default: 4096 +tcp_thin_linear_timeouts - BOOLEAN + Enable dynamic triggering of linear timeouts for thin streams. + If set, a check is performed upon retransmission by timeout to + determine if the stream is thin (less than 4 packets in flight). + As long as the stream is found to be thin, up to 6 linear + timeouts may be performed before exponential backoff mode is + initiated. This improves retransmission latency for + non-aggressive thin streams, often found to be time-dependent. + For more information on thin streams, see + Documentation/networking/tcp-thin.txt + Default: 0 + +tcp_thin_dupack - BOOLEAN + Enable dynamic triggering of retransmissions after one dupACK + for thin streams. If set, a check is performed upon reception + of a dupACK to determine if the stream is thin (less than 4 + packets in flight). As long as the stream is found to be thin, + data is retransmitted on the first received dupACK. This + improves retransmission latency for non-aggressive thin + streams, often found to be time-dependent. + For more information on thin streams, see + Documentation/networking/tcp-thin.txt + Default: 0 + UDP variables: udp_mem - vector of 3 INTEGERs: min, pressure, max @@ -692,6 +716,25 @@ proxy_arp - BOOLEAN conf/{all,interface}/proxy_arp is set to TRUE, it will be disabled otherwise +proxy_arp_pvlan - BOOLEAN + Private VLAN proxy arp. + Basically allow proxy arp replies back to the same interface + (from which the ARP request/solicitation was received). + + This is done to support (ethernet) switch features, like RFC + 3069, where the individual ports are NOT allowed to + communicate with each other, but they are allowed to talk to + the upstream router. As described in RFC 3069, it is possible + to allow these hosts to communicate through the upstream + router by proxy_arp'ing. Don't need to be used together with + proxy_arp. + + This technology is known by different names: + In RFC 3069 it is called VLAN Aggregation. + Cisco and Allied Telesyn call it Private VLAN. + Hewlett-Packard call it Source-Port filtering or port-isolation. + Ericsson call it MAC-Forced Forwarding (RFC Draft). + shared_media - BOOLEAN Send(router) or accept(host) RFC1620 shared media redirects. Overrides ip_secure_redirects. @@ -833,9 +876,18 @@ arp_notify - BOOLEAN or hardware address changes. arp_accept - BOOLEAN - Define behavior when gratuitous arp replies are received: - 0 - drop gratuitous arp frames - 1 - accept gratuitous arp frames + Define behavior for gratuitous ARP frames who's IP is not + already present in the ARP table: + 0 - don't create new entries in the ARP table + 1 - create new entries in the ARP table + + Both replies and requests type gratuitous arp will trigger the + ARP table to be updated, if this setting is on. + + If the ARP table already contains the IP address of the + gratuitous arp frame, the arp table will be updated regardless + if this setting is on or off. + app_solicit - INTEGER The maximum number of probes to send to the user space ARP daemon @@ -1074,10 +1126,10 @@ regen_max_retry - INTEGER Default: 5 max_addresses - INTEGER - Number of maximum addresses per interface. 0 disables limitation. - It is recommended not set too large value (or 0) because it would - be too easy way to crash kernel to allow to create too much of - autoconfigured addresses. + Maximum number of autoconfigured addresses per interface. Setting + to zero disables the limitation. It is not recommended to set this + value too large (or to zero) because it would be an easy way to + crash the kernel by allowing too many addresses to be created. Default: 16 disable_ipv6 - BOOLEAN |