diff options
Diffstat (limited to 'Documentation/networking/ip-sysctl.txt')
| -rw-r--r-- | Documentation/networking/ip-sysctl.txt | 36 |
1 files changed, 34 insertions, 2 deletions
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index fbe427a6580..006b39dec87 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -164,6 +164,14 @@ tcp_congestion_control - STRING additional choices may be available based on kernel configuration. Default is set as part of kernel configuration. +tcp_cookie_size - INTEGER + Default size of TCP Cookie Transactions (TCPCT) option, that may be + overridden on a per socket basis by the TCPCT socket option. + Values greater than the maximum (16) are interpreted as the maximum. + Values greater than zero and less than the minimum (8) are interpreted + as the minimum. Odd values are interpreted as the next even value. + Default: 0 (off). + tcp_dsack - BOOLEAN Allows TCP to send "duplicate" SACKs. @@ -723,6 +731,12 @@ accept_source_route - BOOLEAN default TRUE (router) FALSE (host) +accept_local - BOOLEAN + Accept packets with local source addresses. In combination with + suitable routing, this can be used to direct packets between two + local interfaces over the wire and have them accepted properly. + default FALSE + rp_filter - INTEGER 0 - No source validation. 1 - Strict mode as defined in RFC3704 Strict Reverse Path @@ -738,8 +752,8 @@ rp_filter - INTEGER to prevent IP spoofing from DDos attacks. If using asymmetric routing or other complicated routing, then loose mode is recommended. - conf/all/rp_filter must also be set to non-zero to do source validation - on the interface + The max value from conf/{all,interface}/rp_filter is used + when doing source validation on the {interface}. Default value is 0. Note that some distributions enable it in startup scripts. @@ -1086,6 +1100,24 @@ accept_dad - INTEGER 2: Enable DAD, and disable IPv6 operation if MAC-based duplicate link-local address has been found. +force_tllao - BOOLEAN + Enable sending the target link-layer address option even when + responding to a unicast neighbor solicitation. + Default: FALSE + + Quoting from RFC 2461, section 4.4, Target link-layer address: + + "The option MUST be included for multicast solicitations in order to + avoid infinite Neighbor Solicitation "recursion" when the peer node + does not have a cache entry to return a Neighbor Advertisements + message. When responding to unicast solicitations, the option can be + omitted since the sender of the solicitation has the correct link- + layer address; otherwise it would not have be able to send the unicast + solicitation in the first place. However, including the link-layer + address in this case adds little overhead and eliminates a potential + race condition where the sender deletes the cached link-layer address + prior to receiving a response to a previous solicitation." + icmp/*: ratelimit - INTEGER Limit the maximal rates for sending ICMPv6 packets. |