diff options
Diffstat (limited to 'Documentation/networking')
| -rw-r--r-- | Documentation/networking/ip-sysctl.txt | 170 |
1 files changed, 170 insertions, 0 deletions
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index 17f1f91af35..277437951e4 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -1060,6 +1060,176 @@ bridge-nf-filter-pppoe-tagged - BOOLEAN Default: 1 +proc/sys/net/sctp/* Variables: + +addip_enable - BOOLEAN + Enable or disable extension of Dynamic Address Reconfiguration + (ADD-IP) functionality specified in RFC5061. This extension provides + the ability to dynamically add and remove new addresses for the SCTP + associations. + + 1: Enable extension. + + 0: Disable extension. + + Default: 0 + +addip_noauth_enable - BOOLEAN + Dynamic Address Reconfiguration (ADD-IP) requires the use of + authentication to protect the operations of adding or removing new + addresses. This requirement is mandated so that unauthorized hosts + would not be able to hijack associations. However, older + implementations may not have implemented this requirement while + allowing the ADD-IP extension. For reasons of interoperability, + we provide this variable to control the enforcement of the + authentication requirement. + + 1: Allow ADD-IP extension to be used without authentication. This + should only be set in a closed environment for interoperability + with older implementations. + + 0: Enforce the authentication requirement + + Default: 0 + +auth_enable - BOOLEAN + Enable or disable Authenticated Chunks extension. This extension + provides the ability to send and receive authenticated chunks and is + required for secure operation of Dynamic Address Reconfiguration + (ADD-IP) extension. + + 1: Enable this extension. + 0: Disable this extension. + + Default: 0 + +prsctp_enable - BOOLEAN + Enable or disable the Partial Reliability extension (RFC3758) which + is used to notify peers that a given DATA should no longer be expected. + + 1: Enable extension + 0: Disable + + Default: 1 + +max_burst - INTEGER + The limit of the number of new packets that can be initially sent. It + controls how bursty the generated traffic can be. + + Default: 4 + +association_max_retrans - INTEGER + Set the maximum number for retransmissions that an association can + attempt deciding that the remote end is unreachable. If this value + is exceeded, the association is terminated. + + Default: 10 + +max_init_retransmits - INTEGER + The maximum number of retransmissions of INIT and COOKIE-ECHO chunks + that an association will attempt before declaring the destination + unreachable and terminating. + + Default: 8 + +path_max_retrans - INTEGER + The maximum number of retransmissions that will be attempted on a given + path. Once this threshold is exceeded, the path is considered + unreachable, and new traffic will use a different path when the + association is multihomed. + + Default: 5 + +rto_initial - INTEGER + The initial round trip timeout value in milliseconds that will be used + in calculating round trip times. This is the initial time interval + for retransmissions. + + Default: 3000 + +rto_max - INTEGER + The maximum value (in milliseconds) of the round trip timeout. This + is the largest time interval that can elapse between retransmissions. + + Default: 60000 + +rto_min - INTEGER + The minimum value (in milliseconds) of the round trip timeout. This + is the smallest time interval the can elapse between retransmissions. + + Default: 1000 + +hb_interval - INTEGER + The interval (in milliseconds) between HEARTBEAT chunks. These chunks + are sent at the specified interval on idle paths to probe the state of + a given path between 2 associations. + + Default: 30000 + +sack_timeout - INTEGER + The amount of time (in milliseconds) that the implementation will wait + to send a SACK. + + Default: 200 + +valid_cookie_life - INTEGER + The default lifetime of the SCTP cookie (in milliseconds). The cookie + is used during association establishment. + + Default: 60000 + +cookie_preserve_enable - BOOLEAN + Enable or disable the ability to extend the lifetime of the SCTP cookie + that is used during the establishment phase of SCTP association + + 1: Enable cookie lifetime extension. + 0: Disable + + Default: 1 + +rcvbuf_policy - INTEGER + Determines if the receive buffer is attributed to the socket or to + association. SCTP supports the capability to create multiple + associations on a single socket. When using this capability, it is + possible that a single stalled association that's buffering a lot + of data may block other associations from delivering their data by + consuming all of the receive buffer space. To work around this, + the rcvbuf_policy could be set to attribute the receiver buffer space + to each association instead of the socket. This prevents the described + blocking. + + 1: rcvbuf space is per association + 0: recbuf space is per socket + + Default: 0 + +sndbuf_policy - INTEGER + Similar to rcvbuf_policy above, this applies to send buffer space. + + 1: Send buffer is tracked per association + 0: Send buffer is tracked per socket. + + Default: 0 + +sctp_mem - vector of 3 INTEGERs: min, pressure, max + Number of pages allowed for queueing by all SCTP sockets. + + min: Below this number of pages SCTP is not bothered about its + memory appetite. When amount of memory allocated by SCTP exceeds + this number, SCTP starts to moderate memory usage. + + pressure: This value was introduced to follow format of tcp_mem. + + max: Number of pages allowed for queueing by all SCTP sockets. + + Default is calculated at boot time from amount of available memory. + +sctp_rmem - vector of 3 INTEGERs: min, default, max + See tcp_rmem for a description. + +sctp_wmem - vector of 3 INTEGERs: min, default, max + See tcp_wmem for a description. + UNDOCUMENTED: dev_weight FIXME |